Trust 302KS FR Handleiding

Trust Toetsenbord 302KS FR

Lees hieronder de 📖 handleiding in het Nederlandse voor Trust 302KS FR (8 pagina's) in de categorie Toetsenbord. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

302KS SILVERLINE WIRELESS DESKSET

U K

Method when using for the first time Chapter

1. Uninstalling old drivers and devices (3.1)

2. Connecting/making a wireless connection (3.2)

3. Installing in Windows (3.3)

4. Checking after the installation (3.4)

1 Introduction

This instruction manual is for users of the TRUST 302KS SILVERLINE WIRELESS

DESKSET. The TRUST 302KS SILVERLINE WIRELESS DESKSET has 19

multimedia buttons. The set is wireless and works at a frequency of 27 MHz. It has

two channels, each with 256 different ID codes.

2 Safety

Carefully read the following instructions before use:

- The TRUST 302KS SILVERLINE WIRELESS DESKSET does not require

any special maintenance. Use a slightly damp, soft cloth to clean the set.

- Do not use aggressive substances, such as petrol or white spirit, to clean the

device. These may harm the material.

- Do not submerge the device in liquid. This may be dangerous and will

damage the device. Do not use this device near water.

- Make sure nothing is placed on the cable. Do not use this device in an area

where the cable can become worn or damaged as a result of people walking

over it.

- Do not repair this device yourself.

- This product works at a frequency of 27.0450- 27.0950MHz.

There may be local restrictions with regard to the use of this device. You are

personally responsible for ensuring that the use of this product is permitted

according to local regulations. If in doubt, contact your local authorities about

0470

- Nowadays, there are an increasing number of wireless products (video,

audio, convenience, computer, etc.) which work in the same frequency range

as this device. It may, therefore, be possible that the functionality of this

product can be limited by or be limiting for other wireless products. This can

only be avoided by paying attention to the distance between products and,

where possible, by changing channels.

- Be careful when using wireless devices if you have a pacemaker or are

dependent on other life-saving, sensitive electronic equipment. This product

transmits radio signals!

3 Installation

3.1 Uninstalling old drivers and devices

The most common cause of faults during installation is the presence of a driver for a

similar, old product. The best solution is to first remove all drivers related to old

devices before installing the new driver.

1. Enter the Windows ‘Safe Mode’ (press F8 when starting Windows and then

select ‘Safe Mode’ from the menu which is displayed).

2. Go to ‘Start – Settings – Control Panel’ and double-click on the ‘Add/Remove

Programs’ icon.

3. Find all the programs for similar, old devices and remove these by clicking on

the ‘Add/Remove’ button. When in the ‘Safe Mode’, it is possible for some

programs to appear twice. In that case, remove all the programs which

appear twice.

4. Restart the computer.

302KS SILVERLINE WIRELESS DESKSET

3.2 Connecting

1. Make sure that all products are not more than 1meter apart and that there are

no objects (or a total metal surface) in between since this will reduce the

functionality of the connection.

2. Open the cover of the battery compartment on the bottom of the mouse.

3. Set the channel selection switch (H) to the desired channel using a pointed

object. You can see which channel you select inside the compartment (CH1

or CH2) (see figure 1).

4. Insert 2 batteries into the mouse as indicated inside the battery compartment.

5. Close the mouse battery compartment.

6. Open the keyboard battery compartment.

7. Insert 3 batteries into the battery compartment as indicated inside the battery

compartment.

8. Close the keyboard battery compartment.

9. Open the keyboard’s right-hand bottom stand (see figure 2).

10. Set the channel selection switch (H) to the desired channel using a pointed

object (see figure 2). You can see which channel you select next to the

channel selection switch (CH1 or CH2).

11. Make sure the computer is turned off.

12. Connect the green plug of the set’s receiver to the PS/2 mouse connection

on your computer.

13. Connect the receiver’s purple plug to the PS/2 keyboard connection on your

computer.

14. Turn the computer on.

15. The receiver will be automatically detected and installed as a standard PS/2

mouse and keyboard.

Note: The keyboard and mouse will not work after they have been connected.

A wireless connection must first be made between the keyboard, the

mouse and the receiver before the set can be used. Continue from

chapter 3.3.

Note: Do not recharge the batteries. These are NOT rechargeable.

Note: Inserting the batteries incorrectly may damage the device.

3.3 Making a wireless connection

1. Make sure your computer is turned on.

2. Make sure that all products are not more than 1meter apart and that there are

no objects (or a total metal surface) in between since this will reduce the

functionality of the connection.

3. Make sure that the batteries are placed and are full enough.

4. The receiver has two different coloured indicators. The red indicator is for the

keyboard and the green indicator is for the mouse. These two indicators are

located in a single lamp (J) on top of the receiver (see figure 1).

5. Press the ID button (I) on top of the receiver (see figure 1). The indicators will

flash simultaneously.

6. Open the keyboard’s right-hand bottom stand. Use a pointed object to press

the round ID button (V) (see figure 2). The red indicator on the receiver will

stop flashing to indicate that the keyboard has made a connection with the

receiver.

7. Press the round ID button on the bottom of the mouse (see figure 1). The

green indicator will also stop flashing. The indicator will remain constantly lit

as an orange colour (combination of red and green).

8. The keyboard and mouse have now made a connection with the receiver.

302KS SILVERLINE WIRELESS DESKSET

U K

The keyboard and mouse andard keyboard and mouse.will now work as a st

Continue with the installation of the software if you wish to use the extra

functions.

Note: When one of the indicators does not light up, this indicates that the

mouse or keyboard is not connected or has not been connected

correctly.

3.4 Installation in Windows 98 / ME / 2000 / XP

Note: The latest driver can be downloaded from www.trust.com/13165. Check

whether a new driver is available and use this for the installation.

Note: Make sure all other programs are closed during the installation.

Note: During installation in Windows XP, you may receive a message saying

that the driver has not been signed. This does not cause a problem for

the functionality. Click ok to continue.

Note: In the example, ‘D:\’ is used to indicate the CD-ROM drive. This may be

different for your computer.

1. Insert the CD-ROM into your computer’s CD-ROM drive. The installation

program will start automatically. If it does not start automatically, carry out

the following:

a) Select 'Run' from the Start menu.

b) Type [D:\SETUP.EXE] and click on 'OK' to start the Trust Software

Installer.

2. Figure 3 will appear.

3. Click on the language you wish to use for the installation.

4. Click on ‘302KS Keyboard‘ to start the installation of the keyboard.

5. Follow the on-screen instructions.

6. Click on ‘302KS Mouse‘ to start the installation of the mouse.

7. Follow the on-screen instructions.

The installation of the software for the mouse and the keyboard has now been

completed.

4 Checking after the installation

After installing the device and the driver, the following are installed on your computer

and can be checked:

Taskbar

– The icons as shown in figure 4 should be visible in the right-hand corner of your

taskbar.

‘Start – Settings – Control Panel’. Double-click on the ‘System’ icon and select the

‘Device Manager’ tab.

- Keyboard – Standard 101/102 Key or Microsoft Natural Keyboard

- Mouse – WHEEL MOUSE PS/2

‘Start – Settings – Control Panel’ and then double-click on the ‘Add/Remove

Programs’ icon.

- Trust keyboard utility

- Uninstall Trust keyboard utility

Start - Programs - Trust - 302KS SILVERLINE WIRELESS DESKSET

- Trust mouse utility

- Uninstall Trust mouse utility

Note: The information given in this chapter will vary when the installation has

been altered by the user (for example, not everything has been installed

or locations other than the default locations have been selected).

Product specificaties

Merk:	Trust
Categorie:	Toetsenbord
Model:	302KS FR
Kleur van het product:	Zwart
LED-indicatoren:	Ja
Connectiviteitstechnologie:	Draadloos
Materiaal:	Kunststof
Aantal knoppen:	5
Intern:	Nee
Aansluiting:	RF Draadloos
Compatibele besturingssystemen:	Windows 98+
Inclusief muis:	Ja
Minimale systeemeisen:	CD-ROM
Minimale opslag schijfruimte:	8 MB
Minimale processor:	Pentium
Toetsenbordindeling:	QWERTY
Minimale RAM:	16 MB
Scroll:	Ja