Snom A230 Handleiding

Snom Niet gecategoriseerd A230

Lees hieronder de 📖 handleiding in het Nederlandse voor Snom A230 (3 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/3

v2021001_w

A230

USB DECT Dongle

Important Information

Please read the instructions on safety and disposal and on how to set up and use the device before using it

and also give them to other users to read or inform those users of their contents. Save this document and

do not give the device to third parties without it.

Safety Instructions

Follow the instructions in the manual and other applicable documentation of the device.

• Handle the product with care. Crushing, wrenching, or dropping it from even moderate heights may

damage it.

• This device is for indoor use only! Do not install outdoors - NOT FOR OUTDOOR USE!

• Do not install the device in rooms with high humidity (for example, in bathrooms, laundry rooms, damp

basements).

• Do not immerse the device in water and do not spill or pour liquids of any kind onto or into the device.

• Do not expose the product to extreme heat.

Standards Conformance

This device complies with Directive 2014/53/EU and the essential health, safety, and environmental

requirements of all relevant European and Australian directives. This device complies with the Radio

Equipment Regulations 2017 and the essential health, safety, and environmental requirements of all

relevant UK legislation. The declaration of conformity can be downloaded at https://www.snom.com/

conformity. Unauthorized opening, changing, or modifying the device will cause the warranty to lapse

and may also result in the loss of CE conformity. In case of malfunction contact authorized service

personnel, your seller, or Snom.

Safety: IEC 62368-1

Disposal

This device is subject to European Directive 2012/19/EU and may not be disposed of with general

household garbage. If you do not know where you may dispose of the device at the end of its lifespan,

contact your municipality, your local waste management provider, or your seller.

Registering a wireless device (speakerphone, headset)

1. Remove the dongle‘s protective cap.

2. Insert the dongle into the USB port.

3. Press the key on the dongle for 4 seconds to enter registration mode; the red

LED begins to double-ash rapidly. You now have 10 seconds to register the

device.

4. For pairing with A170/A150 headsets and C52-SP, see reverse side. For pairing

with other wireless devices, please refer to the manuals of the devices.

Deregistering

1. Press the key on the dongle for 10 seconds to enter deregistration mode. After 4 seconds the red LED

starts to double-ash; after 10 seconds the LED starts to ash red rapidly, indicating that the dongle has

entered deregistration mode.

2. Release the key and press it again for 1 second to conrm deregistration. The LED turns green for three

seconds, turns o for one second and then shows steady red light.

v2021001_w

A230 DECT USB-Stick

LED status indications

Description of state Pattern Green Red

Standby mode, no wireless device subscribed Steady - ON

In registration mode (duration 10 seconds) -Rapid double ashes ON

Standby, wireless device subscribed OFF - -

Ready to enter deregistration mode Rapid ashing ON

After deregistration mode has been conrmed:

1. Duration: 3 seconds Steady ON

2. Duration: 1 second OFF - -

3. Back in standby, no wireless device subscribed Steady - ON

Compatible with

• Wireless headsets Snom A170, A150

• wireless speakerphone Snom C52-SP

Pairing with A170/A150 headsets

1. Deregister the headset from its base station or from another dongle it may have been paired with. Please

refer to the user instructions of the headset or the dongle on how to do it. When the headset has been

deregistered, its LED blinks red and green alternatingly.

2. Press the key on the A230 for 4 seconds, then place the headset in its charger. The A230‘s red LED dou-

ble-ashes rapidly and turns o when the registration has been successful, while the headmit beeps once

and its LED switches to steady light (green if fully charged, red if charging).

Pairing with C52SP speakerphone

NOTE: If the speakerphone was previously registered to another DECT dongle or a C520-WiMi conference

phone, it must be deregistered rst.

◦For the deregistration from another A230 DECT dongle, see reverse side.

◦ For the deregistration from the C520-WiMi, please refer to the C520-WiMi

user manual.

NOTE: The C52SP‘s battery must be fully charged, and the device must be connected

to a wall outlet via its power adapter. Keep distance between C52SP and A230

at < 30 cm until pairing was successful.

1. Press the white registration button underneath the battery compartment on the

bottom of the speakerphone for 5 seconds until the speakerphone‘s LEDs start ashing red and green

alternatingly.

2. Press the key on the A230 for 4 seconds. The red LED double-ashes rapidly and

turns o when the registration has been successful. The LEDs on the C52-SP briey

turn green and then turn o while the red Power LED turns on.

Pairing with both: One C52 SP and one headset can be registered at the A230.

v2021001_w

A230 DECT USB-Stick

Using

Accepting calls

1. On the phone, select headset mode. : The C52SP does not ring until headset mode is selected.NOTE

2. You can accept a call ringing on the phone on the headset or on the speakerphone, respectively.

• On the A170/A150 headset, press the call button with LED.

• On the C52SP, press .

Switching between headset and C52SP while in a call

• From headset to C52SP: Press on the C52SP.

• From C52SP to headset: Press the call button with LED on the headset.

Ending calls

• On the A170/A150 Headset press the call button with LED.

• On the C52-SP press .

Adjusting the volume

• A150 Press the respective end of the volume key.:

• A170: Push the lever towards the + or - symbols.

• C52-SP: Press the upper or lower edge, respectively, of the volume key.

Muting and unmuting the microphone

• A150 Press the key labeled "MUTE".:

• A170: Press the key labeled "MUTE".

• C52-SP: Press .

Where to nd the user guides of the headsets A170 and A150 and the speakerphone C52-SP:

C52-SP: On page 50 of the C520 Wi-Mi user manual, available for download at

https://service.snom.com/display/wiki/Conference+Phones.

Headsets: Available for download at . https://service.snom.com/display/wiki/Headsets

Snom is a registered trademark of Snom Technology GmbH in the European Union, USA, Japan, China and certain other countries and regions.

Unless specied otherwise, all trademarks, in particular product names, are legally protected trademarks of Snom Technology GmbH. Other

mentioned trademarks or registered trademarks are the property of their respective manufacturers or owners. Product specications are

subject to change without notice. We do not accept liability for printing errors and mistakes. snom.com

Vol +

Vol –

Product specificaties

Merk:	Snom
Categorie:	Niet gecategoriseerd
Model:	A230
Kleur van het product:	Zwart
Certificering:	CE\nSafety EN 60950
Plug and play:	Ja
Merkcompatibiliteit:	snom
Power LED:	Ja
Compatibele producten:	D7XX\nD3XX\nA170\nC52 SP
Radiofrequentiebereik:	1880 - 1900 MHz