Shure WL183 Handleiding

Shure Microfoon WL183

Lees hieronder de 📖 handleiding in het Nederlandse voor Shure WL183 (2 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

Wireless Lavalier Microphone User Guide

WL183, WL184, AND WL185 LAVALIER MICROPHONES

GENERAL

Models WL183, WL184 and WL185 are lavalier electret condenser

microphones designed for use with a wireless bodypack transmitter. Each

microphone has a 1.2 meter (4 ft.) cable terminated with a miniature

Switchcraft TA4F connector. The furnished tie clip can be rotated in 90°

intervals for placement flexibility.

APPLICATIONS

WL183 (Omnidirectional): Recommended for general purpose

sound reinforcement, recording, or remote monitoring applications.

Low handling noise. Pickup angle is 360°.

WL184 (Supercardioid): Recommended for sound reinforcement ap-

plications requiring high rejection of ambient noise and narrow pickup

angle. Use of windscreen highly recommended. Pickup angle is 115°.

WL185 (Cardioid): Recommended for general purpose sound rein-

forcement applications requiring good rejection of ambient noise. Use

of windscreen highly recommended. Pickup angle is 130°.

INSTALLATION

1. Insert the top of the microphone through tie clip loop from below until

tie clip loop snaps into place over the lower groove on the micro-

phone. Refer to the following illustration.

2. To install the snap–fit windscreen, press it down on the microphone

until it clicks into place inside the upper groove on the microphone.

The snap–fit windscreen provides 30 dB of pop protection.

NOTE: The snap–fit windscreen can be removed by spreading the

slot in the plastic snap–fit ring.

To install the smaller foam windscreen, slip the windscreen over the

top of the microphone so that it covers the side slots.The foam wind-

screen provides 5 to 10 dB of pop protection.

TIE CLIP

WINDSCREEN

3. Attach the microphone approximately 76 mm to 152 mm (3 to 6 in.)

below the neckline.

NOTE: Do not cover the microphone with your hand or clothing.

CHANGING CARTRIDGES

The WL183, WL184, and WL185 microphones use interchangeable

cartridges. To remove the cartridge, unscrew the tip of the microphone

and remove it. Install the replacement cartridge by screwing it onto the

microphone base.

REPLACEMENT PARTS AND ACCESSORIES

Omnidirectional Cartridge R183B. . . . . . . . . . . . . . . . . . . . . . . . . .

Supercardioid Cartridge R184B. . . . . . . . . . . . . . . . . . . . . . . . . . .

Cardioid Cartridge R185B. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Snap–fit Windscreens (4) RK183BWS. . . . . . . . . . . . . . . . . . . . .

Foam Windscreen (4) RK261WS. . . . . . . . . . . . . . . . . . . . . . . . . .

Tie clips (2) RK183T1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Miniature 4-pin connector WA330. . . . . . . . . . . . . . . . . . . . . . . . .

SPECIFICATIONS

Type: Condenser (electret bias)

Frequency Response: 50 to 17,000 Hz

500 1,000 2,000 5,000 10,00050 100 20020

+10

–10

20,000

500 1,000 2,000 5,000 10,000 20,000

50 100 20020

+10

–10

500 1,000 2,000 5,000 10,000 20,000

50 100 20020

+10

–10

WL183 FREQUENCY RESPONSE

WL184 FREQUENCY RESPONSE

WL185 FREQUENCY RESPONSE

Polar Patterns (at 1 kHz):

–10 dB

–15 dB

–5 dB

–20 dB

–10 dB

–15 dB

–5 dB

–20 dB

–10 dB

–15 dB

–5 dB

–20 dB

CARDIOID

(WL185)

OMNIDIRECTIONAL

(WL183)

150o

120o

150o

120o

180o

30 o

60o

90o

30 o

60o

90o

150o

120o

150o

120o

180 o

30 o

60o

90o

30 o

90 o

SUPERCARDIOID

(WL184)

150o

120o

150o

120o

180 o

30 o

60o

90o

30 o

60o

90o

Output Impedance : 1800 Ω

Sensitivity (1 Pa = 94 dB SPL): WL183: –40.0 dBV/Pa

WL184: –44.5 dBV/Pa

WL185: –45.5 dBV/Pa

Maximum Sound Pressure Level: WL183: 125.0 dB SPL

WL184: 129.5 dB SPL

WL185: 130.5 dB SPL

Output Noise (A–weighted): WL183: 22.5 dB SPL

WL184: 27.0 dB SPL

WL185: 28.0 dB SPL

Dynamic Range: 102.5 dB

Polarity: Positive pressure on diaphragm produces positive voltage on

pins 3 and 4 relative to pin 1.

