Skytronic 651.674 Handleiding

Skytronic Diversen 651.674

Lees hieronder de 📖 handleiding in het Nederlandse voor Skytronic 651.674 (19 pagina's) in de categorie Diversen. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/19

DC TO AC POWER INVERTERS

651.668 Invertor 1500W (12V-220V) HQ

651.671 Invertor 1500W (24V-220V) HQ

651.674 Invertor 2000W (12V-220V) HQ

651.677 Invertor 2000W (24V-220V) HQ

651.680 Invertor 3000W (12V-220V) HQ

651.683 Invertor 3000W (24V-220V) HQ

Instruction Manual

Gebruiksaanwijzing

Mode d’Emploi

Gebrauchsanleitung

Brugsanvisning

SKYTRONIC INVERTERS

An Inverter is an electronic device that converts low voltage DC (Direct Current) from a battery or other power

source to standard 230 Volts AC (Alternating Current) household power.

The Inverter converts power in two stages. The first stage is a DC to DC amplification which raises the low voltage

DC at the inverter input to 290 Volts DC. The second stage is the actual inverter stage which converts the high

voltage 290 Volts DC into 230 Volts AC.

The DC to DC stage uses a high frequency power conversion technique that eliminates the need for bulky

transformers found in more traditional inverters. The benefit of this is a significant reduction in size and weight.

The inverter stage uses advanced power MOSFET transistors in a full bridge configuration, which means that the

inverter has a much stronger load handling capability.

A power inverter converts DC power into conventional AC power which can run all kinds of household products

such as: kitchen appliances, microwaves, power tools, TVs, radios, computers and more. You just connect the

inverter to a battery, and plug your AC devices into the inverter and you've got power on the go.

The power inverter draws its power from a 12 Volt or 24 Volt battery, or several batteries wired in parallel. The

battery will need to be recharged as the inverter draws the power out of it. The battery recharges by running the

automobile motor, gas generator, solar panels, or wind and not with the power inverter. During blackouts, an

inverter can be used for emergency power by use with a car battery with the vehicle running and an extension cord

running into the house, where you can then plug in electrical appliances.

Using the SkyTronic 230V inverters

The SkyTronic range of inverters transform 12/24V battery voltage into 230V mains voltage, thus enabling you to

use your domestic equipment everywhere you want e.g. on camping, on a boat, in your car, etc. The regulated

output voltage makes the inverters suitable for use with sensitive devices such as TV sets, video and audio

devices, PCs or laptops and many more.

General features of SkyTronic inverters

• high performance at low heat production

• 50Hz stable output frequency

• regulated 230V output voltage

• protection against short circuit and overheating

• with SkyTronic battery protection system. If the battery voltage drops to 10.3V (21V for 24V batteries) the

inverter emits an alarm signal. If the battery voltage drops even further, the inverter shuts off automatically.

This advanced protection system avoids to over discharge the battery.

WARNING

SkyTronic inverters supply an output voltage of 230V which is as dangerous as the domestic mains voltage!

Therefore only use double-insulated devices and replace immediately leads that are in bad condition. Don’t expose

the inverters to humidity and place them in a well ventilated area. The inverters with an earth connector can be

connected to a grounding point such as a metal part of a boat or the car chassis.

Rechargeable Appliances:

CAUTION: Certain rechargeable devices are designed to be plugged directly into an AC socket to be recharged.

These devices may damage the devices or POWER INVERTER. When first using a rechargeable device, monitor

its temperature for 10 minutes to ensure that it does become abnormally hot. This abnormal heat indicated that the

device should not be used with this POWER INVERTER.

Important!

Under full load, high current is flowing through the battery cables. Therefore it is recommended to use only the

supplied cables and no extension cables in order to avoid unacceptable voltage losses. If necessary, use an

extension cord in the 230V circuit to the connected unit. To comply with the legal standards, the inverter may only

be used with the supplied low voltage cables. Do NOT extend them.

The connected battery must be in good condition and fully charged. After some time, it may be necessary to start

the car or boat in order to recharge the battery. At that moment, the inverter must be switched OFF beforehand in

order to avoid damage due to excessive battery voltage.

On/off switch

Connect the inverter to the battery (red is positive, black is negative). Make sure that all connections are of good

quality. First switch on the inverter and afterwards the unit to be powered. Switch off in reverse order.

Thermal protection

All SkyTronic inverters are protected against thermal overload. If the temperature of the inverter rises above 65°C,

the protection circuit is automatically activated and the unit is switched off. First switch off the connected unit and

then the inverter. Let the units cool down before you switch them on again. Check if the cooling fan is not

obstructed and make sure that there is sufficient air flow around the unit.

TROUBLESHOOTING

If you experience problems with appliances not operating correctly when there are two or more devices connected

to the same circuit, the only remedy is to disconnect one of the units to reduce the load. If the inverter overheats

when the load is at the rated maximum, try running the vehicle engine while running the inverter. (REMEMBER to

switch OFF the inverter when starting the engine.) This will boost the battery voltage allowing the inverter to

operate more efficiently, allowing use of the engine for longer periods of time in high load applications.

