US Blaster USB 7015 Handleiding
US Blaster
DJ Party Music
USB 7015
Lees hieronder de 📖 handleiding in het Nederlandse voor US Blaster USB 7015 (49 pagina's) in de categorie DJ Party Music. Deze handleiding was nuttig voor 59 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/49
DESIGN BY U.S BLASTER - P.O. Box 5376 - Carefree - AZ 85377-USA.
OWNERS MANUAL
CONSOLE MIXER
USB 7015
DESIGN BY U.S BLASTER - P.O. Box 5376 - Carefree - AZ 85377-USA.
USB 7015
Console mixer
GENERAL SAFETY INSTRUCTIONS
- Always read the user guide before using the equipment.
- Keep the user guide in a place where everyone can read it.
- Use the equipment indoors and not in humid environments.
- Never remove or insert a plug from or into a wall socket with wet hands.
- If the plug and/or cable and/or cable input of the equipment is damaged it must be repaired by
aprofessional.
- Always take the plug out of the wall socket in the event of a thunderstorm, and also when the
equipment is not being used for a while.
-Never remove the plug from the power socket by pulling on its cable.
- Install the equipment in such a way that sufficient cooling is possible.
- Never use the appliance in the vicinity of heat sources and/or in direct sunlight.
-Make sure that no small objects or liquids can get in to the appliance.
-Only clean the appliance with a slightly moist dust-free cloth. Do not use cleaning products or
solutions!
-The appliance contains no components, other than those mentioned in the user guide that can
be repaired or replaced by the user.
- If the appliance is defective, it must be repaired by a US Blaster qualified repairs company.
- Keep the equipment out of the reach of children.
Keep the packaging safe so that, if the equipment is defective, you can
send it back in its original packaging and so avoid any damage.
©US Blaster Europe BV
Do not carry out any repairs on the equipment yourself; doing so will invalidate the guarantee.
The equipment may also not be modified; doing so will also invalidate the guarantee.
The guarantee is also invalidated if accidents and damage of any form are caused as a result
of improper use and/or not heeding the warnings in general as laid out in this user guide.
US Blaster Europe accepts no responsibility for any personal accidents as a consequence of not
following the safety instructions and warnings. This is also the case for consequential loss in
any form.
DESIGN BY U.S BLASTER - P.O. Box 5376 - Carefree - AZ 85377-USA.
USB 7015
Console mixer
INPUT CHANNEL SECTION
1. BALANCE INPUT
Electronially Balanced inputs acceptable a standard XLR male connector.
+48V Phantom Power available on each input Mic socket. And this switch is
on Rear Phantom Power.
2. LINE INPUT
The unbalanced Mic input is provided for the use of a unbalanced mic and
is designed to accept a unbalanced high impedance input signal. (This use
for connection Deck,Turntable,Keyboard etc,.)
3. GAIN CONTROL
Adjusts input sensitivity from -60dB to -20dB with the -20dB pad switch in
the out position, and -40dB to OdB when the -20dB pad switch is pushed.
4. HIGH
Control the high frequency tone of each channel. Always set this control to
the 12 O'clock position. You can control the high frequency tone according
to the speaker, the conditions of listening position and listener's taste,
Clockwise rotation of the control increases level.
5. MID
This has a function which controls the middle frequency tone of each chan-
nel. Always set this control to the 12 o'clock position. You can control the
middle frequency tone according to the speaker, the conditions of listening
position and listener's taste. Clockwise rotation of the control incrases the
level, and vice versa.
6. LOW
Controls the low frequency tone of each channel. Always set this control to
the 12 o'clock position. You can control the middle frequency tone accor-
ding to the speaker, the conditions of listening position and listerner's state.
Clockwise rotation of the control increases the level.
7. SEND
Use this contol to set the level of signal from external stereo souce and the
main signal control is recontrolled by the STEREO or MONO section.
8.EFF
Use this control when you want to get sound effects by adjustment of the
input signal. when you don't use external sound, digital delay will be wor-
king which is installed inside.
©US Blaster Europe BV
Product specificaties
Merk: | US Blaster |
Categorie: | DJ Party Music |
Model: | USB 7015 |
Heb je hulp nodig?
Als je hulp nodig hebt met US Blaster USB 7015 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding DJ Party Music US Blaster
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
22 Maart 2023
Handleiding DJ Party Music
- DJ Party Music Pioneer
- DJ Party Music Atomix
- DJ Party Music Envivo
- DJ Party Music Gemini
- DJ Party Music Hercules
- DJ Party Music Ion
- DJ Party Music Koden
- DJ Party Music Native
- DJ Party Music Numark
- DJ Party Music Serato
- DJ Party Music Skytec
- DJ Party Music Vonyx
Nieuwste handleidingen voor DJ Party Music
24 September 2023
25 Augustus 2023
25 Augustus 2023
15 Augustus 2023
15 Augustus 2023
15 Augustus 2023
15 Augustus 2023
15 Augustus 2023
14 November 2022
15 Augustus 2023