Roland APC-10 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Roland APC-10 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 205 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
Setting Up
Attach the all purpose clamp to the stand.
Adjustable
range
Unit 1
Knob 4
Knob 7
Bolt 2
Hex nut 5Hex nut 6
Clamp 8
Clamp 3
1. Loosen knob 7 and hex nut 6, and use the clamp 8 to securely
fasten the unit to the stand.
2. Use a drum key to loosen bolt 2, and then adjust clamp 3 to the
desired position and secure it.
* A drum key is not included.
3. Loosen knob 4 and hex nut 5, and securely insert the item that
youre attaching.
4. Finally, make sure that none of the bolts, nuts, and hex nuts are
loose.
Caution when setting up
5The clamps 3 8 can be attached to pipes with a diameter of 15.9–28.6 mm
(5/8–1-1/8 inches).
5Adjust the tightened depth of the hex nuts 5 6 as appropriate for the
diameter of the attached pipe.
5When tightening the knobs, ensure that the clamps 3 8 remain parallel with
the unit 1.
OK
5To avoid an unstable situation, do not allow clamp 3 to extend beyond the
unit 1.
OK
5After setup, check that the stand to which the all-purpose clamp is attached is
stable before use.
Main Specications
Roland APC-10: All purpose clamp
Usable pipe size 15.9–28.6 mm
5/8–1-1/8 inches
Weight 530 g / 1 lb 3 oz
Accessory Owners Manual
* This document explains the specications of the product at the time that the document was
issued. For the latest information, refer to the Roland website.
* Before using this unit, carefully read “USING THE UNIT SAFELY and “IMPORTANT NOTES. After reading, keep the document(s) where it will be available for immediate
reference.
© 2020 Roland Corporation
English
Owner’s Manual
IMPORTANT NOTES
USING THE UNIT SAFELY
WARNING
Do not disassemble or modify by yourself
Do not carry out anything unless you are
instructed to do so in the owner’s manual.
Otherwise, you risk causing malfunction.
Do not repair or replace parts by yourself
Be sure to contact your dealer, a Roland
service center, or an ocial Roland dealer.
For a list of Roland service centers and
ocial Roland dealers, refer to the Roland
website.
Do not use or store in the following types of locations
• Subject to temperature extremes (e.g.,
direct sunlight in an enclosed vehicle,
near a heating duct, on top of heat-
generating equipment); or are
• Damp (e.g., baths, washrooms, on wet
oors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and shakiness;
or are
• Placed in a poorly ventilated location.
Be cautious to protect children from injury
Always make sure that an adult is on hand
to provide supervision and guidance when
using the unit in places where children
are present, or when a child will be using
the unit.
Do not drop or subject to strong impact
Otherwise, you risk causing damage or
malfunction.
CAUTION
Check safety before using this unit
Even if you observe the cautions given
in the owner’s manual, certain types of
handling may allow this product to fall
from the stand, or cause the stand to
overturn. Please be mindful of any safety issues
before using this product.
Take care so as not to get ngers pinched
When handling the following moving
parts, take care so as not to get ngers,
toes, etc., pinched. Whenever a child uses
the unit, an adult should be on hand to
provide supervision and guidance.
• Clamps
• Knobs
• Hex nuts
Keep small items out of the reach of children
To prevent accidental ingestion of the parts
listed below, always keep them out of the
reach of small children.
• Removable Parts
Bolts, washers, nuts, knobs
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
The symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
plug must be unplugged from the outlet.
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is
determined by the design contained within the triangle. In
the case of the symbol at left, it is used for general
cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never be
carried out (are forbidden). The specific thing that must
not be done is indicated by the design contained within
the circle. In the case of the symbol at left, it means that
the unit must never be disassembled.
About WARNING and CAUTION Notices About the Symbols
ALWAYS OBSERVE THE FOLLOWING
Maintenance
• Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or
deformation.
Intellectual Property Right
• Roland is either a registered trademark or a trademark of Roland Corporation in the United States and/or
other countries.
• Company names and product names appearing in this document are registered trademarks or trademarks
of their respective owners.


Product specificaties

Merk: Roland
Categorie: Niet gecategoriseerd
Model: APC-10

Heb je hulp nodig?

Als je hulp nodig hebt met Roland APC-10 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Roland

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd