Rockford Fosgate Connecting Punch CPPI300 Handleiding

Rockford Fosgate Niet gecategoriseerd Connecting Punch CPPI300

Lees hieronder de 📖 handleiding in het Nederlandse voor Rockford Fosgate Connecting Punch CPPI300 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 173 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

11/02 Printed in China MAN-4437-A

WARRANTY NFORMAITION

Connecting Punch

Rockford Corporation

546 South Rockford Drive

Tempe, AZ 85281 USA

USA, (480) 967-3565

Europe, Fax (49) 4207-8101250

Japan, Fax (81) 559-79-1265

CPPI150

CPPI300

CPPI300HW

Installation &

OPERAtion Manual

Rockford Fosgate offers a limited warranty with the following terms:

• Length of Warranty

One year parts and labor warranty.

Requires proof of purchase.

• What is Covered

This warranty applies only to Rockford Fosgate products sold to

consumers by Authorized Rockford Fosgate Dealers in the United

States of America or its possessions. Product purchased by

consumers from an Authorized Rockford Fosgate Dealer in another

country are covered only by that country’s Distributor and not by

Rockford Fosgate.

• Who is Covered

This warranty covers only the original purchaser of Rockford Fosgate

product purchased from an Authorized Rockford Fosgate Dealer in the

United States. In order to receive service, the purchaser must provide

Rockford Fosgate with a copy of the receipt stating the customer

name, dealer name, product purchased and date of purchase.

Products found to be defective during the warranty period will be

repaired or replaced (with a product deemed to be equivalent) at

Rockford Fosgate’s discretion.

• What is Not Covered

1. Damage caused by accident, abuse, improper operations, water,

theft

2. Any cost or expense related to the removal or reinstallation of

product

3. Service performed by anyone other than Rockford Fosgate or an

Authorized Rockford Fosgate Service Center

4. Any product which has had the serial number defaced, altered,

or removed

5. Subsequent damage to other components

6. Any product purchased outside the U.S.

7. Any product not purchased from an Authorized Rockford Fosgate

Dealer

• Limit on Implied Warranties

Any implied warranties including warranties of fitness for use and

merchantability are limited in duration to the period of the express

warranty set forth above. Some states do not allow limitations on the

length of an implied warranty, so this limitation may not apply. No

person is authorized to assume for Rockford Fosgate any other

liability in connection with the sale of the product.

• How to Obtain Service

Please call 1-800-669-9899 for Rockford Fosgate Customer Service.

You must obtain an RA# (Return Authorization number) to return

any product to Rockford Fosgate. You are responsible for shipment

of product to Rockford Fosgate. Always include Proof of Purchase.

Mark RA# on outside of shipping carton.

INTRODUCTION

Thank you for purchasing the Rockford Fosgate

Connecting Punch Power Inverter.

The Connecting Punch Power Inverters allow you to

power a variety of AC voltage devices from your

car, truck, boat or RV. Power 110 volt AC power

devices such as notebook computers, video game

consoles, and TVs directly from a 12 volt DC power

supply.

Please read, understand and follow all instructions

before connecting the Connecting Punch Power

Inverter. If, after reading your manual, you still have

questions regarding this product, we recommend

that you see your Rockford Fosgate dealer. If you

need further assistance, you can call us direct at

1-800-669-9899.

Model CPPI150

Output Connection 1 North American Standard

Receptacle

Output Voltage Approx. 110 Volts AC RMS 60Hz

Output Current 1.36 Amps RMS

Output Waveform Modified Rectangular Wave

Input Voltage Range 10.6 to 15.5 Volts DC

Low Voltage Alarm Voltage drops below 10.6 Volts DC

Low Voltage Shutdown Voltage drops below 9.6 Volts DC

No Load Input Current 0.3 Amps

Input Fuse 20 Amp AGU

Input Cable Hard Wired Lighter Plug

Additional Protection Overload, Over Voltage, Over Temp

Dimensions Length: 5.6" (142.2mm)

Width: 4.1" (104.1mm)

Height: 1.85" (47.0mm)

