Toa FB-120W Handleiding

Toa Subwoofer FB-120W

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Toa FB-120W (4 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Thank you for purchasing TOA's Subwoofer System.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
FB-120B
FB-120W
SUBWOOFER SYSTEM
OPERATING INSTRUCTIONS
1. SAFETY PRECAUTIONS
β€’ Before installation or use, be sure to carefully read all the instructions in this section for correct and safe operation.
β€’ Be sure to follow all the precautionary instructions in this section, which contain important warnings and/or cautions
regarding safety.
β€’ After reading, keep this manual handy for future reference.
β€’ Refer all installation work to the dealer from whom the
speaker was purchased. Installation for flying requires
extensive technical knowledge and experience. The
speaker may fall off if incorrectly installed, resulting in
possible personal injury.
β€’ Flying Precautions
Be sure to follow the instructions below. Otherwise, the
suspension wires or belts may be off or snap and the
speaker may fall off, causing personal injury.
β€’ Check to confirm that the suspension wires and belts are
strong enough to withstand the speaker load.
β€’ The connectors of the suspension wires and belts must
be securely linked with those of the speaker.
β€’ All parts and components (such as enclosures, metal
pieces, and screws) must be free from any deformation,
crack, and corrosion.
β€’
Be sure to use screws supplied with the optional flying
hardware when installing the speaker using such hardware.
β€’ Install the unit only in a location that can structurally
support the weight of the unit and the mounting bracket.
Doing otherwise may result in the unit falling down and
causing personal injury and/or property damage.
β€’ Since the unit is designed for in-door use, do not install it
outdoors. If installed outdoors, the aging of parts causes
the unit to fall off, resulting in personal injury.
β€’ Owing to the unit's size and weight, be sure that at least
two persons are available to install the unit. Failure to do
so could result in personal injury.
β€’ Do not use other methods than specified to install the
unit. Extreme force is applied to the unit and the unit
could fall off, possibly resulting in personal injuries.
β€’ Use nuts and bolts that are appropriate for the ceiling's
structure and composition. Failure to do so may cause
the speaker to fall, resulting in material damage and
possible personal injury.
β€’ Tighten each nut and bolt securely. Ensure that the
bracket has no loose joints after installation to prevent
accidents that could result in personal injury.
β€’ Do not mount the unit in locations exposed to constant
vibration. The mounting bracket can be damaged by
excessive vibration, potentially causing the unit to fall,
which could result in personal injury.
β€’ Avoid touching the unit's sharp metal edge to prevent
injury.
β€’ To avoid electric shocks, be sure to switch off the
amplifier's power when connecting speakers.
β€’ Do not place heavy objects on the unit as this may cause
it to fall or break which may result in personal injury
and/or property damage. In addition, the object itself may
fall off and cause injury and/or damage.
β€’ Do not operate the unit for an extended period of time
with the sound distorting. This is an indication of a
malfunction, which in turn can cause heat to generate
and result in a fire.
β€’ Do not stand or sit on, nor hang down from the unit as
this may cause it to fall down or drop, resulting in
personal injury and/or property damage.
β€’ Have the unit checked periodically by the shop from
where it was purchased. Failure to do so may result in
corrosion or damage to the unit or its mounting bracket
that could cause the unit to fall, possibly causing
personal injury.
Indicates a potentially hazardous situation which, if mishandled, could result
in death or serious personal injury.
Indicates a potentially hazardous situation which, if mishandled, could result
in moderate or minor personal injury, and/or property damage.
WARNING
CAUTION
CAUTION
WARNING
5. INPUT CONNECTORS
β€’ The NEUTRIK Speakon connectors are internally connected in parallel to the screw terminals; you can use either one.
β€’ The right table shows the pin arrangement of the Speakon NL4MP connector.
β€’ The usable connector (on the cable end) for the Speakon NL4MP IS Speakon NL4FC.
β€’ Wiring diagram of the input connectors is shown at right.
Pin No. FB-120B, FB-120W
1 + Speaker +
1 – Speaker –
2 +
–
2 –
–
Screw terminal 2P
Speakon NL4MP x 2
1+
2+
1–
2–
1+
2+
1–
2–
Speaker +
Speaker –
+–
2. GENERAL DESCRIPTION
TOA's FB-120B/W is a compact, indoor-use subwoofer system employing a high-power 30 cm (12") woofer.
It is designed for use in conjunction with TOA's HX-5 series or other full range speakers, and is particularly ideal for
reproducing dynamic low-frequency sound for both permanent and temporary installations.
3. FEATURES
β€’Equipped with a convenient carrying handle.
β€’Suspended by wire or chain.
4. DIMENSIONAL DIAGRAM
* When suspending the speaker, remove the 4 screws on
both sides and install eyebolts instead.
(refer to "6.2. Suspended Installation.")
[Front] [Side]
[Rear]
408 (16 )1/16 310 (12 13/64)
4-M8*
450 (17 23/32)
70 (2 3/4)
70 (2 )3/4
408 (16 1/16)
Unit: mm (inches)
Input connectors
4 space: +0 dBΟ€
(Free sound field)
2 space: +6 dBΟ€
(Semi-free sound field)
Ο€ space: +12 dB
(1/4 free sound field)
Ο€/2 space: +18 dB
(1/8 free sound field)
6. INSTALLATION
6.1. Installation Location and Acoustic Energy
Acoustic energy emitted from the speaker differs depending on installation locations.
The figures below show that the acoustic energy increases in other installation locations, referenced to the free sound field
(ceiling suspension).
6.2. Suspended Installation
Remove the 4 screws on both sides of the subwoofer system, screw 30 50 mm (1 1 ") M8 eyebolts into the–3/16" –31/32
exposed holes, and use these to suspend the subwoofer using wire or chain.
Note
Eyebolts, nuts, and washers are not supplied and should be acquired separately.
Be sure to select wire, chain, and/or anchor shackles with a safety factor
appropriate to the weight of the speaker system. Incorrect selection of these
suspension components may cause the speaker system to fall, potentially
resulting in damage and/or personal injury.
WARNING
Use the optional HY-PF1B or HY-PF1W Speaker Rigging Frame to suspend the FB-120 subwoofer together in the same
location with TOA HX-5 series speakers.
For suspension, refer to the instruction manual attached to the HY-PF1B or HY-PF1W.
Remove the 4 preinstalled
screws on both sides.
M8 eyebolt
(30 50 mm or 1 –3/16 31/32" – 1 " long)
β€’Two speaker systems can be operated in parallel by connecting them in a
cascade configuration as shown at right.
Note
Be sure to connect the speaker system to the power amplifier's output
terminal of 4 Ωor less.
Connecting it to an output terminal of over 4 may cause amplifier failure.Ω
First speaker Second speaker


Product specificaties

Merk: Toa
Categorie: Subwoofer
Model: FB-120W
Kleur van het product: Wit
Materiaal: Plywood, Steel
Gemiddeld vermogen subwoofer: 200 W
Diameter driver subwoofer (imperiaal): 12 "
Frequentiebereik subwoofer: 40 - 1200 Hz
Breedte van de subwoofer: 408 mm
Hoogte van de subwoofer: 408 mm
Diepte van de subwoofer: 450 mm
Gewicht subwoofer: 15000 g
Draadloze subwoofer: Nee
Subwoofer sensitiviteit: 90 dB
Aantal subwoofers: 1
Diameter driver subwoofer: 30 mm
Subwoofer maximale vermogen: 600 W

Heb je hulp nodig?

Als je hulp nodig hebt met Toa FB-120W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Subwoofer Toa

Handleiding Subwoofer

Nieuwste handleidingen voor Subwoofer