Thermador PA48WTKG Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Thermador PA48WTKG (12 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 222 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
THERMADOR.COM
Installation
INSTRUCTIONS
Professional Series Pro Grand® Range Low Backguard and Toe Kick Accessory
THERMADOR.COM
Installation
INSTRUCTIONS
English................................................................................................2
Français ..............................................................................................5
Español............................................................................................... 8
Models |
Modèles |
Modelos:
PA36JLBG
PA48JLBG
PA48JLBSG
PA60RLBG
PA36JTKG
PA48JTKG
PA60RTKG
Professional Series Pro Grand® Range Low Backguard and Toe Kick Accessory
Page. 2
Safety
DEFINITIONS
9 WARNING
This indicates that death or serious injuries may occur
as a result of non-observance of this warning.
9 CAUTION
This indicates that minor or moderate injuries may
occur as a result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or
property may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or tips.
Rear clearance
REQUIREMENTS
To avoid staining on the back wall, high temperature,
non-porous construction materials suitable for use in a
cooking environment are recommended.
Models PRD606xx are suitable for 0'' rear clearance to
combustible surfaces.
All other models:
When using the included island trim a minimum 6"
(152 mm)* rear clearance is required to a
combustible surface*.
When installing against a combustible surface, a
Thermador low backguard is required for a 0'' rear
clearance to the combustible surface. A
Thermador low backguard must be purchased
separately.
A rear clearance to a surface covered in a non-
combustible material (metal, ceramic tile, brick,
marble, or stone)* is 0'' when using the included
Island Trim.
*Clearances of less than 6'' (152 mm) should be approved by the
local codes and/or by the local authority having jurisdiction.
Clearances from non-combustible materials are not part of the
ANSI Z21.1 scope and are not certified by CSA.
Installation
INSTRUCTIONS
For use with the following models:
State of California Proposition 65 Warning:
: WARNING
This product can expose you to chemicals including
vinyl chloride, which is known to the State of California
to cause cancer and birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov.
9 WARNING
Fingers or hands could get pinched when installing
the backguard. Severe injury could result. Use
extreme caution and wear thick protective gloves to
avoid potential laceration to finger or hand while
sliding the backguard down onto the range.
9 WARNING
To avoid possible burn or fire hazard, a backguard
designed specifically for this appliance must be
installed whenever the appliance is used.
PRD364WDGx PRD48WCSGx PRG364WDG
PRD364WIGx PRD48WDSGx PRG364WLG
PRD364WLGx PRD48WISGx PRG366WG
PRD366WGx PRD48WLSGx PRG486WDG
PRD484WCGx PRD606WCG PRG486WLG
PRD486WDGx PRD606WCSG
PRD486WIGx PRD606WEG
PRD486WLGU PRD606WESG


Product specificaties

Merk: Thermador
Categorie: Niet gecategoriseerd
Model: PA48WTKG

Heb je hulp nodig?

Als je hulp nodig hebt met Thermador PA48WTKG stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Thermador

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Senal

Senal SCS-98 Handleiding

21 November 2024
Senal

Senal ASM-6 Handleiding

21 November 2024
Senal

Senal ASM-MNTKIT Handleiding

21 November 2024
Senal

Senal SMS-45 Handleiding

21 November 2024
Smeg

Smeg KIT6PX Handleiding

21 November 2024
Senal

Senal SCI-3212MP Handleiding

21 November 2024
Senal

Senal OLM-2S-P Handleiding

21 November 2024
Senal

Senal ME-220-CL Handleiding

21 November 2024
Senal

Senal ASM-4 Handleiding

21 November 2024