Toshiba tdp tw420 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Toshiba tdp tw420 (55 pagina's) in de categorie Beamer projector. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/55
Before UsingPreparationsOperationsMaintenanceOthers
Network and
USB memory
TDP-TW420
DATA PROJECTOR
OWNER’S MANUAL
In the spaces provided below, record the Model and Serial No. located at the bottom of
your projector.
Model No. Serial No.
Retain this information for future reference.
2
3
Before Using
SAFETY PRECAUTIONS
The lightning flash with arrowhead symbol, within an equilateral triangle, is
intended to alert the user to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES
ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
WARNING:
USA only
Handling the cord on this product or cords associated with accessories sold with
this product, will expose you to lead, a chemical known to the State of California
to cause birth defects or other reproductive harm. Wash hands after handling.
USA only
Lamp contains mercury. Disposal of this product may be regulated due to
environmental considerations. For disposal, reuse or recycling information,
please contact your local government or the Electronic Industries Alliance at
www.eiae.org.
MODEL NAME: TDP-TW420 USA only
TRADE NAME: DATA PROJECTOR MODEL NAME: TDP-TW420
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RESPONSIBLE PARTY: TOSHIBA AMERICA INFORMATION SYSTEMS, INC.
9740 Irvine Blvd., Irvine, CA 92618-1697 U.S.A
Phone: (949) 583-3000
CAUTION:
USA only
Changes or modifications made to this equipment, not expressly approved by
Toshiba, or parties authorized by Toshiba, could void the user’s authority to
operate the equipment.
Notice:
CANADA only
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada.
Before Using
4
5
Before Using
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND
INSTRUCTIONS GIVEN IN THIS OWNER'S MANUAL AND THOSE
MARKED ON THE UNIT. RETAIN THIS BOOKLET FOR FUTURE
REFERENCE.
This unit is fully transistorized and does not contain any parts that can be repaired by the
user.
WARNING: DO NOT REMOVE THE CABINET COVER, OR YOU MAY BE
EXPOSED TO DANGEROUS VOLTAGE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL ONLY.
1. Read Owner’s Manual
After unpacking this product, read
the owner's manual carefully, and
follow all the operating and other
instructions.
2. Power Sources
This product should be operated
only from the type of power source
which does not exceed the voltage
range specified on the rating label
and the power cord.
If you are not sure of the type
of power supply to your home,
consult your product dealer or local
power company.
3. Source of Light
Do not look into the lens while the
lamp is on. The strong light from
the lamp may cause damage to
your eyesight.
4. Ventilation
Openings in the cabinet are
provided for ventilation and to
ensure reliable operation of the
product and to protect it from
overheating. These openings must
not be blocked or covered. Never
block an opening by placing the
product on a bed, sofa, rug or
other similar surface. Do not place
it in a built-in installation such as
a bookcase or rack, unless proper
ventilation is provided.
5. Heat
The product should be situated
away from heat sources such as
radiators, heat registers, stoves,
or other products (including
amplifiers) that produce heat.
6. Water and Moisture
Do not use this product near water.
- for example, near a bath tub,
wash bowl, kitchen sink, or laundry
tub; in a wet basement; or near a
swimming pool and the like.
7. Cleaning
Unplug this product from the wall
outlet before cleaning. Do not use
liquid cleaners or aerosol cleaners.
Always use a soft cloth for
cleaning.
8. Be sure that you firmly
insert the plug into the wall
outlet.
Incorrect or faulty connections
may result in fire or electric shock.
Avoid using an unsound or loose
outlet.
9. Power Cord Protection
Power cords should be routed
so that they are not likely to be
walked on or pinched by items
placed upon or against them,
paying particular attention to cords
at plugs, convenience receptacles,
and the point where they exit from
the product.
10. Overloading
Do not overload wall outlets. To
reduce the risk of electric shock,
do not use the polarized plug with
an extension cord , receptacle, or
other outlet unless the blades can
be inserted completely with three-
wire grounding type to prevent
blade exposure. Failure to follow
these instructions may result in fire
or electric shock.


Product specificaties

Merk: Toshiba
Categorie: Beamer projector
Model: tdp tw420
Gewicht: 4200 g
Geluidsniveau: 33 dB
Stroomvoorziening: AC 100 - 240 V, 50/60 Hz
Beeldschermdiagonaal: 0.7 "
Typische contrastverhouding: 2000:1
Projector helderheid: 4000 ANSI lumens
Projectietechnologie: DLP
Projector native resolution: XGA (1024x768)
Keystone correctie, verticaal: 40 °
Keystone correctie, horizontaal: 40 °
Aantal kleuren: 16.78 miljoen kleuren
Frequentiebereik horizontaal: 15 - 120 kHz
Frequentiebereik verticaal: 50 - 150 Hz
Aantal USB 2.0-poorten: 1
VGA (D-Sub)poort(en): 1
Audio-ingang (L, R): 1
Composiet video-ingang: 1
Componentingang video (YPbPr/YCbCr): 1
S-Video ingang: 1
DVI-poort: Ja
Aantal Ethernet LAN (RJ-45)-poorten: 1
Focus: Handmatig
Levensduur van de lichtbron: 2000 uur
Type lichtbron: Lamp
Aantal ingebouwde luidsprekers: 1
Hoofdtelefoonuitgangen: 1
Interface: RS-232C
Lampvermogen: 275 W
Beeldverhouding: 4:3,16:9
Levensduur van de lichtbron (besparingsmodus): 3000 uur
Video-ingang: NTSC / PAL / SECAM
Afmetingen (B x D x H): 338 x 280 x 128 mm

Heb je hulp nodig?

Als je hulp nodig hebt met Toshiba tdp tw420 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Beamer projector Toshiba

Handleiding Beamer projector

Nieuwste handleidingen voor Beamer projector

Sanyo

Sanyo PLC EF10E Handleiding

28 September 2024
Sanyo

Sanyo plc xu74 Handleiding

22 September 2023
Nec

Nec GT 5000 Handleiding

31 Augustus 2023
Optoma

Optoma dx 609 Handleiding

27 Augustus 2023
Nec

Nec MT1045E Handleiding

31 Augustus 2023
Optoma

Optoma ep 761 Handleiding

27 Augustus 2023
Nec

Nec np 4001 Handleiding

31 Augustus 2023
Nec

Nec mt 860 Handleiding

31 Augustus 2023
Nec

Nec LT156 Handleiding

31 Augustus 2023