Audio Systems

Some inexpensive portable stereo systems will emit a buzzing noise through the speakers when operated by an

inverter. This is because the power supply in the stereo unit does not adequately filter the modified sine wave

produced by the inverter. The only solution is to use a stereo system with a more efficient power supply.

GENERAL SAFETY

1. Always operate the inverter from the correct power source, 12V or 24V battery ( As applicable).

2. When connecting the cables from the battery to the inverter observe the correct polarity, RED is positive ( + )

and BLACK is negative (-).

3. Ensure the DC input connections are secure, because a loose contact can result in excessive voltage drop and

can cause overheated wires and melted insulation.

4. Locate the inverter and power source (battery) away from any inflammables to avoid any possible fire or

explosion. NOTE. It is normal to experience sparks when connecting the positive terminal of the inverter from

the battery. This is due to the current flow charging the capacitors in the inverter.

5. Where applicable, always ground the inverter before operation to avoid possible shock.

6. Check that the power consumption of the appliance to be operated is compatible with the output capacity of the

inverter. Care should be taken with microwave ovens as the power quoted on the front panel is usually the

heating power and not the actual power drawn. For appliances with no power rating ( W or watts) shown then

the current rating ( A or Amps ) can be multiplied by 230 to give an approximate power rating.

7. The battery must be of adequate capacity (ampere-hour) to run the inverter at the power required. The

maximum current ratings for the various inverter models are’

12V-1500W = 156A 24V-1500W = 78A

12V-2000W = 208A 24V-2000W = 104A

12V-3000W = 312A 24V-3000W = 156A

Ampere-hour (Ah) capacity is a measure of how many amperes a battery can deliver for 20 hours, e.g. a

typical marine or RV battery rated @100Ah can deliver 5amps for 20hrs (5A x 20hrs = 100Ah)

8. In the event of a continuous audible alarm or automatic shut off, immediately switch off the inverter until the

problem has been identified and rectified.

9. Disconnect the inverter when not in use.

10. Do not expose the inverter to moisture or site near sources of heat and inflammable materials.

INSTALLATION

1. Install inverter in a cool, dry and well ventilated area away from any inflammable material.

2. Ensure the DC power cables are as short as possible (<2m ) and of suitable size to handle the current

required. This is to minimise any voltage drop when the inverter draws high currents. Remember solid, secure,

clean connections are essential for optimum performance.

3. Grounding. Connect the chassis ground lug ( where applicable ) to earth ground or car chassis using # 8 AWG

wire, preferably with green / yellow insulation.

4. Battery Type and Size. Make sure the battery has enough capacity to run the inverter at the power needed.

Inverters can be powered by normal car batteries but it is recommended to start the engine every 30 - 60

minutes and let it run for about 10minutes to recharge the battery. Remember to switch OFF the inverter. For

the larger inverters or where extended operating times are required, then Deep Cycle leisure or traction type

lead acid batteries are recommended as they are designed for deep discharge where they will be repeatedly

discharged and recharged. When sizing your battery it is better to have extra capacity as you will have more

reserve and the battery will not be discharged as deeply. To obtain sufficient battery capacity you may need to

use more than one battery. Two identical batteries can be connected in parallel (+) to (+) and (-) to (-) to double

the capacity.

CAUTION: Do not connect batteries of different makes or AMP- hour (Ah) rating. Connections to battery post

must be made with solid secure connectors that provide a reliable, low resistance connection. Clean terminals

regularly.

Product specificaties

Merk:	Skytronic
Categorie:	Diversen
Model:	651.674

Heb je hulp nodig?

Als je hulp nodig hebt met Skytronic 651.674 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Diversen Skytronic

Skytronic 651.542 Handleiding

8 Juni 2023

Skytronic 651.539 Handleiding

8 Juni 2023

Skytronic 651.671 Handleiding

8 Juni 2023

Skytronic 651.533 Handleiding

8 Juni 2023

Skytronic 651.536 Handleiding

8 Juni 2023

Skytronic 710.285 Handleiding

8 Juni 2023

Skytronic 651.674 Handleiding

8 Juni 2023

Skytronic 651.530 Handleiding

8 Juni 2023

Skytronic 651.548 Handleiding

8 Juni 2023

Handleiding Diversen

Nieuwste handleidingen voor Diversen

Fysic FHP-160 Handleiding

23 Oktober 2023

Fysic FC-18 Handleiding

23 Oktober 2023

Fysic FC35 Handleiding

23 Oktober 2023

Ideen Welt Led stekkerdoos verlichting 323043-G Handleiding

17 Oktober 2023

Ideen Welt Thermo koeltas Handleiding

17 Oktober 2023

Ideen Welt Massage MV-25 Handleiding

17 Oktober 2023

Ideen Welt LED sensor LX-LD-P300 Handleiding

17 Oktober 2023

Ideen Welt ZF6865 8 LED Camping lamp Handleiding

17 Oktober 2023

Ideen Welt Muis snoerloos Handleiding

17 Oktober 2023

Ideen Welt Koffer weegscaal Handleiding

17 Oktober 2023