Rockustics BlockRock Handleiding

Rockustics Speaker BlockRock

Lees hieronder de 📖 handleiding in het Nederlandse voor Rockustics BlockRock (2 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
© 2024 SoundTube. Rev. 07.24.2024
Ultra-Fidelity Outdoor Speakers
Contact: SoundTube, 855.663.5600 / 913.663.5600 / sales@soundtube.com
Please read the following instructions carefully before
installing your SoundTube Rockustics Monument Series
speaker. If you have any questions regarding installation
that are not answered in the following directions, please
contact your local sound contractor, or the SoundTube
technical support team.
Basic Wiring
( ) Locate speaker wire on the underside of the Diagram A
rock. If necessary, strip the wire ends and trim the wire to
the appropriate length. Use the supplied silicone wire nut
to connect the positive (red) leads of the speaker and
input wires. Repeat this step with the negative (black) leads.
SoundTube recommends using 14ga or heavier Direct
Burial cable for the connection between the amplier and
speakers.
NOTE: The provided wire nuts are meant for permanent
installation use only. If you are temporarily wiring the
speakers, do not use these wire nuts. In the event you
have used wire nuts, and need to re-wire your system, do
not attempt to unscrew the nuts. Instead, clip the wires
below the nut, and follow the steps in the
Basic Wiring
section with a new pair of waterproof wire nuts (available
at most hardware stores).
Optimizing Speaker Placement for
Best Sound
All SoundTube speakers can generate a high SPL (sound
pressure level). Be ready to rock, but be considerate of
your neighbors! Maximum acoustic performance should
be an important factor in determining speaker placement.
Here is how to achieve it:
1) Establish where the most likely or average listening
position will be.
2) The speakers should be placed at or close to the
same distance from that point.
3) The actual distance between the listening position
and the location of the speakers is not critical. How
ever, keep in mind that as the distance between
listening area and speaker is increased, there will be
a noticeable decrease in perceived volume.
4) Be sure to conrm amp power matches the power
rating on the speaker. Over-driving the speaker can
lead to permanent damage that is not covered under
warranty.
Optimizing Aesthetics with
Speaker Placement
All SoundTube products are designed with a boost in
high frequency response to accommodate for placement
near plants and other landscaping features. Feel free to
position the product within or around your landscaping.
Rockustics Monument series products are designed to
stand out from their surroundings.
Diagram A
Rockustics Monument Series
INSTALL INSTRUCTIONS
© 2024 SoundTube. Rev. 07.24.2024
Ultra-Fidelity Outdoor Speakers
Contact: SoundTube, 855.663.5600 / 913.663.5600 / sales@soundtube.com
Be sure to account for the wires which will run from the
rock to your stereo or audio source. Camouage wires by
running them an inch below ground level when possible.
Cautions and Maintenance
All SoundTube Rockustics Monument Series speakers are
sealed and fully weatherproof. However, DO NOT place
speakers where the grille will be in the path of a sprinkler
system.
Sprinklers typically have a high water pressure level that
can damage speaker cones if hit directly.
DO NOT place soil or wood chips over the bottom plate of
the speaker. If buildup does occur, simply rinse the plate
with a garden hose set to a low pressure level.
Accumulated soil may also promote undesired insect traf-
c into the speaker. Insects may eat through the speaker
cone. Chemical sprays may also cause damage to the
rubber of the speaker surround. This includes bug spray,
deck sealant, some fertilizers and oil based products.
Speakers MUST be covered when applying these treat-
ments or chemicals in your yard.
For environments that get snow and ice during the winter
months, be sure to check that the openings and woofer
cone are clear and there is no hard-packed snow or ice
built up in these areas before playing. If there is ice or
snow present on the cone, use a hair dryer set on a low
setting to melt it away. If the speakers are not going to
be used during the winter months, it is recommended
that they either be disconnected and brought indoors,
or covered with a plastic bag to help protect the speaker
components.
Wiring for 70V/100V Applications
For speakers with transformers, use to nd the Diagram C
proper wire selection for your desired tap setting. Once the
desired tap setting is conrmed, trim the unused wires to
minimize corrosion. For harsh and wet environments, it is
recommended to apply a bead of silicone to the end of the
unused wires for added protection.
If daisy-chaining, follow wire preparations as outlined in
the section. Review for a typical
Basic Wiring Diagram E
daisy-chain wiring system for 70V and 100V applications.
Be sure to connect the wires going to the next speaker in
the chain as shown in . There should be three
Diagram D
pairs of wires at each speaker, but the last speaker in the
chain will only have two pairs. Follow standard protocol
for polarity and make sure all units are wired with the
same polarity.
Diagram E
Diagram DDiagram C
Rockustics Monument Series
INSTALL INSTRUCTIONS


Product specificaties

Merk: Rockustics
Categorie: Speaker
Model: BlockRock

Heb je hulp nodig?

Als je hulp nodig hebt met Rockustics BlockRock stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Rockustics

Handleiding Speaker

Nieuwste handleidingen voor Speaker