Thermex Black Sun II Handleiding

Thermex Heater Black Sun II

Lees hieronder de 📖 handleiding in het Nederlandse voor Thermex Black Sun II (3 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
INFRARED CERAMIC HEATER
Safety Instructions
and Operation Manual
THERMEX BLACK SUN II
1
Introduction
Your heater your infrared is heating i the n way o radiationf (no need for medium) so infrared
heater heater is effective. t A the , the sam timee has very good physiotherapy effect b ecaus ite
doesn' nee t hea thet d o t ambient air. I t i goods to be used in th opene air a well.s
Importan Safett y Instructions
When using electrica appliances, basicl safety precautions should always b followede t reduceo the
risk electri shock o injur t persons etc. of fire, c , r y o ,
Read through and the operation assembly instructions conscientiously before operating the
appliance.
Be sure safe future the to keep th manuale i an plac fore reference. If you pass appliance on, pass
on the instructions too.
Check if the voltage indicated on the nameplate of the appliance corresponds to the local
mains voltage before you connect the appliance.
The power supply to the appliance should correspond to the relevant regulations of the power
supply companies and the regional construction regulations. Extension cords and multisockets
may be used only if care is exercised in their use. The marked electrical rating of the extension
cord or multisocket should have adequate current carrying capacity and correspond to the
relevant regulations of the power supply companies and the regional construction regulations.
Check if the voltage indicated on the appliance corresponds to the marked electrical rating of
the extension cord or multisocket before you connect the appliance.
The appliance is not located immediately below a wall socketoutlet.
Never install this appliance close to anything combustible material, such as furniture, curtains,
etc.
In order to avoid overheating and fire hazard, do not cover or obstruct the appliance. Do not
put any of the following materials on the appliance, such as clothes, blanket, pillow, paper etc.
The appliance become extremely hot during operation. Pay attention that, no combustible
material due to Wind or other environmental influences covers or obstructs the appliance, such
as curtains, marquees, flags, plastic foil etc. Do not touch the appliance. Caution! Risk of scald
injury!
Do not let the cord hang over edge of table or counter, or touch hot surfaces.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
In case of improper use, there is a risk of electrical shock and/or fire hazard. Operation of the
appliance must be discontinued and remove the mains plug immediately. Do not try to repair
the appliance by yourself. Please contact with the service agent or a suitably qualified
electrician for maintenance.
Remove the plug from the power outlet and wait until the appliance is sufficiently cooled off
before cleaning.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Keep out of reach of children. In order to keep children from the dangers of electrical
appliances, never leave them unsupervised with the machine. Consequently, when selecting
2
the location for your machine, do so in such a way that children do not have access to the
machine. Children being supervised not to play with the appliance.
Th appliancee mus onl b mounted a authorizedt y e by n specialist, paying attention t theo
relevant regulations o thef power supply companies and the regional construction regulations.
Do not use this heater wit programmer, timer,h a separate remote contro systeml o anyr other
device that switches the fir ris exist i the heate o automatically sincer n , a e k s f heater is covered
or positioned incorrectly.
the fireguard of this heater is intended t preveo nt direct access elements to heating and must
be in place the when heater is in use.
Installation
For additional protection the installation of a residual current device (RCD) is advisable.
Remove package all material (including antivibration and object o thef lamp) check the
appliance, supply cor andd the plug for signs o damage.f
Pay attention to the mounting place and all mounting material(dowels, screws) Ensure they.
are suitable stable and enough for mounting and lastingly holding of the appliance.
Before the show i the mounting, minimum and safe mounting distances tilt angles n n figures
mus b strictlyt e followed.
1. Th distance edg o the appliance thee between the bottom e f and floor must at be least
1 8, m.
2. There mus b distancet e a of a leas 0 2t t , mbetween th applianc ande e the ceilings, roofs
or other covers.
3. There must at b distancee a of leas 0 5t , ma eacht side between the appliance and walls
or the like. Se figuree 2.
4. Remembe thatr degree t mountingo surface is 45°.
Pay attention installation wind that, the o the appliancef must not add excessive load.
Fix the on the Ensure the be mounting bracket wall first. that place to installed is secure and
firm. O connectr the t the appliance o stand.
Adjust the desired angl o radiatione f an fes screwd t al screws.l Chec regularlyk the screws
connection. Mechanical bearin pressureg an oscillation couldd due to wind rain or lea tod
loose.
Plug in the the power source. Then observe, whether during firs 10t 15 minutes the appliance
works troublefree.
3
Figure1: Mounting bracket and anchor dowels
provided. Connection from the wall to the infrared
heater.
Figure2: Min. distance to floor, ceiling and wall.
Figure3: Tilt angle. Figure 4: Max.remote distance
4
Specifications
Specification Thermex Black Sun II
Voltage (V) 220240 V
Power consumption (W) 2000 W
Dimensions
W H× ×D (cm) 94 10× ×8 3,
Remote Control Instructions
Button Function Feature
On On
1. Turn on the heater
2. Receiver light in heater will turn Red with 100
power output..
Off Off
1.Turn off the heater
2.The receive lightr will be flas i Re colorh n d i thef
heater connects to the power supply. here be T will
no indication after cutting of thef electricity.
Notice
Use control. Remove the use 2 pieces AAA 1 5V, batteries in the remote battery when not for long
time, thus the lifespa o remoten f control can b extended.e
Choose the same specification when battery replacing the battery inside, otherwise it may
cause remote control not work, thereby affect the the normal use of heater.
Please contac servic agen fort e t further help need i youf the function.
The remote be control function may out of if work there the remote is a barrier between control and
heater .
5
Cleaning and Maintenance
Before cleaningremove the plug from the power outlet and wait until the appliance is
sufficiently cooled off.
Wipe the appliance only with clean and lintfree cloth or a soft brush.
Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
The alcohol can be used to clean the appliance. When cleaning the reflector , please contact
with the service agent or a suitably qualified electrician if the reflector needs to be removed
To protect against electrical shock and danger of life, do not immerse cord, plug, or any part of
the appliance in water or other liquid.
For heating element replacement please contact the manufacturer or its service agent or a
similarly qualified person.
Disposal
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Customer Service
Repairs must be carried out by authorize specialists, thus ensuring electrical safety. Please contact
with the service agent or a suitably qualified electrician.
Improper repairs could lead to danger to the user.
This warranty does not cover damage of failure which results from alteration, accident, misuse,
abuse, neglect, commercial use or improper maintenance.
In line with our policy of continuous product development we reserve the right to change the
product and documentation specifications without notice.
Installation Roof
Black Sun II are equipped with the ability to hang with chains from the ceiling. See
drawing below for a description of how you attach the hook to the back of the product.


Product specificaties

Merk: Thermex
Categorie: Heater
Model: Black Sun II

Heb je hulp nodig?

Als je hulp nodig hebt met Thermex Black Sun II stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Thermex

Handleiding Heater

Nieuwste handleidingen voor Heater