Thinkware F800 Pro Handleiding

Thinkware Dashcam F800 Pro

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Thinkware F800 Pro (44 pagina's) in de categorie Dashcam. Deze handleiding was nuttig voor 105 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/44
This product records videos while the vehicle is operating.
Read and follow the instructions in this guide to properly use and maintain the product.
User Guide
Before using the product
About the product
This product records videos while the vehicle is operating. Use this product only for reference when investigating
incidents or road accidents. This product is not guaranteed to record ALL events. The device may not properly record
accidents with small impacts that are too minor to activate the impact sensor or accidents with massive impacts that
cause the vehicle’s battery voltage to deviate.
Video recording does not begin until the product is completely turned on (booted up). To ensure that all vehicle
events are recorded, wait until the product is completely booted up after turning it on, and then begin operating the
vehicle.
THINKWARE is not responsible for any loss caused by an accident, nor is it responsible for providing any support
regarding the outcome of an accident.
Depending on the vehicle's configuration or operating conditions, such as the installation of remote door lock devices,
ECU settings, or TPMS settings, some product features may not be supported, and different firmware versions may
the product's performance or features.
About the user guide
The information provided in the guide may change when the manufacturer updates its service policy.
This user guide is intended for THINKWARE F800 PRO models only, and it may contain technical errors, editorial
errors, or missing information.
Copyrights
All rights for the content and maps in this guide are reserved by THINKWARE and are protected under copyright
laws. All unauthorized duplication, revision, publication, or distribution of this guide without written consent from
THINKWARE is prohibited and is eligible for criminal charges.
Registered trademarks
THINKWARE F800 PRO is a registered trademark of THINKWARE.
Other product logos and service names in this guide are trademarks of the relevant companies.
Disclaimer regarding device operation outside of the U.S. and its territories
This THINKWARE dash cam has been pre-loaded with a firmware and GPS data that are specific for use within the
United States and its territories. As such, THINKWARE does not recommend the use and operation of this dash cam,
along with all of its features, outside of the United States and its territories. Doing so might result in the device not
functioning properly and will void any warranties associated with this THINKWARE dash cam.
Industry Canada Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20 cm between the radiator & your body.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
β€’ξ˜ƒ Reorient or relocate the receiving antenna.
β€’ξ˜ƒ Increase the separation between the equipment and receiver.
β€’ξ˜ƒ Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
β€’ξ˜ƒ Consult the dealer or an experienced radio/TV technician for help.
β€’ξ˜ƒ This appliance and its antenna must not be co-located or operation in conjunction with any other
antenna or transmitter.
β€’ξ˜ƒ A minimum separation distance of 20cm must be maintained between the antenna and the person
for this appliance to satisfy the RF exposure requirements.
FCC CAUTION: Any changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC ID: 2ADTG-F800
Information to user : RSS-247
This device complies with Industry Canada’s licence-exempt RSSs.
Please be cautioned the changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Notice: Operation is subject to the following two conditions : (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
IC: 12594A-F800


Product specificaties

Merk: Thinkware
Categorie: Dashcam
Model: F800 Pro

Heb je hulp nodig?

Als je hulp nodig hebt met Thinkware F800 Pro stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Dashcam Thinkware

Handleiding Dashcam

Nieuwste handleidingen voor Dashcam