Model CPPI300

Output Connection 2 North American Standard

Receptacles

Output Voltage Approx. 110 Volts AC RMS 60Hz

Output Current 2.73 Amps RMS

Output Waveform Modified Rectangular Wave

Input Voltage Range 10.6 to 15.5 Volts DC

Low Voltage Alarm Voltage drops below 10.6 Volts DC

Low Voltage Shutdown Voltage drops below 9.6 Volts DC

No Load Input Current 0.3 Amps

Input Fuse 40 Amp AGU

Input Cable Lighter Plug and Battery Clip Adapter

Additional Protection Overload, Over Voltage, Over Temp

Dimensions Length: 7.5" (190.5mm)

Width: 4.1" (104.1mm)

Height: 1.85" (47.0mm)

Model CPPI300HW

Output Connection 2 North American Standard

Receptacles

Output Voltage Approx. 110 Volts AC RMS 60Hz

Output Current 2.73 Amps RMS

Output Waveform Modified Rectangular Wave

Input Voltage Range 10.6 to 15.5 Volts DC

Low Voltage Alarm Voltage drops below 10.6 Volts DC

Low Voltage Shutdown Voltage drops below 9.6 Volts DC

No Load Input Current 0.3 Amps

Input Fuse 40 Amp AGU

Input Cable Lighter Plug and Battery

Hard Wire Kit

Additional Protection Overload, Over Voltage, Over Temp

Dimensions Length: 7.5" (190.5mm)

Width: 4.1" (104.1mm)

Height: 1.85" (47.0mm)

SPECIFICATIONS

150 watt or 300 watt

12 volt DC to 110 volt AC

Power Inverter

S IAFETY NFORMATION

CAUTION: To prevent injury and damage to

the unit, please read and follow

the instructions in this manual.

CAUTION: If you feel unsure about installing

this system yourself, have it

installed by a qualified technician.

WARNING: To prevent serious personal injury,

fire, electrical shock and/or

damage, never connect the inverter

to an AC powered outlet.

Always unplug the appliance or

device from the inverter before

attempting any repairs to the

appliance or device.

Never connect the inverter to

places designated as IGNITION

PROTECTED.

CAUTION: Failure to observe the following

safety precautions could result in fire,

damage to the inverter, vehicle

and/or personal injury.

• DO NOT use with 6 or 24 volt DC systems or

positive ground electrical systems.

The majority of all vehicles are

negative ground.

• DO NOT use the inverter to operate high

wattage appliances or devices that

produce heat, such as hair dryers,

heaters, toasters, microwave ovens,

etc.

• DO NOT operate the inverter if it is wet.

• DO NOT install the inverter in the engine

compartment. Install in a well

ventilated, dry area.

• DO NOT use the inverter with a surge

protector or power strip.

• DO NOT use the inverter to power medical

equipment or devices.

• DO NOT replace a fuse with one of a

different type or rating.

• DO NOT operate the inverter near flammable

material or where flammable fumes

or gases may accumulate.

• DO NOT connect the inverter to a vehicle

battery while it is running.

• ALWAYS turn any device connected to the

inverter OFF before starting the

vehicle.

INSTALLATION / OPERATION

FEATURES

MOUNTING

Locate on your inverter in a well ventilated, dry place free

from dirt and grease. Keep the inverter away from heater

vents or heat producing devices. If at all possible, keep the

inverter away from direct sunlight.

CONNECTIONS

Before connecting the inverter to power, determine the

wattage needed to power your devices. Most electrical

devices have labels that indicate the power consumption in

amps or watts. To convert amps into watts, multiply amps by

the voltage. Example; a 110 volt AC device requires 1.2

amps, 110 X 1.2 = 132 watts needed.

CPPI150

CPPI300 / CPPI300HW

1. Lighted On/Off Power Switch – Turns power on

and off to AC outlet(s). I=On, O=Off.

2. 110 Volt AC Power Outlet(s)

3. External Fuse – 20A for CPPI150, 40A for CPPI300

& CPPI300HW.

4. LED – Lights green when 12 volt DC power is

connected and on.

5. Lighter Plug – (CPPI150) Plug into vehicle lighter

receptacle.