Power Requirements: Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc)

provided at microphone connector pin 2 relative to pin 1 of a Shure

wireless microphone transmitter.

NOTE: For additional technical assistance, phone Shure at (847)

866-2200. In Europe, phone 49-7131-72140.

CONDENSER

CARTRIDGE

IMPEDANCE CONVERTER

SHIELD

BLK

RED

D+ 4

MICROPHONE WIRING DIAGRAM

1 GROUND

2 BIAS

3,4 AUDIO

27B2833 (AA)

2001, Shure Incorporated Printed in U.S.A

Wireless Lavalier Microphone User Guide

WL93, WL93T, WL93–6, WL93–6T LAVALIER MICROPHONES

GENERAL

Model WL93 Microphones are omnidirectional, subminiature, lavalier

electret condenser microphones designed for use in TV broadcasting,

theater, and sound reinforcement applications where a visually unob-

trusive microphone is desirable.

All WL93 models are supplied with a mounting block with attached tie

bar, a sew-on mounting bracket, and an acoustic windscreen to mini-

mize wind noise in outdoor applications. All WL93 models include a 1.2

m (4 ft.) cable terminated with a miniature 4-pin connector (Switchcraft

TA4F type) which connects directly to a Shure wireless body-pack

transmitter.

VARIATIONS

WL93: Black finish; includes 1.2 m (4 ft. cable)

WL93T: Tan finish; includes 1.2 m (4 ft. cable)

WL93–6: Black finish; includes 1.9 m (6 ft. cable)

WL93–6T: Tan finish; includes 1.9 m (6 ft. cable)

INSTALLATION

1. To mount a WL93 to the tie clip, snap the microphone into the

mounting bracket and attach the clip to an article of clothing.

2. To install the foam windscreen, slip the it over the top of the micro-

phone. The foam windscreen provides 5 to 10 dB of pop protection.

WL93 MOUNTING

TIE CLIP

FOAM WINDSCREEN

REPLACEMENT PARTS AND ACCESSORIES

Windscreen, Charcoal Gray RK355WS. . . . . . . . . . . . . . . . . . . . . . . . .

Tie Clip, Black (2 each) RK354SB. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Tan Windscreen RK304T. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Double Tie Clip RK307DB. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Tan Tie Clip Assembly 90B4327. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Black Sew-on Mounting Bracket 65B1733. . . . . . . . . . . . . . . . . . . . . .

Tan Sew-on Mounting Bracket 65B1733A. . . . . . . . . . . . . . . . . . . . . .

Zippered Carrying Bag 26A13. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

SPECIFICATIONS

Type: Condenser (electret bias)

Frequency Response: 50 to 20,000 Hz

500 1,000 2,000 5,000 10,000 20,00050 100 20020

+10

–10

WL93 FREQUENCY RESPONSE

FREQUENCY IN Hz

RELATIVE RESPONSE IN dB

Polar Pattern: Omnidirectional, uniform with frequency

Output Impedance: 3000 Ω

Sensitivity (1 Pa = 94 dB SPL): –38 dBV/Pa

Maximum Sound Pressure Level: 120 dB SPL

Dynamic Range: 102 dB

Output Noise (A–weighted): 18 dB SPL

Polarity: Positive pressure on microphone diaphragm produces posi-

tive voltage on pin 3 with respect to pin 1 (ground)

Power Requirements: Regulated nominal +5 Vdc (2 Vdc to 10 Vdc)

source provided at microphone connector pin 2 relative to pin 1 of a

Shure wireless body-pack transmitter.

NOTE: For additional technical assistance, phone Shure at

1-800-516-2525. In Europe, phone 49-7131-72140.

MICROPHONE WIRING DIAGRAM

CONDENSER

CARTRIDGE

IMPEDANCE

CONVERTER

SHIELD

BLK

RED

D+ 4

27B2833 (AA)

2001, Shure Incorporated Printed in U.S.A

SHURE Incorporated Web Address: http://www.shure.com

222 Hartrey Avenue, Evanston, IL 60202–3696, U.S.A.

Phone: 847-866–2200 Fax: 847-866-2279

In Europe, Phone: 49-7131-72140 Fax: 49-7131-721414

In Asia, Phone: 852-2893-4290 Fax: 852-2893-4055

Elsewhere, Phone: 847-866–2200 Fax: 847-866-2585

Product specificaties

Merk:	Shure
Categorie:	Microfoon
Model:	WL183
Kleur van het product:	Zwart
Soort:	Microfoon voor studio's
Connectiviteitstechnologie:	Bedraad
Aansluiting:	XLR-3
Microphone direction type:	Omnidirectioneel
Gevoeligheid microfoon:	-40 dB
Frequentie microfoon:	50 - 17000 Hz
Aantal producten inbegrepen:	1 stuk(s)