Silvercrest SSSP 1500 A1 Handleiding

Silvercrest Statief SSSP 1500 A1

Lees hieronder de 📖 handleiding in het Nederlandse voor Silvercrest SSSP 1500 A1 (1 pagina's) in de categorie Statief. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Tripod Spider

SSSP 1500 A1 14_V1.0

•Thoroughly read these operating instructions prior to

initial commissioning.

•Above all, observe the safety instructions!

•The tripod should only be used as described in these

operating instructions.

•Keep these operating instructions for reference.

•If you pass the tripod on to someone else, please in-

clude these operating instructions.

1. Overview

2. Intended purpose

The tripod serves to fasten photo cameras, video cameras or other de-

vices with a 1/4-inch thread.

It is only intended for private use and not suited for commercial or in-

dustrial purposes.

3. Safety information

Warnings

If necessary, the following warnings will be used in these operating in-

structions:

DANGER! High risk: failure to observe this warning may result

in injury to life and limb.

WARNING! Moderate risk: failure to observe this warning may result

in injury or serious material damage.

CAUTION: low risk: failure to observe this warning may result in minor

injury or material damage.

NOTE: circumstances and specifics that must be observed when han-

dling the device.

DANGER for children

• Packing materials are not children's toys. Children should not be

allowed to play with the plastic bags: there is a risk of suffocation.

• This device is not designed to be used by people (including chil-

dren) with limited physical, sensory or mental capabilities or peo-

ple without adequate experience and/or understanding unless

they are supervised by someone responsible for their safety or are

instructed by them on how to use the device.

• Children must be supervised to ensure that they do not play with

the device.

• Keep the device out of the reach of children.

WARNING! Risk of material damage

• The tripod must always be positioned such that it is stable and se-

cure in order to be protected against toppling over or falling. En-

sure a safe position or a safe attachment of the camera.

• In order to protect your photo or film camera against damages

caused by falling, always make sure that

- the camera is firmly screwed to the quick shoe;

- the quick shoe is firmly connected to the tripod flat head;

- camera and lens do not weigh more than the admissible 1.5 kg.

• Do not use any astringent or abrasive cleaning agents.

4. Items supplied

1 tripod

1 set of operating instructions

5. Operation

Setup and alignment

1. Pull the legs of the tripod apart.

2. Bend the legs to set up the tripod on uneven ground.

Securing the camera

The camera is screwed onto a quick shoe. Thus, it is not necessary to

position and remove the camera by screwing it on or unscrewing it eve-

ry time you would like to take pictures with or sometimes without the

tripod.

1. Use thumb and index finger to press the buttons 2 to unlock the

quick shoe 1.

2. Remove the quick shoe 1.

3. Fold the small clamp on the lower side of the quick shoe 1 up and

screw the camera firmly in place

4. Use thumb and index finger to press the buttons 2 to unlock the

quick shoe and insert it again.

5. Release the buttons.

6. Check the tight fitting of the quick shoe within the tripod flat head

Settings at the tripod

Tilting upward/downward / turn by 360°

The tripod flat head 6 is connected to the base frame via a ball head 5.

Thus, you have achieved maximum freedom of movement for your set-

tings.

• In order to change the position of the camera, loosen the locking

screw 3 first. Move the camera into the desired direction. If fin-

ished, retighten the locking screw.

6. Cleaning and storage

WARNING! Risk of material damage

• Do not use any astringent or abrasive cleaning agents.

• Use a slightly moist cloth to clean the tripod. If necessary, you may

also put mild soapy water on the cloth.

• After cleaning, let the tripod dry.

7. Disposal

After the end of service life, the product is to be disposed of in a proper

and environmentally-compatible manner.

Packaging

When disposing of the packaging, make sure you comply with the en-

vironmental regulations applicable in your country.

8. Technical specifications

Subject to technical modification.

9. Warranty of the HOYER Handel

GmbH

Dear Customer,

your device is provided with a 3 year warranty starting with the pur-

chase date. In the event of product defects, you are entitled to statutory

rights against the vendor. These statutory rights are not restricted by our

warranty presented in the following.

Warranty conditions

The warranty period starts with the purchase date. Please keep the orig-

inal purchase receipt in a safe place. This document is required to verify

the purchase.

If within three years from the purchase date of this product a material

or factory defect occurs, the product will be repaired or replaced by us

– at our discretion – free of charge to you. This warranty implies that

within the period of three years the defective device and the purchase

receipt are presented, including a brief written description of the defect

and the time it occurred.

