Sanyo PLV-Z3000 Handleiding

Sanyo Beamer PLV-Z3000

Lees hieronder de 📖 handleiding in het Nederlandse voor Sanyo PLV-Z3000 (15 pagina's) in de categorie Beamer. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/15

Multimedia P ojectorr

MODEL PLV-Z3000

Owner’s Manual

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER (OR

BACK). NO USER-SERVICEABLE PARTS

INSIDE EXCEPT LAMP REPLACEMENT.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS

VOLTAGE CONSTITUTING A RISK OF ELECTRIC

SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE

IMPORTANT OPERATING AND MAINTENANCE

INSTRUCTIONS IN THE OWNER’S MANUAL WITH

THIS UNIT.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Before operating this projector, read this manual thoroughly

and operate the projector properly.

This projector provides many convenient features and

functions. Operating the projector properly enables you to

manage those features and maintain it in good condition for

many years to come.

Improper operation may result in not only shortening the

product life, but also malfunctions, fire hazard, or other

accidents.

If your projector seems to operate improperly, read this

manual again, check operations and cable connections, and

try the solutions in the “Troubleshooting” section in the back

of this manual. If the problem still persists, contact the dealer

where you purchased the projector or the service center.

Safety Precaution

TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

– This projector produces intense light from the projection

lens. Avoid staring directly into the lens as much as possible,

otherwise eye damage could result. Be especially careful

that children do not stare directly into the beam.

– Install the projector in a proper position. Otherwise it may

result in fire hazard.

– Allowing the proper amount of space on the top, sides,

and rear of the projector cabinet is critical for proper air

circulation and cooling of the unit. The dimensions shown

here indicate the minimum space required. If the projector

is to be built into a compartment or similarly enclosed, these

minimum distances must be maintained.

– Do not cover the ventilation slot on the projector. Heat build-

up can reduce the service life of your projector, and can also

be dangerous.

– If the projector is unused for an extended time, unplug the

projector from the power outlet.

1.5' (50 cm)

3' (1 m) 1.5' (50 cm) 1.5' (50 cm)

SIDE and TOP REAR

READ AND KEEP THIS OWNER’S MANUAL FOR LATER

USE.

NOTE: This symbol and recycle system are applied to EU

countries only and not to the countries in the other area

of the world.

Your SANYO product is designed and

manufactured with high quality materials

and components which can be recycled

and reused.

This symbol means that electrical and

electronic equipment, at their end-of-life,

should be disposed of separately from

your household waste.

Please dispose of this equipment at your

local community waste collection/recycling centre.

In the European Union there are separate collection

systems for used electrical and electronic products.

Please help us to conserve the environment we live in!

CAUTION ON HANGING FROM THE CEILING

When hanging the projector from the

ceiling, clean the air intake vents, air filters,

and the top of the projector periodically

with a vacuum cleaner. If you leave the

projector unclean for a long time, the

cooling fans can be clogged with dust, and

it may cause a breakdown or a disaster.

DO NOT SET THE PROJECTOR IN GREASY, WET,

OR SMOKY CONDITIONS SUCH AS IN A KITCHEN

TO PREVENT A BREAKDOWN OR DISASTER. IF THE

PROJECTOR COMES IN CONTACT WITH OIL OR

CHEMICALS, IT MAY BECOME DETERIORATED.

To the Owner

CAUTION

Not for use in a computer room as defined in the

Standard for the Protection of Electronic Computer/Data

Processing Equipment, ANSI/NFPA 75.

Ne peut être utilisé dans une salle d’ordinateurs telle

que définie dans la norme ANSI/NFPA 75 Standard for

Protection of Electronic Computer/Data Processing

Equipment.

WARNING: THIS APPARATUS MUST BE EARTHED.

All the safety and operating instructions should be read before

the product is operated.

Read all of the instructions given here and retain them for

later use. Unplug this projector from AC power supply before

cleaning. Do not use liquid or aerosol cleaners. Use a damp

cloth for cleaning.

Follow all warnings and instructions marked on the projector.

