Rockford Fosgate Prime R1L-1X10 Handleiding

Rockford Fosgate Speaker Prime R1L-1X10

Lees hieronder de đź“– handleiding in het Nederlandse voor Rockford Fosgate Prime R1L-1X10 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 142 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Installation & Operation
Serial Number: Date of Purchase:
R1L 10" 12"
Single R1L-1X10 R1L-1X12
Dual R1L-2X10 R1L-2X12
R1L – LOADED ENCLOSURES
SVC - SINGLE VOICE COIL SUBWOOFERS
INSTALLATION – ENGLISH
CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire and/or possible injury.
Run the speaker cable from the amp. When routing the speaker cable from the amplifier, avoid running it close to any sources of high current
(wiring harnesses).The positive (+) speaker output from the amp connects to the red terminal of the enclosure, and the negative (-) connects to the
black terminal.
INSTALACIÓN – ESPAÑOL
PRECAUCIÓN: Antes de la instalación, desconecte el terminal negativo de la batería (-) para prevenir daño a la unidad, incendio
y/o posibles lesiones.
Recorrido del Cable de Altavoz Desde el Amplificador.Al llevar el cable de altavoz desde el amplificador, evite que pase cerca de cualquier
fuente de alto corriente (cables de alimentacion). El terminal positive (+) de las salida de rojo, y el terminal negativo (-) al terminal negro.
INSTALLATION – FRANÇAIS
MISE EN GARDE : avant d'entamer l'installation, déconnectez la broche négative (-) de la batterie pour éviter tout risque de
blessures, d’incendie ou de dommages à l'appareil.
Branchement du câble du haut-parleur de l’amplificateur. En plaçnt le câble du haut-parleur de l’ampli, éviter de l’approcher d’une source
de courant important. La sortie positive de l’ampli se branche sur le terminal rouge du caisson, et le négatif se branche sur le terminal noir.
EINBAU – DEUTSCH
VORSICHT: Entfernen Sie vor dem Einbau den negative Batteriepol, um Schäden am Gerät, Feuer bzw. mögliche Verletzungen zu
vermeiden.
AnschluĂź des Lautsprecherkabels. Beim AnschluĂź des Lautsprecherkables sollten Sie darauf achten, daĂź das Kabel keine Fahrzeugstromkabel
kr um Einsteuungen zu verhindern. Die Plus-Leitung des Lautsprecherkabels kommt in die rote Klemme des Terminals, die Negativ-Leitung in dieeuzt,
schwarze Klemme des Terminals.
INSTALLAZIONE – ITALIANO
ATTENZIONE: Prima dell’installazione scollegate il terminale negativo (-) della batteria per evitare danni all’unità,,
pericoli d’incendio e/o potenziali lesioni personali.
Far correre il cavo dell’altoparlante all’amplificatore. Quando fate correre il cavo dell’altoparlante all’amplificatore non
fatelo passare vicino a qualsiasi cavo dell’impianto elettrico di serie dell’auto. Il segnale positivo dell’altoparlante (+) in uscita dall’amplificatore á col-
legato al terminale rosso del diffusore, e il negativo (-) al terminale nero.
Strip 5/8"
(16mm)
From
Amplifier
From
Amplifier
16 AWG
-to-
12 AWG
R1L-1X10 / R1L-1X12
Amplifier 4Ω Mono
Amplificador 4Ω Mono
Amplificateur de 4Ω Mono
Amplifier 4Ω Mono
Amplificatore 4Ω Mono
Black
Negro
Noir
Schwarz
Nero
Red
Rojo
Rouge
Rot
Rosso
R1L-2X10 / R1L-2X12
Amplifier 2Ω Mono
Amplificador 2Ω Mono
Amplificateur de 2Ω Mono
Amplifier 2Ω Mono
Amplificatore 2Ω Mono
FEATURES
SPECIFICATIONS
Enclosure Features
• High Current Binding Posts
• Constructed with 5/8" MDF
• Covered with High Density Carpet
Specifications subject to change without notice
R1L-1X10 Single 10" SVC
Nominal Impedance (Ohms) 4 Ω
Replacement Woofer R1S410
Power Handling (Watts) 150 RMS / 300 Max
Overall Dimensions (HxWxD) 12.0” x 15.825” x 12.25”
(30.5cm x 40.1cm x 31.1cm)
R1L-2X10 Dual 10" SVC
Nominal Impedance (Ohms) 2 Ω
Replacement Woofer R1S410 (wired internally)
Power Handling (Watts) 300 RMS / 600 Max
Overall Dimensions (HxWxD) 12.0” x 30.0” x 12.25”
(30.5cm x 76.2cm x 31.1cm)
R1L-1X12 Single 12" SVC
Nominal Impedance (Ohms) 4 Ω
Replacement Woofer R1S412
Power Handling (Watts) 150 RMS / 300 Max
Overall Dimensions (HxWxD) 14.0” x 17.5” x 12.25”
(35.6cm x 44.5cm x 31.1cm)
R1L-2X12 Dual 12" SVC
Nominal Impedance (Ohms) 2 Ω
Replacement Woofer R1S412 (wired internally)
Power Handling (Watts) 300 RMS / 600 Max
Overall Dimensions (HxWxD) 14.0” x 33.75” x 12.25”
(35.6cm x 85.7cm x 31.1cm)
Speaker Features
• Parabolic polypropylene cone.
• 12 AWG compression terminals.
• 18 gauge stamped steel frame.
• Optimized for sealed enclosures.


Product specificaties

Merk: Rockford Fosgate
Categorie: Speaker
Model: Prime R1L-1X10

Heb je hulp nodig?

Als je hulp nodig hebt met Rockford Fosgate Prime R1L-1X10 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Rockford Fosgate

Handleiding Speaker

Nieuwste handleidingen voor Speaker