T-Rex TMA-9H Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor T-Rex TMA-9H (13 pagina's) in de categorie Krik. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/13
User Manual
[Revision February 2022.0 1]
READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO
MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID
WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products
covered by this manual may vary in appearance, assembly, inclusions,
specifications, escription,d and packaging.
Portable Hydraulic Lift – TMA-9H
E&OE © 2 2021 Trex
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death,
injury or equipment or property damage if not understood or followed. Safety messages have the
following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you
do not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you
do not follow instructions.
You CAN be INJURED if you
do not follow instructions or
equipment damage may occur.
It is vital that you read and understand
this user manual before using the product,
including safety warnings, and any
assembly and operating instructions.
Keep the manual for future reference.
Safety precautions and recommendations
detailed here must be fully understood
and followed to reduce the risk of injury,
fire, explosion, electrical hazard, and/or
property damage.
Safety information presented here is
generic in nature – some advice may not
be applicable to every product. The term
"equipment" refers to the product, be it
electrical mains powered, battery powered
or combustion engine powered.
• - If you are not familiar with Before Use
the safe operation/handling of the
equipment, or are in any way unsure of
any aspect of suitability or correct use
for your application, you should
complete training conducted by a
person or organization qualified in safe
use and operation of this equipment,
including fuel/electrical handling and
safety.
• Do NOT operate the equipment in
flammable or explosive environments,
such as in the presence of flammable
liquids, gases or dust. The equipment
may create sparks or heat that may
ignite flammable substances.
• Keep clear of moving parts.
• Equipment may be a potential source of
electric shock or injury if misused.
• Do NOT operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
• Do NOT allow others to use the
equipment unless they have read this
manual and are adequately trained.
• Keep packaging away from children -
risk of suffocation! Operators must use
the equipment correctly. When using
the equipment, consider conditions and
pay due care to persons and property.
General Work Area Safety
• Work areas should be clean and well it.
• Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
• If devices are provided for connecting
dust extraction / collection facilities,
ensure these are connected and used
properly. Dust collection can reduce
dust-related hazards.
General Personal Safety
• Wear appropriate protective equipment
when operating, servicing, or when in
the operating area of the equipment to
help protect from eye and ear injury,
poisoning, burns, cutting and crush
injuries. Protective equipment such as
safety goggles, respirators, non-slip
safety footwear, hard hat, hearing
protection etc should be used for
appropriate equipment / conditions.
Other people nearby should also wear
appropriate personal protective
equipment. Do not wear loose clothing
or jewellery, which can be caught in
moving parts. Keep hair and clothing
away from the equipment.
• Stay alert and use common sense
when operating the equipment. Do not
over-reach. Always maintain secure
footing and balance.
• Do not use the equipment if tired or
under the influence of drugs, alcohol or
medication.
• This equipment is not intended for use
by persons with reduced physical,
sensory or mental capabilities.
General Fuel Safety
• Petrol/fuel/gasoline is extremely
flammable – keep clear of naked
flames or other ignition sources.
• Do not spill fuel. If you spill fuel, wipe it
off the equipment immediately – if fuel
gets on your clothing, change clothing.
• Do NOT smoke near fuel or when
refuelling.
• Always shut off the engine before
refuelling.
• Do NOT refuel a hot engine.
• Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly.
• Always refuel in well ventilated areas.
• Always check for fuel leakage. If fuel
leakage is found, do not start or run the
engine until all leaks are fixed.
General Carbon-Monoxide Safety
• Using a combustion engine indoors
CAN KILL IN MINUTES. Engine
exhaust contains carbon-monoxide – a
poison you cannot smell or see.
• Use combustion engines OUTSIDE
only, and far away from windows, doors
and vents.
General Equipment Use and Care
• The equipment is designed for
domestic use only.
• Handle the equipment safely and
carefully.
• Before use, inspect the equipment for
misalignment or binding of moving
parts, loose components, damage or
any other condition that may affect its
operation. If damaged, have the
equipment repaired by an authorised
service centre or technician before use.
• Prevent unintentional starting of the
equipment - ensure equipment and
power switches are in the OFF position
before connecting or moving
equipment. Do not carry equipment
with hands or fingers touching any
controls. Remove any tools or other
items that are not a part of the
equipment from it before starting or
switching on.
• Do not force the equipment. Use the
correct equipment for your application.
Equipment will perform better and be
safer when used within its design and
usage parameters.
• Use the equipment and accessories
etc. in accordance with these
instructions, considering working
conditions and the work to be
performed. Using the equipment for
operations different from those
intended could result in hazardous
situations.
• Always keep equipment components
(engines, hoses, handles, controls,
frames, housings, guards etc) and
accessories (cutting tools, nozzles, bits
etc) properly maintained. Keep the
equipment clean and, where applicable,
properly lubricated.
• Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place or store the
equipment near flammable materials,
combustible gases or liquids etc.
• The equipment is not weather-proof,
and should not be stored in direct
sunlight, at high ambient temperatures
or locations that are damp or humid.
• Do not clean equipment with solvents,
flammable liquids or harsh abrasives.
• For specific equipment safety use and
care, see Equipment Safety.
Portable Hydraulic Lift – TMA-9H
E&OE © 3 2021 Trex
General Electrical Safety
• Inspect electrical equipment, extension
cords, power bars, and electrical fittings
for damage or wear before each use.
Repair or replace damaged equipment
immediately.
• Ensure all power sources conform to
equipment voltage requirements and
are disconnected before connecting or
disconnecting equipment.
• When wiring electrically powered
equipment, follow all electrical and
safety codes.
• Wherever possible, use a residual
current device (RCD).
• High voltage / high current power lines
may be present. Use extreme caution
to avoid contact or interference with
power lines. Electrical shock can be
fatal.
General Electrical Safety
• Electrically grounded equipment must
have an approved cord and plug and
be connected to a grounded electrical
outlet.
• Do NOT bypass the ON/OFF switch
and operate equipment by connecting
and disconnecting the electrical cord.
• Do NOT use equipment that has
exposed wiring, damaged switches,
covers or guards.
• Do NOT use electrical equipment in wet
conditions or in damp locations.
• Do NOT use electrical cords to lift,
move or carry equipment.
• Do NOT coil or knot electrical cords,
and ensure electrical cords are not trip
hazards.
General Service Information
• The equipment must be serviced or
repaired at authorised service centres
by qualified personnel only.
• Replacement parts must be original
equipment manufacturer (OEM) to
ensure equipment safety is maintained.
• Do NOT attempt any maintenance or
repair work not described in this
manual.
• After use, the equipment and
components may still be hot – allow the
equipment to cool and disconnect spark
plugs and/or electrical power sources
and/or batteries from it before making
adjustments, changing accessories or
performing repair or maintenance.
• Do NOT make adjustments while the
equipment is running.
• Perform service related activities in
suitable conditions, such as a
workshop.
• Replace worn, damaged or missing
warning/safety labels immediately.
Owner and/or Operator Responsibility
The owner and/or operator shall study the product instructions and retain them for future reference.
Operation
The owner and/or operator should understand the product, its operating characteristics, and safety operating instructions before
operating the lift. Safety information should be emphasised and understood. If the operator Is not fluent In English, the product and
safety instructions should be read to and discussed with the operator in the operator's native language by the purchaser/owner or his
designee, making sure that the operator comprehends their contents.
Maintenance
The lift should be maintained in accordance with the product instruction.
• When jack is not in use, lifting arm should be in full downward position.
• Always keep the jack clean and keep screws and bearings well-lubricated.
• Keep moving parts clean; lubricate moving parts every 3 months.
Inspection
• Visual inspection shall be made before each use of the jack by checking for any abnormal conditions such as cracked welds, leaks
and damaged, loose, or missing parts.
• Other inspections shall be made per product operating instructions.
• The jack should be inspected immediately if the device Is believed to have been subjected to an abnormal load or shock. It Is
recommended that this inspection be made by the manufacturer or supplier authorised repair facility. ’s ’s
• Owners and/or operators should be aware that repair of this equipment may require specialised knowledge and facilities. It is
recommended that an annual inspection of the jack be made by a manufacturer’s or supplier’s authorised repair facility and that any
defective parts, decals, or safety labels or signs be replaced with manufacturer's or supplier's specified parts.
Damaged Equipment
Any jack that appears to be damaged in any way, is found to be worn or operates abnormally SHOULD BE REMOVED FROM
SERVICE UNTIL REPAIRED. It is recommended that necessary repairs be made by a manufacturer's or supplier’s authorised repair
facility if repairs are permitted by the manufacturer or supplier.
Alterations
Because of potential hazards associated with this type of equipment, no alterations shall be made to the product.
Attachments and Adaptors
Only attachments and/or adaptors supplied by the manufacturer should be used.
WARNING!
Study, understand and follow all instructions before operating this device.
Do not exceed rated capacity.
Use only on hard, level surfaces.
Centre load on lift platform.
Product specificaties
| Merk: | T-Rex |
| Categorie: | Krik |
| Model: | TMA-9H |
Heb je hulp nodig?
Als je hulp nodig hebt met T-Rex TMA-9H stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Krik T-Rex
18 Juli 2023
18 Juli 2023
14 Juli 2023
14 Juli 2023
14 Juli 2023
Handleiding Krik
- Krik Al-ko
- Krik Einhell
- Krik Ferm
- Krik Silverline
- Krik Soundmaster
- Krik Ultimate Speed
- Krik Westfalia
- Krik Car Xtras
- Krik Facom
- Krik Hamron
- Krik Linn
Nieuwste handleidingen voor Krik
8 April 2024
25 Februari 2024
25 Februari 2024
25 Februari 2024
25 Februari 2024
6 December 2023
6 December 2023
15 September 2023
20 Juni 2023
26 Mei 2023