Satel INT-KWRL2 Handleiding

Satel Detector INT-KWRL2

Lees hieronder de 📖 handleiding in het Nederlandse voor Satel INT-KWRL2 (16 pagina's) in de categorie Detector. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/16

INT-KWRL2

Wireless keypad

Firmware version 3 int-kwrl2_ 03/ .00 en 21

SATEL sp. z o.o. ul. Budowlanych 66 - POLAND • • 80 298 Gdańsk •

tel. +48 58 320 94 00

www.satel. eu

IMPORTANT

The device should be installed by qualied personnel.

Read carefully this manual before proceeding to installation.

Changes, modications or repairs not authorized by the manufacturer shall void your rights

under the warranty.

The name plate of the device is located on the enclosure base.

SATEL aims to continually improve the quality of its products, which may result in changes in

their technical specications and software. Current information about the changes being

introduced is available on our website.

Please visit us at:

https://support.satel.eu

Hereby, SATEL sp. z o.o. declares that the radio equipment type INT-KWRL2 is in

compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity

is available at the following internet address: www.satel.eu/ce

In the EU, th radio equipment is only permitted to operate in the 868 MHz frequency is

band.

The following symbols may be used in this manual:

- note,

- caution.

The INT-KWRL2 wireless keypad enables operation and programming of the INTEGRA and

INTEGRA Plus control panels with firmware version 1.19 (or newer). The device is designed

for work within the ABAX 2 / ABAX two-way wireless system. This manual applies to the

keypad with rmware version 3.00 (or newer), which is supported by:

 2: ACU-220 / ACU-280 controller, ABAX

 ABAX: ACU-120 / ACU-270 controller (rmware version 5.04 or newer).

The ABAX 2 / ABAX controller must be connected to the expander bus (controller

terminals CKE and DTE) and the keypad bus (controller terminals CKM and DTM)

of the INTEGRA / INTEGRA Plus alarm control panel.

In the ACU-220 / ACU-280 controller, switches 9 and 10 must be set in OFF position.

In the ACU-120 / ACU-270 controller, switch 8 must be set in OFF position.

The keypad is not supported by the ARU-100 and ARU-200 radio signal repeaters or

by the INTEGRA 128-WRL control panel.

Fig. 1. INT-KWRL2 keypad.

Product specificaties

Merk:	Satel
Categorie:	Detector
Model:	INT-KWRL2
Kleur van het product:	Zwart
Gewicht:	374 g
Breedte:	145 mm
Diepte:	143 mm
Hoogte:	25 mm
Accu/Batterij voltage:	3 V
Ondersteund aantal accu's/batterijen:	2
Aantal per verpakking:	1 stuk(s)
Merkcompatibiliteit:	Satel
Soort apparaat:	Beveiligingsalarmsysteem
Frequentie:	868-868.6 MHz
Type product:	Toetsenblok