Tascam 788 Handleiding

Tascam Niet gecategoriseerd 788

Lees hieronder de 📖 handleiding in het Nederlandse voor Tascam 788 (128 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 232 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/128

788

OWNER’S MANUAL

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The exclamation point within an equilateral triangle is intended to alert the user to the pres-

ence of important operating and maintenance (servicing) instructions in the literature

accompanying the appliance.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert

the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure

that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This appliance has a serial number

located on the rear panel. Please record

the model number and serial number

and retain them for your records.

Model number

Serial number

WARNING: TO PREVENT FIRE OR SHOCK

HAZARD, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

9101420600

2 TASCAM 788 Digital Portastudio

Important Safety Precautions

IMPORTANT (for U.K. Customers)

DO NOT cut off the mains plug from this equipment.

If the plug fitted is not suitable for the power points in your home or

the cable is too short to reach a power point, then obtain an appro-

priate safety approved extension lead or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose

of the plug immediately, to avoid a possible shock hazard by inad-

vertent connection to the mains supply.

If this product is not provided with a mains plug, or one has to be

fitted, then follow the instructions given below:

IMPORTANT: DO NOT make any connection to the larger termi-

nal which is marked with the letter E or by the safety earth symbol

ç or coloured GREEN or GREEN-and-YELLOW.

The wires in the mains lead on this product are coloured in accord-

ance with the following code:

BLUE : NEUTRAL

BROWN : LIVE

As these colours may not correspond with the coloured markings

identifying the terminals in your plug proceed as follows:

The wire which is coloured BLUE must be connected to the terminal

which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the ter-

minal which is marked with the letter L or coloured RED.

When replacing the fuse only a correctly rated approved type should

be used and be sure to re-fit the fuse cover.

IF IN DOUBT — CONSULT A COMPETENT ELECTRICIAN.

TO THE USER

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment gen-

erates, uses, and can radiate radio frequency

energy and, if not install ed an d used in

accordance with the instruction manual, may

cause harmful interference to radio comm-

unications. However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception,

which can be determ ined by turn ing the

equipment off and on, the user is encouraged to

try to correct the interference by one or more of

the following measures.

a)Reorient or relocate the receiving antenna.

b)Increase the separation between the

equipment and receiver.

c)Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

d)Consult the dealer or an experienced radio/

TV technician for help.

CAUTION

Changes or modifications to this equipment not

expressly approved by TEAC CORPORATION

for compliance could void the user’s authority to

operate this equipment.

For U.S.A

TASCAM 788 Digital Portastudio 3

CAUTION:

…Read all of these Instructions.

…Save these Instructions for later use.

…Follow all Warnings and Instructions marked on the audio

equipment.

1) Read Instructions — All the safety and operating instructions should

be read before the product is operated.

2) Retain Instructions — The safety and operating instructions should

be retained for future reference.

3) Heed Warnings — All warnings on the product and in the operating

instructions should be adhered to.

4) Follow Instructions — All operating and use instructions should be

followed.

5) Cleaning — Unplug this product from the wall outlet before cleaning.

Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for clean-

ing.

6) Attachments — Do not use attachments not recommended by the

product manufacturer as they may cause hazards.

7) Water and Moisture — Do not use this product near water — for

example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet

basement; or near a swimming pool; and the like.

8) Accessories — Do not place this product on an unstable cart, stand,

tripod, bracket, or table. The product may fall, causing serious injury to a

child or adult, and serious damage to the product. Use only with a cart,

stand, tripod, bracket, or table recommended by the manufacturer, or sold

with the product. Any mounting of the product should follow the manufac-

turer’s instructions, and should use a mounting accessory recommended by

the manufacturer.

9) A product and cart combination should be moved with care. Quick stops,

excessive force, and uneven surfaces may cause the product and cart com-

bination to overturn.

10) Ventilation — Slots and openings in the cabinet are provided for ven-

tilation and to ensure reliable operation of the product and to protect it from

overheating, and these openings must not be blocked or covered. The open-

ings should never be blocked by placing the product on a bed, sofa, rug, or

other similar surface. This product should not be placed in a built-in instal-

lation such as a bookcase or rack unless proper ventilation is provided or

the manufacturer’s instructions have been adhered to.

11) Power Sources — This product should be operated only from the

type of power source indicated on the marking label. If you are not sure of

the type of power supply to your home, consult your product dealer or local

power company. For products intended to operate from battery power, or

other sources, refer to the operating instructions.

12) Grounding or Polarization — This product may be equipped with a

polarized alternating-current line plug (a plug having one blade wider than

the other). This plug will fit into the power outlet only one way. This is a

safety feature. If you are unable to insert the plug fully into the outlet, try

reversing the plug. If the plug should still fail to fit, contact your electrician

to replace your obsolete outlet. Do not defeat the safety purpose of the

polarized plug.

