Ventev TW-HCEN-FL-TBAR Handleiding

Ventev Niet gecategoriseerd TW-HCEN-FL-TBAR

Lees hieronder de 📖 handleiding in het Nederlandse voor Ventev TW-HCEN-FL-TBAR (3 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 17 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

www.ventevinfra.com sales@ventev.com 1-800-851-4965

Flush Mount Hard Cap Wi-Fi Enclosure

Assembly Instructions

Step 1 - Cut a hole into the ceiling as shown in Figure 1. It ers so the lid covers the hole. is important to chamfer the corn

Figure 2

Step 2 - Place the enclosure base into the hole and tighten the 4 screws that clamp the enclosure to the ceiling. Knock outs

are provided to run the RJ45 cable into the enclosure. Shown in Figure 2.

Figure 1

Figure 2

www.ventevinfra.com sales@ventev.com 1-800-851-4965

Flush Mount Hard Cap Wi-Fi Enclosure

Assembly Instructions

Step 3 - Remove the back plate from the enclosure base by removing 4 screws and install the AP to it.

Step 3A - To attach Cisco AP’s, use the key holes provided and place the locking spring pin in the key hole to prevent the AP

from sliding o as shown in Figure 3 and Figure 4. Connect the RJ45 cable to the AP.

Step 3B - To attach Aruba AP’s, insert the ing spring pin in the center hole to preAP feet into the cut outs and place the lock -

vent the AP from sliding o as shown in Figure 5. Connect the RJ45 cable to the AP.

Figure 3 - Cisco

Figure 5 -Aruba

Figure 4 - Cisco

Step 3C - If you are using the Solution that includes a T-Bar, Please follow your AP Manufacturer’s Instructions to attach the

AP T-Bar Mounting Solution to the T-Bar inside the enclosure as shown in Figure 6. Connect the RJ45 cable to the AP.

Figure 6 -T-Bar

www.ventevinfra.com sales@ventev.com 1-800-851-4965

Flush Mount Hard Cap Wi-Fi Enclosure

Assembly Instructions

Step 4 - Screw the back plate back into place to the stand os provided in the base as shown in Figure 7.

Figure 9 Figure 8

Figure 10

Step 6 - To access the AP, pull the cover down and press the spring pin in to remove the cover.

Step 5 - Align the 2 spring pins on the lid assembly into the slots in the enclosure base. Push the lid towards the assembly

keeping the lid level until the cover is tight against the ceiling shown in Figures 8, 9, and 10.

Figure 7

Product specificaties

Merk:	Ventev
Categorie:	Niet gecategoriseerd
Model:	TW-HCEN-FL-TBAR
Kleur van het product:	Wit
Gewicht:	2040 g
Aantal per verpakking:	1 stuk(s)
Type product:	WLAN-toegangspunt bevestiging