If the defect is covered by our warranty, the repaired or a new product

will be returned to you. No new warranty period starts with a repair or

replacement of the product.

Warranty period and statutory claims for defects

The warranty period is not extended when the warranty has been

claimed. This also applies to replaced and repaired parts. Any damag-

es and defects already existing at the time of purchase must be reported

immediately upon unpacking. Repairs arising after the expiration of the

warranty period are subject to a charge.

Warranty coverage

The device was produced carefully according to strict quality guidelines

and tested diligently prior to delivery.

The warranty applies to material or factory defects. This warranty does

not include product parts that are subject to standard wear and therefore

can be considered wear parts; the same applies to damages at fragile

parts, e.g. switches, rechargeable batteries or parts made of glass.

This warranty expires if the product is damaged, not used as intended or

not serviced. For the proper operation of the product, all instructions list-

ed in the operating instructions must be observed carefully. Any form of

use and handling that is advised against in the operating instructions or

warned against must always be avoided.

The product is only intended for private and not for commercial use. In

the case of incorrect and improper treatment, use of force and interven-

tions not performed by our authorised Service Centre, the warranty shall

cease.

Handling in case of a warranty claim

In order to ensure prompt processing of your matter, please observe the

following notes:

• Please keep the article number

IAN: 79653

and the purchase receipt

as a purchase verification for all inquiries.

• If faulty operation or other defects occur, first contact the Service

Centre listed in the following by telephone or email.

• Then, you are able to send a product reported as defective free of

charge to the service address specified to you, including the pur-

chase receipt and the information on the defect and when it oc-

curred.

Please visit www.lidl-service.com to download this and many

other manuals, product videos and software.

Service Centre

Service Great Britain

Tel.: 0871 5000 720 (£ 0.10/Min.)

E-Mail: hoyer@lidl.co.uk

Service Ireland

Tel.: 1890 930 034

(0,08 EUR/Min., (peak))

(0,06 EUR/Min., (off peak))

E-Mail: hoyer@lidl.ie

Service Cyprus

Tel.: 8009 4409

E-Mail: hoyer@lidl.com.cy

Service Malta

Tel.: 80062230

E-Mail: hoyer@lidl.com.mt

IAN: 79653

Supplier

Please note that the following address is no service address. First

contact the aforementioned Service Centre.

HOYER Handel GmbH

Kühnehöfe 5

22761 Hamburg

Germany

1Quick shoe

2Button unlocking the quick shoe

3Locking screw (movement of the head)

4Flexible legs (vertically adjustable by bending)

5Ball head

6Tripod flat head

7Thread

Model: SSSP 1500 A1

Height max: approx. 27 cm

Max. load with legs straight: 1.5 kg

Thread size: 6.35 mm / 1/4 inch

__Toz79653_A3.book Seite 3 Montag, 21. Oktober 2013 2:13 14

Product specificaties

Merk:	Silvercrest
Categorie:	Statief
Model:	SSSP 1500 A1

Heb je hulp nodig?

Als je hulp nodig hebt met Silvercrest SSSP 1500 A1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Statief Silvercrest

Silvercrest SSSP 1500 A1 Handleiding

10 Mei 2023

Silvercrest SDS 22 A1 Handleiding

6 Mei 2023

Silvercrest STS 8 A1 Handleiding

24 Maart 2023

Silvercrest SDS 3000 A1 Handleiding

15 Maart 2023

Silvercrest SSTS 1500 A1 Handleiding

7 Maart 2023

Silvercrest SFS 156 A1 Handleiding

14 Januari 2023

Silvercrest STS 8 B1 Handleiding

10 Januari 2023

Silvercrest SSD 3000 A1 Handleiding

11 November 2022

Handleiding Statief

Nieuwste handleidingen voor Statief

Rollei Traveler Handleiding

20 December 2024

Rollei Lion Rock Stativkopf 25 Handleiding

20 December 2024

Rollei Rock Solid Gamma Mark II Handleiding

20 December 2024

Rollei Universal L-Bracket Handleiding

20 December 2024

Axler CS-CF-30 Handleiding

19 December 2024

Axler CS-CPS-20A Handleiding

19 December 2024

Axler Robin 05R V2 Handleiding

19 December 2024

Axler Robin 20S Handleiding

19 December 2024

Axler FCS-1428 Handleiding

19 December 2024

Axler CS-CF-30LW Handleiding

19 December 2024