Sanyo PLV-80 Handleiding

Sanyo Beamer PLV-80

Lees hieronder de 📖 handleiding in het Nederlandse voor Sanyo PLV-80 (60 pagina's) in de categorie Beamer. Deze handleiding was nuttig voor 49 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/60

Multimedia Projector

MODEL PLV-75/PLV-80

PLV75L/PLV-80L (Lensless)

Owner’s Manual

CAUTION : TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE COVER (OR

BACK). NO USER-SERVICEABLE PARTS

INSIDE EXCEPT LAMP REPLACEMENT.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS

VOLTAGE CONSTITUTING A RISK OF ELECTRIC

SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE

IMPORTANT OPERATING AND MAINTENANCE

INSTRUCTIONS IN THE OWNER’S MANUAL WITH

THIS UNIT.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

Before operating this projector, read this manual thoroughly

and operate the projector properly.

This projector provides many convenient features and

functions. Operating the projector properly enables you to

manage those features and maintain it in better condition for a

considerable time.

Improper operation may result in not only shortening the

product life, but also malfunctions, fire hazard, or other

accidents.

If your projector seems to operate improperly, read this

manual again, check operations and cable connections and try

the solutions in the “Troubleshooting” section in the end of this

booklet. If the problem still persists, contact the dealer where

you purchased the projector or the service center.

Safety Precaution

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPLIANCE

TO RAIN OR MOISTURE.

– This projector produces intense light from the projection

lens. Do not stare directly into the lens as much as

possible. Eye damage could result. Be especially careful

that children do not stare directly into the beam.

– Install the projector in a proper position. If not, it may result

in a fire hazard.

– Provide appropriate space on the top, sides and rear of the

projector cabinet for allowing air circulation and cooling the

projector. Minimum clearances must be maintained. If the

projector is to be built into a compartment or similarly

enclosed, the minimum distances must be maintained. Do

not cover the ventilation slot on the projector. Heat build-up

can reduce the service life of your projector, and can also

be dangerous.

– If the projector is not to be used for an extended time,

unplug the projector from the power outlet.

CAUTION

Not for use in a computer room as defined in the Standard for

the Protection of Electronic Computer/Data Processing

Equipment, ANSI/NFPA 75.

Ne peut être utilisé dans une salle d’ordinateurs telle que

définie dans la norme ANSI/NFPA 75 Standard for Protection

of Electronic Computer/Data Processing Equipment.

NOTE: This symbol mark and recycle system are applied only

to EU countries and not applied to the countries in the

other area of the world.

Your SANYO product is designed and

manufactured with high quality materials

and components which can be recycled

and reused.

This symbol means that electrical and

electronic equipment, at their end-of-life,

should be disposed of separately from

your household waste.

Please dispose of this equipment at your local community

waste collection/recycling centre.

In the European Union there are separate collection sys-

tems for used electrical and electronic products.

Please help us to conserve the environment we live in!

CAUTION ON HANGING FROM THE CEILING

When hanging the projector from the ceiling,

clean the air intake vents, air filters, and top

of the projector periodically with a vacuum

cleaner. If you leave the projector without

cleaning for a long time, the dust will block the

operation of the cooling function, and it may

cause a breakdown or a disaster.

DO NOT SET THE PROJECTOR IN GREASY, WET, OR

SMOKY CONDITIONS SUCH AS IN A KITCHEN TO PREVENT

A BREAKDOWN OR A DISASTER. IF THE PROJECTOR

COMES IN CONTACT WITH OIL OR CHEMICALS, IT MAY

BECOME DETERIORATED.

READ AND KEEP THIS OWNER'S MANUAL FOR LATER

USE.

TO THE OWNER

3.3' (1m)

3.3' (1m) 3.3' (1m) 3.3' (1m)

SIDE and TOP REAR

SAFETY INSTRUCTIONS

All the safety and operating instructions should be read before

the product is operated.

Read all of the instructions given here and retain them for later

use. Unplug this projector from AC power supply before

cleaning. Do not use liquid or aerosol cleaners. Use a damp

cloth for cleaning.