For added protection to the projector during lightning storm, or

when it is left unattended and unused for long periods of time,

unplug it from the wall outlet. This will prevent damage due to

lightning and power line surges.

Do not expose this unit to rain or use near water... for

example, in a wet basement, near a swimming pool, etc...

Do not use attachments not recommended by the

manufacturer as they may cause hazards.

Do not place this projector on an unstable cart, stand, or

table. The projector may fall, causing serious injury to a child

or adult, and serious damage to the projector. Use only with

a cart or stand recommended by the manufacturer, or sold

with the projector. Wall or shelf mounting should follow the

manufacturer’s instructions, and should use a mounting kit

approved by the manufacturers.

An appliance and cart combination

should be moved with care. Quick stops,

excessive force, and uneven surfaces

may cause the appliance and cart

combination to overturn.

Slots and openings in the back and bottom of the cabinet are

provided for ventilation, to ensure reliable operation of the

equipment and to protect it from overheating.

The openings should never be covered with cloth or other

materials, and the bottom opening should not be blocked

by placing the projector on a bed, sofa, rug, or other similar

surface. This projector should never be placed near or over a

radiator or heat register.

This projector should not be placed in a built-in installation

such as a bookcase unless proper ventilation is provided.

Never push objects of any kind into this projector through

cabinet slots as they may touch dangerous voltage points

or short out parts that could result in a fire or electric shock.

Never spill liquid of any kind on the projector.

Do not install the projector near the ventilation duct of air-

conditioning equipment.

This projector should be operated only from the type of power

source indicated on the marking label. If you are not sure of

the type of power supplied, consult your authorized dealer or

local power company.

Do not overload wall outlets and extension cords as this can

result in fire or electric shock. Do not allow anything to rest on

the power cord. Do not locate this projector where the cord

may be damaged by persons walking on it.

Do not attempt to service this projector yourself as opening

or removing covers may expose you to dangerous voltage

or other hazards. Refer all servicing to qualified service

personnel.

Unplug this projector from wall outlet and refer servicing to

qualified service personnel under the following conditions:

a. When the power cord or plug is damaged or frayed.

b. If liquid has been spilled into the projector.

c. If the projector has been exposed to rain or water.

d. If the projector does not operate normally by following

the operating instructions. Adjust only those controls that

are covered by the operating instructions as improper

adjustment of other controls may result in damage and will

often require extensive work by a qualified technician to

restore the projector to normal operation.

e. If the projector has been dropped or the cabinet has been

damaged.

f. When the projector exhibits a distinct change in

performance, this indicates a need for service.

When replacement parts are required, be sure the service

technician has used replacement parts specified by the

manufacturer that have the same characteristics as the original

part. Unauthorized substitutions may result in fire, electric

shock, or injury to persons.

Upon completion of any service or repairs to this projector,

ask the service technician to perform routine safety checks to

determine that the projector is in safe operating condition.

Safety Instructions

Product specificaties

Merk:	Sanyo
Categorie:	Beamer
Model:	PLV-Z3000
Gewicht:	7500 g
Geluidsniveau:	19 dB
Soort lamp:	UHP
Projector helderheid:	1200 ANSI lumens
Projectietechnologie:	LCD
Geschikt voor schermmaten:	40 - 300 "
Frequentiebereik horizontaal:	15 - 80 kHz
Frequentiebereik verticaal:	50 - 100 Hz
Matrix grootte:	0.7 "
VGA (D-Sub)poort(en):	1
Aantal HDMI-poorten:	1
Soort serieële aansluiting:	RS-232
Composiet video-ingang:	1
Componentingang video (YPbPr/YCbCr):	3
S-Video ingang:	1
Focus:	Handmatig
Brandpuntbereik:	22.3 - 45.3 mm
Levensduur van de lichtbron:	2000 uur
Type lichtbron:	Lamp
RS-232 port:	1
Lampvermogen:	165 W
Beeldverhouding:	16:9
Levensduur van de lichtbron (besparingsmodus):	3000 uur
Dot clock scanfrequentie:	100 MHz
Eenvormigheid:	85 procent
Afmetingen (B x D x H):	400 x 146 x 346 mm