Scott CX 82 Sola Handleiding

Scott Radio CX 82 Sola

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Scott CX 82 Sola (4 pagina's) in de categorie Radio. Deze handleiding was nuttig voor 49 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Instruction Manual
Dual Alarm Clock Radio with
Digital Display
CX 82
PACKAGE INCLUDES:
1. The unit 2. Instruction manual
LOCATION OF CONTROLS
234
5 6 7
8
91012
1. button ALARM/SLEEP OFF
2. buttonALARM
3. buttonTIME
4. buttonSNOOZE
5. FAST button
6. buttonSLOW
7. button SLEEP
8. switchALARM 1/1+2/2
9. knobTUNING
10. LED display
11. knobVOLUME/OFF BUZZER
12. ON/OFF/AUTO switch
13. Clock back up battery cover
14. FM antenna wire and AC power cord
INSTALLING BATTERIES
Installing the clock back up battery
Clock back up
The clock and alarm time can be maintained during a power failure with a 9V β€œ6F22” battery (not
supplied). During power failures, the clock time may gain or lose a few minutes per hour and may
require resetting.
Battery insertion
1. Remove the battery cover on the bottom of the unit, by pressing the top edge.
2. Insert a 9V β€œ6F22” battery (an alkaline battery is recommended) into the battery compartment,
following the correct polarities marked inside the battery compartment.
3. Replace the battery cover.
Note: For optimum performance, the battery should be replaced every 6 months.
Precautions when using batteries
1. Use only the size and type of battery speciξ‚Ώed.
2. Ensure you follow the correct polarities when installing the battery, as indicated in the battery
compartment. A reversed battery may damage the unit.
3. An exhausted battery must be removed to prevent possible battery leakage.
4. Dispose of batteries properly according to environmental regulations.
Notes on clock back up battery
Please note that this unit will not operate fully by battery power alone. The battery provides a back up
system only in the event of an interruption of the AC power supply.
GB-1
CR38 SCOTT CX82 GB IM.indd 1 7/13/2009 5:34:59 PM
PRECAUTIONS
Follow the advice below for safe and appropriate operations.
INSTALLATION
β€’ Do not use the unit in places which are extremely hot, cold, dusty, or humid.
β€’ Place the unit on a ξ€€at and even surface.
β€’ Do not restrict the airξ€€ow of the unit by placing it in a place with poor airξ€€ow, by covering it with a
cloth, or by placing it on a carpet.
SAFETY
β€’ When connecting and disconnecting the AC power cord from the AC mains outlet, pull the plug
and not the cord itself. Pulling the cord may damage it and may be dangerous.
β€’ The mains plug must remain readily operable.
β€’ When you are not going to use the unit for a long period of time, disconnect the AC power cord
from the AC mains outlet.
AC VOLTAGE
β€’ Before use, check that the rated voltage of your unit matches your local voltage.
CONDENSATION
β€’ When there is condensation inside the unit, the unit may not function normally.
β€’ Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the
unit before use.
β€’ Ensure a minimum distance of 5 cm around the apparatus for sufξ€€cient ventilation.
β€’ Ensure that the ventilation is not impeded by covering the ventilation openings with items such as
newspapers, tablecloths, curtains, etc.
β€’ Do not place naked ξ€€ame sources such as lighted candles on the apparatus.
β€’ Pay attention to the environmental aspects of battery disposal.
β€’ Use the apparatus only in moderate climates (not in tropical climates).
β€’ Do not expose the apparatus to dripping or splashing.
β€’ Do not place objects ξ€€lled with liquids, such as vases, on the apparatus.
β€’ Mains plug is used as the disconnect device. It shall remain readily operable and should not be
obstructed during intended use. To be completely disconnected the apparatus from supply mains,
the mains plug of the apparatus shall be disconnected from the mains socket outlet completely.
ATT ENTI ON: To reduce the risk of electric
shock, do not remove the cover. There are no
user serviceable parts inside the unit. Refer all
servicing to qualiξ€€ed personnel.
The exclamation mark within
a triangle is a warning sign
alerting the user to the pres-
ence of important instructions
accompanying the product.
The lightning ξ€€ash with an
arrowhead symbol within
a triangle is a warning sign
alertin g the user to the
presence of "dangerous
voltage" inside the unit.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
GB-2
In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting it from
mains supply.
The marking plate is located on the bottom enclosure.
CR38 SCOTT CX82 GB IM.indd 2 7/13/2009 5:34:59 PM
GB-3
OPERATING INSTRUCTIONS
Connecting the power supply
Insert the AC power cord into the AC mains outlet with a 230V AC ~ 50Hz power source. The LED
display will ash.
Clock setting
1. Press and hold down the and TIME FAST buttons to set the clock quickly.
2. Press and hold down the button and press the button repeatedly to set the clock TIME SLOW
precisely, minute by minute.
Alarm operation
The unit allows you to wake up to the buzzer or radio.
Set the alarm time 1
1. Adjust the switch to . The alarm ON/OFF/AUTO AUTO
indicator(s) will light up.
2. Adjust the switch to . The LED ALARM 1/1+2/2 1 AL1
indicator will light up.
3. Press and hold down the and ALARM FAST buttons to set the alarm time 1 quickly.
4. Press and hold down the button and press the button repeatedly to set the alarm ALARM SLOW
time 1 precisely.
Set the alarm time 2
Follow the same steps in the section β€œ ”, but Set the alarm time 1
adjust the switch to the 2 position. The LED ALARM 1/1+2/2 AL2
indicator will light up.
Wake to Buzzer
1. Turn the knob to β€œ ” until a click sound is heard.VOLUME/OFF BUZZER BUZZ
2. Adjust the switch to . The alarm indicator(s) will light up.ON/OFF/AUTO AUTO
3. Adjust the switch to select alarm 1, 2 or both (1+2). The corresponding alarm ALARM 1/1+2/2
indicators will light up on the LED display.
4. When the preset alarm time is reached, the buzzer will sound.
5. To stop the alarm, press the ALARM/SLEEP OFF button. The alarm will sound again the next
day at the same time.
Wake to Radio
Turn on and adjust the volume to desired level using the VOLUME/OFF BUZZER knob and follow steps
(2) to (5) in the section β€œ ” for alarm operation.Wake to Buzzer
Snooze function
When the alarm sounds, press the SNOOZE button to stop the alarm temporarily and it will sound again
after 7 minutes. To cancel the SNOOZE function, press the ALARM/SLEEP OFF button. The alarm will
sound again the next day at the same time.
CR38 SCOTT CX82 GB IM.indd 3 7/13/2009 5:34:59 PM


Product specificaties

Merk: Scott
Categorie: Radio
Model: CX 82 Sola
Kleur van het product: Grijs
Gewicht: 198 g
GeΓ―ntegreerde klok: Ja
Stroomvoorziening: AC 230V ~ 50Hz
Beeldschermdiagonaal: 0.9 "
Accu/Batterij voltage: 9 V
Snooze functie: Ja
Ingebouwde luidsprekers: Ja
Soort tuner: Analoog
Backlight-kleur: Blauw
Ondersteunde frequentiebanden: FM
Radio: Klok
Afmetingen (B x D x H): 720 x 187 x 65 mm
Slaaptimer: Ja
Type beeldscherm: LED

Heb je hulp nodig?

Als je hulp nodig hebt met Scott CX 82 Sola stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Radio Scott

Handleiding Radio

Nieuwste handleidingen voor Radio