SereneLife PSLERK4 Handleiding

SereneLife Ongediertebestrijder PSLERK4

Lees hieronder de 📖 handleiding in het Nederlandse voor SereneLife PSLERK4 (2 pagina's) in de categorie Ongediertebestrijder. Deze handleiding was nuttig voor 53 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

1. Features & Functions:

1) Delivers high voltage electronic shock to kill rat, nonpoisonous, safe and reliable.

2) Set with safety protection switch, in order to prevent mistake electric shock to person.

3) Use micro-electronic circuit technology for product design, low power consumption, suitable for long life operation.

4) Low battery indication.

2. Application:

This unit widely applies in dining-room, cookroom, bedroom, oce, hotel and any places that rats usually appear.

3. Directions for use:

1) Step #1: Using a plastic or wooden knife, insert a small amount of peanut butter (or any food that rats prefer) through a bottom hole on the back

plate.

2) Step #2: Insert 4”C” batteries into battery compartment or use the adapter DC-6V

3) Step #3: Identify location with rat activity look for worn trails or walkways. Place unit on oor against wall, the entrance in-line with the trail; rats

prefer to travel against a wall.

4) Step #4: Press switch to “On” position. Unit will hum, and the green light will ash, then the red light will ash every 5 seconds, indicating that

the unit has been enabled. To prevent incidental shock avoid contact with metal plates. Do not touch the bottom of the machin e.

STEP 1 STEP 2 STEP 3 STEP 4

Clean:

STEP 5 STEP 6

4. Note Items for Use:

1) The rat triggers metal plates when rodent enter the unit, and the unit emits high voltage sock immediately, the red light ashes. High voltage

produced time is 4 minutes. Firstly it delivers high voltage last for 1 minute, later impulse electric-shock which imitating rat heartbeat 15HZ for each

time and it continues for 3 minutes, then the high voltage shock stops, the light turns from red to green and ashes once every 5 seconds, here high

voltage shock will not be produced until restarting the unit next time.

2) Every after killing the rat, press switch to “OFF” position (O) and remove case of the unit to clean the chamber, dry it under the sun, then it can be

reinstalled to use. (Use cleaning agent to clean out the smell that the rat remained, or rats may not come again). How to clean it is showed in STEP5 and

STEP 6.