Shure PGA 52 Handleiding

Shure Microfoon PGA 52

Lees hieronder de 📖 handleiding in het Nederlandse voor Shure PGA 52 (4 pagina's) in de categorie Microfoon. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
© 2015 Shure Incorporated
27A24477 (Rev. 3)
WIRED MICROPHONE
PGA 52
USER GUIDE
PG ALTA SERIES
TM
2
PGA52
Applications and Placement
The following table lists the most common applications and
placement techniques. Keep in mind that microphone technique
is largely a matter of personal taste; there is no one "correct"
microphone position.
Application Suggested Microphone
Placement
Tone Quality
Kick Drum 5 to 7.5 cm (2 to 3 in.)
away from beater head,
slightly off-center from
beater.
Sharp attack;
maximum bass
sound, highest
sound pressure
level.
20 to 30 cm (8 to 12 in.)
from beater head, on-
axis with beater.
Medium attack;
balanced sound.
NOTE: To create
a tighter sound
with more “punch,”
place a pillow or
blanket on bottom
of the drum
against the beater
head.
Guitar & Bass
Amplifiers
2.5 cm (1 in.) from
speaker, on-axis with
center of speaker cone.
Sharp attack;
emphasized bass.
2.5 cm (1 in.) from
speaker, at edge of
speaker cone.
Sharp attack;
higher frequency
sound.
60 to 90 cm (2 to 3 ft.)
back from speaker, on-
axis with speaker cone.
Softer attack;
reduced bass.
Avoiding Pickup of Unwanted Sound
Sources
Place the microphone so that unwanted sound sources, such as
monitors and loudspeakers, are directly behind it. To minimize
feedback and ensure optimum rejection of unwanted sound,
always test microphone placement before a performance.
MONITOR
P.A. LOUDSPEAKER
Recommended Loudspeaker Locations for Cardioid
Microphones
PG Alta Microphones
Congratulations on the purchase of a new Shure PG Alta series
microphone. The PG Alta series delivers professional quality
audio at an affordable price, with solutions for capturing nearly
any source, including voice, acoustic instruments, drums,
and amplified electric instruments. Suitable for live and studio
applications, PG Alta microphones are built to last, and meet
the same rigorous quality testing standards that make all Shure
products trustworthy and reliable.
General Rules for Use
Aim the microphone toward the desired sound source (such as
an instrument or amplifier) and away from unwanted sources.
Place the microphone as close as practical to the desired
sound source.
Work close to the microphone for extra bass response.
For better gain before feedback, use fewer microphones.
If the kick drum head has a hole cut in it, place the microphone
inside for improved rejection of unwanted sources.
Keep the distance between microphones at least three times
the distance from each microphone to its source (“three to one
rule”).
Place microphones as far as possible from reflective surfaces.
Avoid excessive handling to minimize pickup of mechanical
noise and vibration.
Proximity Effect
Directional microphones progressively boost bass frequencies as
the microphone is placed in closer proximity to the source. This
phenomenon, known as proximity effect, can be used to create a
warmer, more powerful sound.
Optional Accessories and
Replacement Parts
7.6 m (25 ft.) Cable (XLR-XLR) C25J
5/8" to 3/8" Thread Adapter 31A1856
Vinyl zippered storage bag 95B2324
Drum Microphone Mount AP56DM
Grille RPMP52G
PGA52 Replacement Grille RPM154
3
Using the Quick-Release Lever
This microphone features a quick-release lever to easily
adjust position.
1. Pull the lever open
2. Move the microphone into the desired position
3. Press the lever back towards the microphone to tighten
1
2
3
Note: To adjust the
tension on the lever,
pull it open and use a
flat head screwdriver
to tighten or loosen
the bolt on the
opposite side.
Specifications
Type
Dynamic (moving coil)
Frequency Response
50 to 12,000 Hz
Polar Pattern
Cardioid
Output Impedance
150 Ω
Sensitivity
at 1 kHz, open circuit voltage
-55 dBV/Pa¹ (1.75 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on pin 2
with respect to pin 3
Weight
454 g (16.01oz.)
Connector
Three-pin professional audio (XLR), male
Environmental Conditions
Operating Temperature -20° to 165°F (-29° to 74°C)
Relative Humidity 0 to 95%
1 Pa=94 dB SPL
Certifications
This product meets the Essential Requirements of all relevant
European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: info@shure.de
20
15
10
5
0
-30
-25
-20
-15
-10
-5
dB
Hz
20 100 1k 10k 20k
0,6 m (2 ft.) from sound source
Typical Frequency Response
1000 Hz
Typical Polar Pattern
108 mm (4.26 in.)
67.0 mm diameter
(2.64 in.)
Overall Dimensions


Product specificaties

Merk: Shure
Categorie: Microfoon
Model: PGA 52

Heb je hulp nodig?

Als je hulp nodig hebt met Shure PGA 52 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Microfoon Shure

Handleiding Microfoon

Nieuwste handleidingen voor Microfoon

Neumann

Neumann KM 56 Handleiding

2 December 2024
Vimar

Vimar 19586.B Handleiding

1 December 2024
Vimar

Vimar 19586 Handleiding

1 December 2024
Vimar

Vimar 20586.N Handleiding

30 November 2024
Vimar

Vimar 20586.B Handleiding

30 November 2024
Vimar

Vimar 19586.M Handleiding

30 November 2024
Vimar

Vimar 20586 Handleiding

30 November 2024
HyperX

HyperX SoloCast Handleiding

30 November 2024
Polsen

Polsen XP-2 Handleiding

25 November 2024