Follow all warnings and instructions marked on the projector.

For added protection to the projector during a lightning storm,

or when it is left unattended and unused for long periods of

time, unplug it from the wall outlet. This will prevent damage

due to lightning and power line surges.

Do not expose this unit to rain or use near water... for

example, in a wet basement, near a swimming pool, etc...

Do not use attachments not recommended by the

manufacturer as they may cause hazards.

Do not place this projector on an unstable cart, stand, or table.

The projector may fall, causing serious injury to a child or

adult, and serious damage to the projector. Use only with a

cart or stand recommended by the manufacturer, or sold with

the projector. Wall or shelf mounting should follow the

manufacturer's instructions, and should use a mounting kit

approved by the manufacturers.

An appliance and cart combination should

be moved with care. Quick stops,

excessive force, and uneven surfaces

may cause the appliance and cart

combination to overturn.

Slots and openings in the back and bottom of the cabinet are

provided for ventilation, to insure reliable operation of the

equipment and to protect it from overheating.

The openings should never be covered with cloth or other

materials, and the bottom opening should not be blocked by

placing the projector on a bed, sofa, rug, or other similar

surface. This projector should never be placed near or over a

radiator or heat register.

This projector should not be placed in a built-in installation

such as a book case unless proper ventilation is provided.

Never push objects of any kind into this projector through

cabinet slots as they may touch dangerous voltage points or

short out parts that could result in a fire or electric shock.

Never spill liquid of any kind on the projector.

Do not install the projector near the ventilation duct of air-

conditioning equipment.

This projector should be operated only from the type of power

source indicated on the marking label. If you are not sure of

the type of power supplied, consult your authorized dealer or

local power company.

Do not overload wall outlets and extension cords as this can

result in fire or electric shock. Do not allow anything to rest on

the power cord. Do not locate this projector where the cord

may be damaged by persons walking on it.

Do not attempt to service this projector yourself as opening or

removing covers may expose you to dangerous voltage or

other hazards. Refer all servicing to qualified service

personnel.

Unplug this projector from wall outlet and refer servicing to

qualified service personnel under the following conditions:

a. When the power cord or plug is damaged or frayed.

b. If liquid has been spilled into the projector.

c. If the projector has been exposed to rain or water.

d. If the projector does not operate normally by following the

operating instructions. Adjust only those controls that are

covered by the operating instructions as improper

adjustment of other controls may result in damage and will

often require extensive work by a qualified technician to

restore the projector to normal operation.

e. If the projector has been dropped or the cabinet has been

damaged.

f. When the projector exhibits a distinct chang e in

performance-this indicates a need for service.

When replacement parts are required, be sure the service

technician has used replacement parts specified by the

manufacturer that have the same characteristics as the

original part. Unauthorized substitutions may result in fire,

electric shock, or injury to persons.

Upon completion of any service or repairs to this projector, ask

the service technician to perform routine safety checks to

determine that the projector is in safe operating condition.

Voor de klanten in Nederland

Bij dit product zijn batterijen

geleverd.

Wanneer deze leeg zijn,

moet u ze niet weggooien

maar inleveren als KCA.

Product specificaties

Merk:	Sanyo
Categorie:	Beamer
Model:	PLV-80
Gewicht:	7900 g
Geluidsniveau:	32 dB
Soort lamp:	NSH
Stroomvoorziening:	100V-240V,50Hz/60Hz
Typische contrastverhouding:	1000:1
Projector helderheid:	3000 ANSI lumens
Projectietechnologie:	LCD
Projector native resolution:	XGA (1024x768)
Frequentiebereik horizontaal:	15 - 100 kHz
Frequentiebereik verticaal:	48 - 100 Hz
Type lichtbron:	Lamp
Aantal ingebouwde luidsprekers:	2
Netvoeding:	450 W
Lampvermogen:	300 W
Audio-uitgang:	2W+2W
Dot clock scanfrequentie:	180 MHz
Afmetingen (B x D x H):	319 x 429.5 x 168 mm
Stroomverbruik (typisch):	450 W