Teledex AT1202 Handleiding

Teledex Telefoon AT1202

Lees hieronder de 📖 handleiding in het Nederlandse voor Teledex AT1202 (3 pagina's) in de categorie Telefoon. Deze handleiding was nuttig voor 52 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

iPhone Trimline User Guide

For Models AT1101, AT1102, AT1201, AT1202

CONNECTING THE PHONE

1. Located on the left side of the phone is a modular jack.

Insert one end of the coiled handset cord into this jack (you

should hear the coil cord click when properly inserted).

2. Insert the other end of the coiled handset cord into the

modular jack on the bottom of the handset.

3. Turn the telephone over and insert one end of the line cord

into the jack on the bottom of the telephone.

4. Route the line cord through the cable channel in the base

of the phone, and insert the other end into an analog

telephone jack.

PLACING A CALL

1. Lift the handset. Listen for dial tone. Dial the desired

number.

2. To end the call, hang up by placing the handset back

in the cradle.

RECEIVING A CALL

An audible ring and ﬂickering red message waiting light

(models AT1102 and AT1202 only) indicate an inbound call.

To answer the call, lift the handset and begin your conversa-

tion. To end the call hang up the handset.

REDIAL

To redial the last telephone number dialed, lift the handset

from the cradle and press the REDIAL key.

INITIATING A NEW CALL

The Teledex iPhone Trimline is equipped with a hook switch

on the handset, so it’s easy to place a new call without having

to return the handset to the base. To make a new call, simply

press the large oval button on the keypad, next to teh volume

keys. This performs the “FLASH” function.

ADJUSTING THE RING VOLUME

Locate the ringer volume control on the back of the

telephone. Slide the switch to the desired LOW or HI

ring volume.

ADJUSTING THE HANDSET VOLUME

In compliance with the Americans with Disabilities Act, this

phone has an adjustable handset volume feature. To adjust,

locate the volume UP and DOWN keys on the keypad. Press

the desired key to achieve the desired volume level.

MUTE KEY

The phone has a momentary MUTE key on the handset. To

mute the handset microphone, press and hold the MUTE key.

To resume your conversation, simply release the key.

MESSAGE WAITING INDICATOR

(Models AT110 and AT120 only)1 1

The message waiting indicator is located near the top of the

phone base. Most telephone systems will turn on this indicator

to alert you that there is a message for you. Follow procedures

outlined in the guest directory for retrieving messages.

BACKLIT KEYPAD

The phone has a backlit keypad for easy of use in a low-light

environment. The backlight is automatically switched on when

the handset is removed from the base.

ANALOG DATA PORT

The phone is equipped with a standard RJ-11 analog data

port on the right side of the phone. This provides access for a

modem or fax machine to be used on the same line.

WALL MOUNTING

The phone can be easily wall-mounted by placing it over any

standard wall mounting plate and pressing down.

RMA PROCEDURES

The following procedure should be followed with all Teledex

telephone products prior to sending the telephone to the

factory for repair. Please perform the tests listed below:

1. Test the phone on a different telephone jack.

2. Test the phone with a different line cord.

3. Test the phone with a different handset cord.

4. For two-line products, please ensure that one of the line

buttons is pressed (if both line buttons are in the UP position,

the telephone will not operate).

If the steps listed above do not remedy the situation, please

visit our website, www.teledex.com, for RMA instructions.

From teledex.com, you can process your RMA online and print

a shipping label.

Handset

Base

User Guide

Line Cord

Coiled handset cord

Included in Your Package

REQUIREMENTS OF PART 68 - FCC RULES

This device has been granted a registration number by the Federal Communica-

tions Commission, under Part 68 rules and regulations for direct connection

to the telephone lines. In order to complywith these FCC rules, the following

instructions must be carefully read and applicable portions followed

completely:

1. Direct connection to the telephone lines may be made only through the stan-

dard modular cord furnished, to the utility installed jack. No connection may be

made to party or coin phone lines. On the bottom of the phone is a label that

contains among other information, the FCC Registration Number and the Ringer

Equivalence number (REN) for this equipment. If requested, this information

must be provided to the telephone company. The USOC Jack for this equipment

is RJ11C.

