Sweex LW050UK Handleiding

Sweex Router LW050UK

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Sweex LW050UK (22 pagina's) in de categorie Router. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/22
English version
4
LW050/LW050UK Sweex Wireless Broadband Router 54 Mbps
Introduction
First of all, many thanks for purchasing this Sweex Wireless Broadband Router 54 Mbps. The Sweex Wireless Broadband Router 54 Mbps enables
you to share a broadband Internet connection and to set up your own wireless network.
To ensure this product operates correctly, we advise you to carefully read this manual first. If despite this manual you still experience problems during
installation or operation of this product, go to www.sweex.com and look under the heading service & support.
In order to fully enjoy the Sweex Wireless Broadband Router 54 Mbps, it is important to observe a number of things:
β€’ Do not expose the Sweex Wireless Broadband Router 54 Mbps to extreme temperatures.
Do not place the device in direct sunlight or in the direct vicinity of heating elements.
β€’ Do not use the Sweex Wireless Broadband Router 54 Mbps in extremely dusty or moist surroundings.
β€’ Protect the device against powerful shocks or jolts - they may damage the internal electronics.
β€’ Never attempt to open the device yourself - it will cause the warranty to lapse.
Contents of the box
Prior to using the Sweex Wireless Broadband Router 54 Mbps, check if all required parts are present. The following parts must be present in the box:
β€’ Wireless broadband router 54 Mbps
β€’ Antenna
β€’ Power supply adaptor
β€’ RJ-45 UTP Ethernet network cable
β€’ CD-ROM with manual and Panda Anti-virus trial software
If one of the above parts is missing, please contact the shop or supplier.
English version
5
Specifications
β€’ Supports: IEEE 803.3 and IEEE 803.3u
β€’ Supports: IEEE 802.11b, IEEE 802.11g
β€’ Maximum wireless data transfer speed: 54Mbps
β€’ Supports: DHCP (dynamic IP), PPTP, Static IP, PPPoE, L2TP
β€’ 1 x WAN, 4 x LAN RJ-45 UTP ports
β€’ Supports: WEP/WPA./WPA2/802.1X data encryption
β€’ Built-in Firewall and Port Forwarding
β€’ Removable reverse SMA Antenna 5 dBi
β€’ 2 to 3 x Extended Range
β€’ Supports: VPN pass through
β€’ Web-based configuration
β€’ Not operating system dependent
Front view
Status Status Meaning
Power
Off The router is switched off
Lit The router is switched on
System
Lit The router is starting up
Blinking The router is operating correctly
Off The router has a hardware error
Link/Act WAN
and 1 to 4
Off No device is connected to this port
Lit A computer or other network device is connected to this port
Blinking There is data traffic between the router and the connected device
WLAN
Off The wireless part is switched off
Blinking The wireless part is active
English version
6
Rear view
β€’ Antenna with reverse SMA connector.
β€’ Reset button to return to the factory settings
β€’ WAN port for connecting a modem by means of a RJ-45 UTP Ethernet network cable.
β€’ LAN ports 1, 2, 3 and 4 for connecting computers by means of an RJ-45 UTP Ethernet network cable.
β€’ Power connector for connecting the power adaptor.
Connecting the Sweex Wireless Broadband Router 54 Mbps
1. Connect the power adaptor (included) to the rear of the router and the mains socket. The light next to β€œPower” is lit. In the event the LED is not
lit, check the connections of the power adaptor to the router and the mains socket.
2. Switch on the computer and connect it to the rear of the modem using a network cable (RJ-45 UTP). You can select any of the ports 1, 2, 3 and 4.
The corresponding light at the front will be lit. In the event the light fails to light up, check whether the network cable is properly connected to
the computer and the router.
3. Switch on the modem* again. Note: Here we do not refer to the Sweex router. Connect the modem to the rear of the router using a network
cable (RJ-45 UTP). Do this via the WAN port The WAN light at the front of the router will light up. In the event the light fails to light up, check
whether the network cable is properly connected to the router and the modem.
*In order to use the Sweex Wireless Broadband Router 54 Mbps you need an active Internet connection, which is established through a modem.
This modem is usually supplied by the provider.


Product specificaties

Merk: Sweex
Categorie: Router
Model: LW050UK

Heb je hulp nodig?

Als je hulp nodig hebt met Sweex LW050UK stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Router Sweex

Handleiding Router

Nieuwste handleidingen voor Router