Velleman K6714-16 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Velleman K6714-16 (16 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 13 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
Total solder points: 351
Difficulty level: beginner 1 4 5 2 3 ⌧   advanced
Universal relay card
ILLUSTRATED ASSEMBLY MANUAL H6714(16)IP-1
K6714
K6714
If you want to switch large electric currents
using an electronic control and require control
isola
tion a t
t he same time, then this card is a
valuable asset.
K6714
K6714 -
-16
16
2
Features & specifications
Features :
 The relays can be controlled in different ways : direct control from open-
collector outputs, TTL or CMOS level or trough other kits (K6711, K8000,
K8023,…)
 Every output of the print can be equipped with a noise suppressor network.
 Output 12V CC can be used as a power supply for other kits: K6711,
K8023,...
Specifications
• Power supply:.................................................... 230 or 125VAC max. 12VA.
• Output voltage: ...........................................................................12V/250mA.
• Relay switch-over contact: .................................................max. 5A at 220V.
• PCB dimensions m (5.9" x 8.4") :..................................................150 x 212m
3
Assembly hints
1. Assembly (Skipping this can lead to troubles ! )
Ok, so we have your attent you to make this project ion. These hints will help
successful. Read them carefully.
1.1 Make sure you have the right tools:
• A good quality soldering iron (25-40W) with a
small tip.
• Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to
the tip, to give it a wet look. This is called ‘thinning’ and will protect
the tip, and enables you to make good connections. When solder
rolls off the tip, it needs cleaning.
• Thin raisin-core solder. Do not use any flux or grease.
• A diagonal cutter to trim excess wires. To avoid injury when cutting
excess leads, hold the lead so they cannot fly towards the eyes.
• Needle nose pliers, for bending leads, or to hold compo-
nents in place.
• Small blade and Phillips screwdrivers. A basic range
is fine.
For some projects, a basic multi-meter is required, or might
be handy
1.2 Assembly Hints :
⇒ Make sure the skill level matches your experience, to avoid disappointments.
⇒ Follow the instructions carefully. Read and understand the entire step before
you perform each operation.
⇒ Perform the assembly in the correct order as stated in this manual
⇒ Position all parts on the PCB (Printed Circuit Board) as shown on the draw-
ings.
⇒ Values on the circuit diagram are subject to changes.
⇒ Values in this assembly guide are correct*
0.000


Product specificaties

Merk: Velleman
Categorie: Niet gecategoriseerd
Model: K6714-16

Heb je hulp nodig?

Als je hulp nodig hebt met Velleman K6714-16 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Velleman

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd