TP Link Tapo T310 Handleiding

TP Link Luchtbevochtiger Tapo T310

Lees hieronder de 📖 handleiding in het Nederlandse voor TP Link Tapo T310 (4 pagina's) in de categorie Luchtbevochtiger. Deze handleiding was nuttig voor 47 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

Meet Your Temperature and Humidity Sensor

Measure the temperature and humidity of the environment and send you instant

notications when the environment changes. It is suitable for green houses, bedrooms,

nursery, incubators, and wine cellars.

Quick Start Guide

Smart Temperature and

Humidity Sensor

7106509722 REV1.0.0

*Images may dier from actual products.

Open the Tapo app and tap the button.

Select and then your model. Sensors

Follow the app instructions to complete

setup.

2. Set Up Your SensorBefore You Start

A Tapo Hub is required. Make sure your

Tapo Hub is successfully added via the

Tapo app.

Remove the battery insulation tab to power

up your sensor. The LED should blink.

Note: If the LED is not blinking, use a pin to press the Reset

button for 5 seconds to reset your sensor and enter pairing

mode.

1. Power Up Your Sensor1

Take your sensor to the preferred location.

Option 1

Single press the Reset button. Your hub

should make a voice prompt.

3. Test Your Sensor3

Option 2

Blow on the sensor detector. The

temperature and humidity displayed on

the Tapo app should change.

Reset

Sensor

Detector

LED

Battery Pinhole

Use a pin to press and

remove the cover

Reset Button

Single press: Eective range test

Press for 5s: Reset and enter

pairing mode

CR2450

4. Place Your Sensor44. How to replace the battery?

Option 1: Hang with the Lanyard

a. Stick the included adhesive magnets to

the back panel.

b. Magnetically attach the sensor to metallic

surfaces.

b. Stick the sensor to your preferred location.

Option 2: Use Adhesive Magnets

a. Stick the included 3M adhesives to the

back panel.

Option 3: Use 3M Adhesives

Metallic Surface

Need some help?

Visit www.tapo.com/support/

for technical support, user guides,

FAQs, warranty & more

Do not ingest battery, Chemical Burn Hazard

Avoid replacement of a battery with an incorrect type that can defeat a

safeguard.

Avoid disposal of a battery into re or a hot oven, or mechanically crushing

or cutting of a battery, that can result in an explosion.

Do not leave a battery in an extremely high temperature surrounding

environment that can result in an explosion or the leakage of ammable

liquid or gas; Do not leave a battery subjected to extremely low air

pressure that may result in an explosion or the leakage of ammable liquid

or gas.

Safety Information

Keep the device away from water, re, humidity or hot environments.

Do not attempt to disassemble, repair, or modify the device. If you need

service, please contact us.

Do not use the device where wireless devices are not allowed.

Please read and follow the above safety information when operating the

device. We cannot guarantee that no accidents or damage will occur due

to improper use of the device. Please use this product with care and

operate at your own risk.

TP-Link hereby declares that the device is in compliance with the essential

requirements and other relevant provisions of directives 2014/53/EU,

2009/125/EC, 2011/65/EU and (EU) 2015/863.

The original EU declaration of conformity may be found at

https://www.tapo.com/en/support/ce/

TP-Link hereby declares that the device is in compliance with the essential

requirements and other relevant provisions of the Radio Equipment

Regulations 2017.

The original UK declaration of conformity may be found at

https://www.tapo.com/support/ukca/

For EU/UK Region:

Operating Frequency / Nominal Operating Frequency / Max Output Power:

863~865MHz / 863.35MHz / 25mW (e.r.p)

863~865MHz / 864.35MHz / 25mW (e.r.p)

1. Use a pin to press and remove the cover.

2. Replace the battery with a fresh cell.

3. Put the cover back.

CR2450

(The installation height should not be higher than 2 meters.)

This product contains a coin / button cell battery. If the coin / button

cell battery is swallowed, it can cause severe internal burns in just 2

hours and can lead to death.

Keep new and used batteries away from children.

If the battery compartment does not close securely, stop using the

product and keep it away from children.

If you think batteries might have been swallowed or placed inside

any part of the body, seek immediate medical attention.

Warning

Risk of explosion if the battery is replaced by an incorrect type.

Warning

Product specificaties

Merk:	TP Link
Categorie:	Luchtbevochtiger
Model:	Tapo T310
Breedte:	46 mm
Diepte:	12.3 mm
Hoogte:	46 mm
Soort:	Vrijstaand
Connectiviteitstechnologie:	Draadloos
Meeteenheid temperatuur:	F, °C
Nauwkeurigheid:	3 procent
Ondersteund aantal accu's/batterijen:	1
Certificering:	FCC, CE, R-NZ, UKCA, JRF, VCCI, \nNCC, RCM
Type beeldsensor:	Temperatuur- & vochtigheidssensor
Bedoeld voor:	Binnen
Duurzaamheidscertificaten:	RoHS
Naleving van duurzaamheid:	Ja
Meetbereik temperatuur:	-20 - 60 °C
Bedrijfstemperatuur (T-T):	-20 - 60 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 99 procent
Type batterij:	CR2450
Meetbereik vochtigheid:	0 - 99 procent
Acculevensduur (max):	2 jaar
RF-zendfrequentie:	868 MHz
Controle-interval:	2 s