13) Power-Cord Protection — Power-supply cords should be routed so

that they are not likely to be walked on or pinched by items placed upon or

against them, paying particular attention to cords at plugs, convenience

receptacles, and the point where they exit from the product.

14) Outdoor Antenna Grounding — If an outside antenna or cable

system is connected to the product, be sure the antenna or cable system is

grounded so as to provide some protection against voltage surges and built-

up static charges. Article 810 of the National Electrical Code, ANSI/NFPA

70, provides information with regard to proper grounding of the mast and

supporting structure, grounding of the lead-in wire to an antenna discharge

unit, size of grounding conductors, location of antenna-discharge unit, con-

nection to grounding electrodes, and requirements for the grounding elec-

trode.

"Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to

Section 820-40 of the NEC which provides guidelines for proper grounding

and, in particular, specifies that the cable ground shall be connected to the

grounding system of the building, as close to the point of cable entry as

practical.

15) Lightning — For added protection for this product during a lightning

storm, or when it is left unattended and unused for long periods of time,

unplug it from the wall outlet and disconnect the antenna or cable system.

This will prevent damage to the product due to lightning and power-line

surges.

16) Power Lines — An outside antenna system should not be located in

the vicinity of overhead power lines or other electric light or power circuits,

or where it can fall into such power lines or circuits. When installing an

outside antenna system, extreme care should be taken to keep from touch-

ing such power lines or circuits as contact with them might be fatal.

17) Overloading — Do not overload wall outlets, extension cords, or

integral convenience receptacles as this can result in risk of fire or electric

shock.

18) Object and Liquid Entry — Never push objects of any kind into

this product through openings as they may touch dangerous voltage points

or short-out parts that could result in a fire or electric shock. Never spill

liquid of any kind on the product.

19) Servicing — Do not attempt to service this product yourself as open-

ing or removing covers may expose you to dangerous voltage or other

hazards. Refer all servicing to qualified service personnel.

20) Damage Requiring Service — Unplug this product from the wall

outlet and refer servicing to qualified service personnel under the following

conditions:

a) when the power-supply cord or plug is damaged.

b) if liquid has been spilled, or objects have fallen into the product.

c) if the product has been exposed to rain or water.

d) if the product does not operate normally by following the operating

instructions. Adjust only those controls that are covered by the operating

instructions as an improper adjustment of other controls may result in

damage and will often require extensive work by a qualified technician to

restore the product to its normal operation.

e) if the product has been dropped or damaged in any way.

f ) when the product exhibits a distinct change in performance – this

indicates a need for service.

21) Replacement Parts — When replacement parts are required, be sure

the service technician has used replacement parts specified by the manufac-

turer or have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock, or other

hazards.

22) Safety Check — Upon completion of any service or repairs to this

product, ask the service technician to perform safety checks to determine

that the product is in proper operating condition.

23) Wall or Ceiling Mounting — The product should be mounted to a

wall or ceiling only as recommended by the manufacturer.

24) Heat — The product should be situated away from heat sources such

as radiators, heat registers, stoves, or other products (including amplifiers)

that produce heat.

ANTENNA

LEAD IN

WIRE

ANTENNA

DISCHARGE UNIT

(NEC SECTION 810-20)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250. PART H)

NEC - NATIONAL ELECTRICAL CODE

ELECTRIC

SERVICE

EQUIPMENT

Example of Antenna Grounding as per

National Electrical Code, ANSI/NFPA 70

GROUND

CLAMP

IMPORTANT SAFETY INSTRUCTIONS

Product specificaties

Merk:	Tascam
Categorie:	Niet gecategoriseerd
Model:	788

Heb je hulp nodig?

Als je hulp nodig hebt met Tascam 788 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Tascam

Tascam DR-10L Pro Handleiding

4 Augustus 2023

Tascam TC-8 Handleiding

13 Juni 2023

Tascam US-800 Handleiding

12 Juni 2023

Tascam 424MKIII Handleiding

23 Mei 2023

Tascam DP-008 Handleiding

13 Mei 2023

Tascam VL-A4 Handleiding

11 Mei 2023

Tascam US-1200 Handleiding

25 April 2023

Tascam MiNiSTUDIO Creator US-42B Handleiding

23 April 2023

Tascam TT-M1 Handleiding

23 April 2023

Tascam Podcast Editor Handleiding

21 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Philips Quick Clean Pot QCP10 Handleiding

24 December 2024

Philips Senseo HD7002 Handleiding

24 December 2024

D-Link DUB-C2 Handleiding

24 December 2024

Nec MultiPresenter Stick DS1-MP10RX1 Handleiding

24 December 2024

Nec DS1-TM01 Handleiding

24 December 2024

Profoto RFi Softbox Octa Handleiding

24 December 2024

Koenic KAP 2523 Handleiding

24 December 2024

Philips HD9921 Handleiding

24 December 2024

Philips Senseo HD7008 Handleiding

24 December 2024

Onkyo IRK1804C Handleiding

24 December 2024