2. The telephone company, under certain circumstances, may temporarily discon-

tinue and make changes in facilities and services which may affect the operation

of the users’ equipment: however, the user shall be given adequate notice in

writing to allow the user to maintain uninterrupted service.

3. In certain circumstances, it may be necessary for the telephone company to

request information from you concerning the equipment which you have

connected to your telephone line. Upon request of the telephone company,

provide the FCC registration number and the ringer equivalence number of the

equipment which is connected to your line; this information will be found on

the device.

4. If any of your telephone equipment is not operating properly, you should im-

mediately remove it from the telephone line. It may cause harm to the

telephone network.

5. If the telephone company notes a problem, they may temporarily discontinue

service. When practical, they will notify you in advance of disconnection.

If advance notice is not feasible, the telephone company must: promptly notify

you of such temporary discontinuance; afford the opportunity to correct the

condition; inform you of your rights to bring a complaint to the FCC under their

rules.

6. Repairs to the device may be made only by the manufacturer or an

authorized service agency. This applies at any time during and after warranty.

If unauthorized repair is performed, registration, connection to the telephone

lines and remainder of warranty period all become null and void.

7. This equipment is hearing aid compatible.

8. This telephone must be connected behind a PBX.

REQUIREMENTS OF PART 15 - FCC RULES

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

1. Move the telephone away from the receiver.

2. Consult the dealer or an experienced radio/TV technician for help.

Any changes made by the user not approved by the manufacturer can void

the user’s authority to operate the telephone.

INDUSTRY OF CANADA REQUIREMENTS

NOTICE: The Industry Canada label identiﬁes certiﬁed equipment. This certiﬁca-

tion means that the equipment meets certain telecommunications network

protective operational and safety requirements as prescribed in the appropri-

ate Terminal Equipment Technical Requirements documents. The department

does not guarantee the equipment will operate to the users satisfaction. Before

installing this equipment, users should ensure that it is permissible to be

connected to the facilities of the local telecommunications company. The

equipment must also be installed using an acceptable method of connection.

The customer should be aware that compliance with the above conditions may

not prevent degradation of service in some situations. Repairs to certiﬁed

equipment should be coordinated by a representative designated by the

supplier. Any repairs or alterations made by the user to this equipment, or

equipment malfunctions, may give the telecommunications company cause to

request the user to disconnect the equipment. Users should ensure for their own

protection that the electrical ground connections of the power utility,

telephone lines, and internal metallic water pipe systems, if present, are

connected together. This precaution may be particularly important in rural

areas.

Caution: Users should not attempt to make such connections themselves, but

should contact the appropriate authority or an electrician, as appropriate.

The Ringer Equivalence Number (REN) of this device is Z.

Notice: The Ringer Equivalence Number (REN) assigned to each terminal device

provides an indication of the maximum number of terminals allowed to be con-

nected to a telephone interface. The termination on an interface may consist of

any combination of devices subject only to the requirement that the sum of the

Ringer Equivalence Numbers of all the devices does not exceed 5. This telephone

connects to the telephone network under the connecting arrangement code

CA11A.

IMPORTANT SAFETY INSTRUCTIONS

WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS

SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK

AND INJURY TO PERSONS. INCLUDING THE FOLLOWING:

1. READ AND UNDERSTAND ALL INSTRUCTIONS.

2. FOLLOW ALLWARNINGS AND INSTRUCTIONS MARKED ON THE PRODUCT.

3. UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE CLEANING. DO

NOT USE LIQUID CLEANER OR AEROSOL CLEANERS. USE A DAMP CLOTH FOR

CLEANING.

4. DO NOT USE THIS PRODUCT NEAR WATER FOR EXAMPLE NEAR A BATHTUB,

WASHBOWL, KITCHEN SINK OR LAUNDRY TUB, IN A WET BASEMENT, OR NEAR

A SWIMMING POOL.

5. DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND OR TABLE.

THE PRODUCT MAY FALL, CAUSING SERIOUS DAMAGE TO THE PRODUCT.

6. SLOTS AND OPENINGS IN THE CASE, IF PRESENT, ARE PROVIDED FOR VENTILA-

TION PURPOSES, TO PROTECT THE PHONE FROM OVERHEATING. THESE OPEN-

INGS MUST NOT BE BLOCKED OR COVERED. THE OPENINGS SHOULD NEVER BE

BLOCKED BY PLACING THE PRODUCT ON THE BED, SOFA, RUG OR ANY OTHER

SIMILAR SURFACE. THIS PRODUCT SHOULD NEVER BE PLACED NEAR OR OVER

A RADIATOR OR HEAT REGISTER. THIS PRODUCT SHOULD NOT BE PLACED IN A

BUILT-IN INSTALLATION UNLESS PROPER VENTILATION IS PROVIDED.

7. NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCT THROUGH CABINET

SLOTS, AS THEY MAY TOUCH DANGEROUS VOLTAGE POINTS OR SHORT OUT

PARTS THAT COULD RESULT IN A RISK OF FIRE OR ELECTRIC SHOCK. NEVER SPILL

LIQUID OF ANY KIND ON THE PRODUCT.

8. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE THIS PROD-

UCT. INSTEAD, TAKE IT TO A QUALIFIED SERVICE CENTER SERVICE OR REPAIR.

OPENING OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS

VOLTAGES OR OTHER RISKS. INCORRECT REASSEMBLY CAN CAUSE ELECTRIC

SHOCK WHEN THE PHONE IS SUBSEQUENTLY USED.

9. AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE) DURING AN

ELECTRICAL STORM. THERE MAY BE A REMOTE RISK OF ELECTRIC SHOCK FROM

LIGHTNING.

10. DO NOT USE THE TELEPHONE TO REPORT A GAS LEAK IN THE VICINITY OF

THE LEAK.

SAVE THESE INSTRUCTIONS

Contacting Teledex

Worldwide Headquarters

6311 San Ignacio Ave

San Jose, CA 95119

Telephone

Main: +1.408.363.3100

Toll Free (US) +1.800.794.8353

Fax: +1.408.363.3136

Internet

www.teledex.com

sales@teledex.com

please visit www.teledex.com.

MODELS AT1101, AT1102

MODELS AT1201, AT1202

Product specificaties

Merk:	Teledex
Categorie:	Telefoon
Model:	AT1202

Heb je hulp nodig?

Als je hulp nodig hebt met Teledex AT1202 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Telefoon Teledex

Teledex SIP ND2105 Handleiding

26 Juni 2023

Teledex Pearl S Handleiding

26 Juni 2023

Teledex SIP LD4210S Handleiding

26 Juni 2023

Teledex SIP ND2105S Handleiding

26 Juni 2023

Teledex SIP ND2110 Handleiding

26 Juni 2023

Teledex SIP ND2110S Handleiding

26 Juni 2023

Teledex SIP LD4105S Handleiding

26 Juni 2023

Teledex Opal 1003 Handleiding

26 Juni 2023

Teledex SIP LD4205S Handleiding

26 Juni 2023

Teledex Opal 1010S Handleiding

26 Juni 2023

Handleiding Telefoon

Nieuwste handleidingen voor Telefoon

Yealink MP56 E2 Handleiding

24 September 2024

Yealink MP54 E2 Handleiding

23 September 2024

Yealink MP58-WH E2 Handleiding

23 September 2024

Yealink MP52 E2 Handleiding

23 September 2024

VXi D200 Dialpad Handleiding

11 September 2024

Lewitt LCT 240 Handleiding

6 September 2024

Valcom VIP-430 Handleiding

5 September 2024

Valcom VIP-431 Handleiding

5 September 2024

Valcom V-5330210 Handleiding

5 September 2024

Valcom V-5330110 Handleiding

5 September 2024