Sun Joe 24V-LGT500-LTE Handleiding

Sun Joe Verlichting 24V-LGT500-LTE

Lees hieronder de 📖 handleiding in het Nederlandse voor Sun Joe 24V-LGT500-LTE (40 pagina's) in de categorie Verlichting. Deze handleiding was nuttig voor 6 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/40

Original instructions.

A Division of Snow Joe, LLC Model 24V-LGT500-LTE Form No. SJ-24V-LGT500-LTE-880E-MR1

OPERATOR’S MANUAL

CORDLESS LANTERN

24V MAX* | 500-MAX LUMEN LED

*Initial no-load voltage, when fully charged, peaks at 24V;

nominal voltage under typical load is 21.6V.

SAVE THESE INSTRUCTIONS

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Always follow these safety guidelines. Failure to do so may

result in serious bodily injury or death.

General Safety

mWARNING! This appliance is not intended for use

by children or by unassisted, unsupervised persons whose

physical, sensory or mental capabilities prevent them from

using it safely. Children should be supervised to ensure that

they do not play with the appliance.

Before starting up your machine, please check it carefully for

any defects. If you nd any, do not start up your machine.

Instead, contact your authorized Snow Joe® + Sun Joe® dealer

or call the Snow Joe® + Sun Joe® customer service center at

1-866-SNOWJOE (1-866-766-9563).

mWARNING! When using the power tool, basic safety

precautions should always be followed to reduce the risk of

fire, electric shock, and personal injury. These include:

• Read all the instructions before using the tool.

• Do not look into the light, or expose the light to eyes.

Eyes may be damaged.

• To reduce the risk of injury, children must be

supervised when using the tool around them.

• To reduce the risk of electrical shock, do not put the

lantern or charger in water or other liquid. Do not place

or store them where they can fall or be pulled into a tub or

sink.

• Recharge only with the charger specified by the

manufacturer. A charger that is suitable for one type

of battery pack may create a risk of fire when used with

another battery pack.

• Use tool only with specifically designated battery

packs. Use of any other battery packs may create a risk

of injury or fire.

• Remove battery pack from cordless lantern before

performing any routine maintenance or cleaning.

• Do not disassemble the lantern.

• Do not place lantern or battery pack near fire or heat.

They may explode. Do not incinerate the battery, even if it

is severely damaged or completely worn out. The battery

may explode in fire.

• Do not operate lantern or charger near flammable

liquids or in gaseous or explosive atmospheres.

Internal sparks may ignite fumes.

• Do not store in locations where the temperature is

fewer than 50°F or more than 100°F. Do not store in

outside sheds or in vehicles.

• Do not permit children to use lantern, lens, and

surrounding housing.

• Keep lantern dry, clean, and free from oil and grease.

Always use a clean cloth when cleaning. Never use brake

fluids, gasoline, petroleum-based products, or any strong

solvent to clean the lantern.

• Do not overreach while holding the lantern. Keep

proper footing and balance at all times. Proper footing

and balance enable better control of the lantern in

unexpected situations. Do not use on a ladder or unstable

support.

mWARNING! Do not use this appliance without reading

this instruction manual.

Lantern Use + Care

• This product is for household use only.

• Store the lantern out of the reach of children and other

untrained persons. The lantern is dangerous in the hands

of untrained users.

• Do not use or permit use of lantern in bed or sleeping

bags. The lantern lens can melt fabric and a burn injury

could result.

Safety Rules for Lantern

• Always remove battery pack before storing the device.

• Under extreme usage or temperature conditions,

battery leakage may occur. If liquid comes in contact

with your skin, wash immediately with soap and water.

If liquid gets in your eyes, flush them with clean water

for at least 10 minutes, then seek immediate medical

attention.

• Batteries can explode in the presence of a source

of ignition, such as a pilot light. To reduce the risk of

serious personal injury, never use any cordless product

in the presence of open flame. An exploded battery can

propel debris and chemicals. If exposed, flush with water

immediately.

• Do not crush, drop or damage battery pack. Do not

use a battery pack or charger that has been dropped

or received a sharp blow. A damaged battery is subject

to explosion. Properly dispose of a dropped or damaged

battery immediately. Failure to heed this warning can

result in serious personal injury.

• Save these instructions. Refer to them frequently and

use them to instruct others who may use this tool. If you

loan someone this tool, loan them these instructions also.

