Russell Hobbs 18464-56 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Russell Hobbs 18464-56 (92 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 56 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/92
instructions 2
Bedienungsanleitung 6
mode d’emploi 10
instructies 14
istruzioni per l’uso 18
instrucciones 22
instruções 26
brugsanvisning 30
bruksanvisning 34
instruksjoner 38
yttöohjeet 42
инструкции (Русский) 46
pokyny (Čeština) 50
pokyny (Slovenčina) 54
instrukcja 58
upute 62
navodila 66
οδηγίες 70
utasítások 74
talimatlar 78
instrucţiuni 82
инструкции ългарски) 86
2
Read the instructions, keep them safe, pass them on if you pass the appliance on.
Remove all packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of a responsible adult. Use and
store the appliance out of reach of children.
2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors.
3 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.
4 Don’t iron clothing while its being worn – you’ll injure the wearer.
5 Don’t touch the soleplate, and keep away from the steam it emits.
6 Don’t use the iron in the vicinity of children.
7 Use the iron, or set it on its heel, on a stable, level, heat-resistant surface, preferably an
ironing board.
8 Don’t leave the iron unattended while plugged in, or while it’s standing on the ironing board.
9 Unplug the iron before filling, before cleaning, and after use.
10 Sit the iron upright when you’re not ironing.
11 Don’t fill the iron directly from the tap, use the jug.
12 Don’t use accessories or attachments other than those we supply.
13 Don’t use the appliance for any purpose other than those described in these instructions.
14 Don’t scratch the soleplate – avoid buttons, zips, etc.
15 The appliance has a protective thermal fuse, which will blow if it overheats. If this happens,
the appliance will stop working, and must be returned for repair.
16 Don’t operate the appliance if it’s dropped or damaged, or if it malfunctions or leaks.
17 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
household use only
U BEFORE USING FOR THE FIRST TIME
•Remove any labels, stickers or packaging from the iron and soleplate.
•Don’t worry if the iron smokes a bit at first, it’ll stop as the element cures.
3
•Iron an old piece of cotton fabric, to clean the soleplate.
•Press the S and * buttons 3 or 4 times, to check them.
C AUTO SHUT-OFF
•If the iron is motionless, it will switch off after about 30 seconds with the soleplate down, or
about 8 minutes if its upright.
•The auto shut-off light will flash, and keep on flashing till you move the iron.
•To switch on again, lift it up, tilt it forward, then sit it upright to return to operating
temperature.
•No settings are lost during auto shut-off.
C PREPARATION
1 Check for textile care symbols (i j k l).
2 Iron fabrics needing low temperatures jrst, then those that need medium temperatures
k, and finish with those needing high temperatures l.
temperature setting guide
label marking temperature setting
j cool – nylon, acrylics, polyester
k warm – wool, polyester mixtures ••
l hot – cotton, linen •••/max
i do not iron
, If the instructions on the fabric label differ from this guide, follow the instructions on the
label.
X FILLING
3 The iron may be used with tap-water, but if you live in a hard-water area, you should use
distilled water (not chemically descaled water).
4 If you buy distilled water, check that it is marketed as suitable for irons.
5 Don’t add anything to the water – you’ll damage the iron.
6 Unplug the appliance.
7 Open the water inlet cover.
8 Tilt the iron till the water inlet cover is vertical.
9 Pour water from the jug into the water inlet.
10 Pour slowly, to allow the air in the reservoir to escape, and avoid an airlock.
11 Don’t fill past the max mark on the reservoir, or water will escape in use.
12 Close the water inlet cover.
13 Wipe up any spillage.
C SWITCH ON
14 Sit the iron on its heel.
15 Put the plug into the power socket.
a) The appliance will beep.
b) The display will flash, then go off.
c) The power light will glow as long as the appliance is connected to the electricity supply.
d) The auto shut-off light will flash untill you press a button.
16 Press any button. The display will show SILK .
17 Use the u and d buttons to set the temperature.
instructions
diagrams
1 power light
2 auto shut-off light
3 display
4 water inlet cover
5 water inlet
6 spray nozzle
7 soleplate
8 steam vents
9 reservoir
10 heel
11 steam control


Product specificaties

Merk: Russell Hobbs
Categorie: Strijkijzer
Model: 18464-56

Heb je hulp nodig?

Als je hulp nodig hebt met Russell Hobbs 18464-56 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Strijkijzer Russell Hobbs

Handleiding Strijkijzer

Nieuwste handleidingen voor Strijkijzer