6. High Speed Fan – (CPPI300 & CPPI300HW)

7. Positive Binding Post – (CPPI300 & CPPI300HW)

Connect to positive12 volt DC power.

8. Negative Binding Post – (CPPI300 & CPPI300HW)

Connect to negative12 volt DC power.

If you're plugging the inverter into a cigarette lighter

outlet, ensure the outlet can supply the wattage needed.

Most vehicles have a 15 or 20 amp fuse protecting the

circuit. Multiply the fuse rating by voltage to determine

the maximum wattage output available. Example; 12 volts X

15 amp fuse = 180 watts maximum.

NOTE: For loads over 180 watts, connect the inverter

directly to the battery.

NOTE: Some vehicles may require you to turn the ignition

switch to the On position to supply power to the

cigarette lighter outlet.

CAUTION: To prevent fire, damage to the

inverter, vehicle and/or personal

injury, do not replace a fuse with

one of a different type or rating.

NOTE: Some devices, such as TVs and stereos, may require

2 to 6 times their wattage rating to start up. Testing is

the only way to check if the inverter will operate

these devices. If an overload does occur, the inverter

will shut down. Remove the device that caused the

overload and if necessary turn the power switch on

the inverter Off then On.

Connecting to Cigarette Lighter Outlet (All Models)

1. (Models CPPI300 and 300HW) Connect the cigarette

plug harness to the binding posts on the inverter.

2. Plug the cigarette plug into the cigarette lighter outlet.

3. The green LED on the inverter should light showing

power is connected and On.

4. Turn the switch on the inverter to On. This will light.

5. Plug your device into the inverter and use normally.

Connecting Directly to Battery

(CPPI300 and CPPI300HW Only)

1. (Model CPPI300 only) Connect the battery clip

harness to the binding posts on the inverter.

2. Clip the RED (positive +) clip to the positive (+) post on

the battery.

3. Clip the BLACK (negative ) clip to the negative (– –) post

on the battery.

CAUTION: To prevent fire, damage to the

inverter, vehicle and/or personal

injury, never connect the inverter to

a vehicle battery while it is running.

4. The green LED on the inverter should light showing

power is connected and On.

5. Turn the switch on the inverter to On. This will light.

6. Plug your device into the inverter and use normally.

CAUTION: To prevent damage to the inverter

and/or vehicle, turn any device

connected to the inverter OFF

before starting the vehicle.

Product specificaties

Merk:	Rockford Fosgate
Categorie:	Niet gecategoriseerd
Model:	Connecting Punch CPPI300

Heb je hulp nodig?

Als je hulp nodig hebt met Rockford Fosgate Connecting Punch CPPI300 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Rockford Fosgate

Rockford Fosgate RFX9900DM Handleiding

10 Juni 2024

Rockford Fosgate RFK-HD9813M5 Handleiding

24 Mei 2024

Rockford Fosgate HD14CVO-STG2 Handleiding

9 Januari 2024

Rockford Fosgate Prime R16-S Handleiding

9 Januari 2024

Rockford Fosgate HD9813SG-STG3 Handleiding

9 Januari 2024

Rockford Fosgate HD9813SG-PMX-STG2 Handleiding

9 Januari 2024

Rockford Fosgate HD9813SG-STG2 Handleiding

9 Januari 2024

Rockford Fosgate HD14U-STG2 Handleiding

9 Januari 2024

Rockford Fosgate RFC1D Handleiding

9 Januari 2024

Rockford Fosgate HD9813RG-STG3 Handleiding

9 Januari 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Brennenstuhl Tower Power Handleiding

29 December 2024

Brennenstuhl Eco-Line Handleiding

29 December 2024

Atlona AT-2VGA300SL Handleiding

28 December 2024

Atlona AT-HD-V216 Handleiding

28 December 2024

Atlona AT-VGA11S Handleiding

28 December 2024

Atlona AT-HD-3GSDI Handleiding

28 December 2024

Adj EVS3 FLEX45 Handleiding

28 December 2024

Adj COB Cannon LP200X Handleiding

28 December 2024

Atlona AT-DVI0808 Handleiding

28 December 2024

Atlona AT-HDRX-ROADNET Handleiding

28 December 2024