Battery & Charger

Safety Instructions

We pay a great deal of attention to the design of every battery

pack to ensure that we supply you with batteries that are safe,

durable and have a high energy density. The battery cells have

a wide range of safety devices. Each individual cell is initially

formatted and its electrical characteristic curves are recorded.

This data is then used exclusively to assemble the best

possible battery packs.

Despite all the safety precautions, caution must always be

exercised when handling batteries. The following points must

be obeyed at all times to ensure safe use. Safe use can only

be guaranteed if undamaged cells are used. Incorrect handling

of the battery packs can cause cell damage.

IMPORTANT! Analyses conrm that incorrect use and poor

care of high-performance batteries are the main factors

responsible for product damage and/or personal injury.

mWARNING! To reduce the risk of injury, use only official

24V iON+ designated chargers and battery packs. The use of

other batteries or chargers poses a risk of fire, personal injury

and damage.

mWARNING! Do not use a battery pack or product

that has been damaged or modified. Damaged or modified

batteries may exhibit unpredictable behavior resulting in fire,

explosion or risk of injury.

Do not modify or attempt to repair the product or the battery

pack except as indicated in the instructions for use and care.

Do not wire a battery pack to a power supply or car cigarette

lighter, as such misuse will permanently disable or damage the

battery pack.

Have your battery pack serviced by a qualied repair person

using only identical replacement parts. This will ensure that the

safety of the battery pack is maintained.

mWARNING! To reduce the risk of electric shock,

always unplug the charger before performing any cleaning

or maintenance. Do not allow water to flow into the charger.

Use a Ground Fault Circuit Interrupter (GFCI) to reduce shock

hazards.

• Remove battery – Remove the battery pack from the tool

when not in use, before servicing, or before performing

any other maintenance task. Never leave the tool

unattended while switched on. In the event of an accident

or breakdown, switch off the tool immediately.

• Avoid dangerous environments – Do not charge the

battery packs in rain, snow or in damp or wet locations.

Do not use the battery pack or charger in the presence

of explosive atmospheres (gaseous fumes, dust or

flammable materials) because sparks may be generated

when inserting or removing the battery packs, which could

lead to a fire.

NOTE: The safe temperature range for the batteries are

41°F (5°C) to 105°F (40.5°C). Do not charge the batteries

outside in freezing weather; charge them at room

temperature.

• Charge in a well-ventilated area – Do not block the

charger vents. Keep them clear to allow for proper

ventilation. Do not allow smoking or open flames near a

charging battery pack. Vented gases may explode.

• Maintain charger cord – When unplugging the charger,

pull the plug, not the cord from the receptacle to reduce

the risk of damage to the power cord. Never carry the

charger by its cord. Keep the cord away from heat, oil and

sharp edges. Make sure the cord will not be stepped on,

tripped over or subjected to damage or stress when the

charger is in use. Do not use a charger with a damaged

cord or plug. Replace a damaged charger immediately.

• Do not use an extension cord unless it is absolutely

necessary – Using the wrong, damaged or improperly

wired extension cord poses a risk of fire and electric

shock. If an extension cord must be used, plug the

charger into a properly wired 16 gauge or larger extension

cord with the female plug matching the male plug on the

charger. Make sure that the extension cord is in good

electrical condition.

• Do not expose the machine or battery packs to fire –

Exposure to fire or temperatures above 265°F (130°C)

may cause the battery packs to explode, causing personal

injury or damage. Toxic fumes and materials are created

when battery packs are ignited.

• Do not crush, drop or damage battery packs –

Do not use the battery packs or charger if they have

sustained a sharp blow, been dropped from a height

of more than 3 feet (1 meter), run over or have been

damaged in any way. Even if the housing of a battery

pack appears to be undamaged, the battery cells inside

the battery may have suffered serious damage. In such

instances, please read the waste disposal information for

proper battery disposal.

• Do not disassemble – Incorrect reassembly may pose

a serious risk of electric shock, fire or exposure to toxic

battery chemicals. If the battery or charger is damaged,

contact an authorized Snow Joe® + Sun Joe® dealer or

call the Snow Joe® + Sun Joe® customer service center at

1-866-SNOWJOE (1-866-766-9563) for assistance.

• Battery chemicals cause serious burns – Never let a

damaged battery pack contact the skin, eyes or mouth.

If damaged, battery chemicals will react violently with air.

Use rubber or neoprene gloves to safely dispose of the

battery. If skin is exposed to battery chemicals, wash the

affected area with soap and water. If eyes are exposed

to battery chemicals, immediately flush with water for 20

minutes and seek medical attention. Remove and dispose

of contaminated clothing.

• Risk of short circuit – A battery pack will short circuit if

a metal object makes a connection between the positive

and negative contacts on the battery pack. Do not place a

battery pack near anything that may cause a short circuit,

such as paperclips, coins, keys, screws, nails and other

metallic objects. A short-circuited battery pack poses a

risk of fire and severe personal injury.

• Store your battery packs and charger in a cool, dry

place – Ideally, store the battery packs at 59°F (15°C) and

charged to at least 40%. Do not store the battery packs or

charger where temperatures may exceed 105ºF (40.5ºC),

such as in direct sunlight or inside a vehicle, or where

temperatures may drop below 41°F (5°C).

NOTE: Prevent the battery packs from freezing. Battery

packs that were stored below 32°F (0°C) for more than 60

minutes must be discarded.

• Charge before use – The battery pack supplied with your

machine is only partially charged. The battery pack must

be fully charged before using the lantern for the first time.

• Battery Aging – Lithium-ion batteries are subject to a

natural aging process. A battery pack must be replaced at

the latest when its capacity falls to just 80% of its capacity

when new. Weakened cells in an aged battery pack are no

longer capable of meeting the high power requirements

needed for the proper operation of your machine, and

therefore pose a safety risk.

• Do not exhaustively discharge battery packs –

A complete discharge will damage the battery cells. The

most common cause of exhaustive discharge is lengthy

storage. Stop working as soon as the performance of a

battery falls noticeably or the electronic protection system

triggers. For optimum battery performance, charge the

battery packs frequently. Place the battery packs in

storage only after they have been fully charged.

• Do not overload battery packs – Protect the lantern and

battery from overloading. Overloads will quickly result in

overheating and cell damage inside the battery housing

even if it is not apparent externally. For safety reasons, the

integrated protective cutoff will activate to switch off the

equipment. After regular use, allow the battery packs to

cool to room temperature before recharging them.

IMPORTANT! Do not attempt to turn on the machine if the

protective cutoff has been activated. This may damage

the battery packs.

• Outlet voltage – Please check the data marked on the

rating label of the battery charger. Be sure that the voltage

of the power supply matches that marked on the rating

label. Never connect it to a different mains voltage.

• Charger use – Do not use the supplied battery charger to

charge other types of battery packs or tools.

• Do not overcharge battery packs – Do not exceed the

maximum charging times. Frequently overcharging the

battery packs will result in cell damage. Do not leave

battery connected to the charger for days on end.

• Battery pack abnormalities – Do not use batteries that

have suffered swelling or deformation or those that exhibit

other atypical symptoms (gassing, hissing, cracking, etc.).

• Electrostatic discharge – When handling batteries, be

wary of electrostatic charge. Electrostatic discharges can

damage the electronic protection system and the battery

cells. To avoid electrostatic discharges, never touch the

battery terminals.

Product specificaties

Merk:	Sun Joe
Categorie:	Verlichting
Model:	24V-LGT500-LTE

Heb je hulp nodig?

Als je hulp nodig hebt met Sun Joe 24V-LGT500-LTE stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Verlichting Sun Joe

Sun Joe 24V-LGT500-LTE Handleiding

6 Januari 2025

Sun Joe 24V-1500FL-LTE-P1 Handleiding

19 Mei 2023

Sun Joe 24V-1500FL-LTE Handleiding

16 April 2023

Sun Joe 24V-1500FL-CT Handleiding

14 Maart 2023

Handleiding Verlichting

Nieuwste handleidingen voor Verlichting

V-Tac VT-55ST Handleiding

8 Januari 2025

BeamZ Phoenix 5000 Handleiding

8 Januari 2025

Nitecore HA15 UHE Handleiding

30 December 2025

Nitecore NPL25 GL Handleiding

30 December 2025

Genaray Bright Beast TIR-1X1B Handleiding

27 December 2024

Genaray Quad Sun QS-1X4 Handleiding

27 December 2024

Aputure STORM 1200x Handleiding

24 December 2024

Kogan KAABLGTBARD Handleiding

23 December 2024

Kogan KASMCRTNLTA Handleiding

23 December 2024

LumenRadio CRMX Galileo MAX Handleiding

21 December 2024