Real Flame Opti-V Single PGF10 Handleiding

Real Flame Heater Opti-V Single PGF10

Lees hieronder de 📖 handleiding in het Nederlandse voor Real Flame Opti-V Single PGF10 (8 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
08/51841/3 Issue 3
Model: PGF10
Instructions
Opti-V Fire
OCN 11161
The product complies with the European Safety Standards EN60065 and the European Standard Electromagnetic Compatibility (EMC) EN55014-1 & EN55014-
2, EN6100-3-2 and EN6100-3-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
Patent - This product is protected by the following international patents : GB2502814 & EP2802746.
Introduction
Thank you for chosing this Real Flame Opti-V re. Please
read information guide carefully to be able to safely install, use
and maintain your product. The appliance is designed to be
installed into a cabinet or wall opening.
Important Safety Advice
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety. When using electrical
appliances, basic precautions should be followed to reduce the
risk of re, electric shock, and injury to persons, including the
following:
If the appliance is damaged, check immediately with the supplier
before installation and operation.
Do not use this appliance in the immediate surroundings of a
bath, shower or swimming pool.
Means for disconnection must be incorporated in the xed wiring
in accordance with the wiring regulations.
Do not use outdoors.
In the event of a fault switch off the appliance.
Switch off the appliance when not required for long periods.
If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service
agent. Always have a professional technician, manufacturer or
service agent replace a damaged power cord.
Warning - No naked ame sources, such as candles, should be
placed on this apparatus.
Warning - The appliance shall not be exposed to dripping or
splashing and that no objects lled with liquid, such as vases,
shall be placed on the apparatus.
Warning - this appliance is of Class I construction and must be
connected to a mains outlet with protective earthing connection.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
Do not switch the appliance on until properly installed. Please
read all the safety warnings and operating instructions.
General
Unpack the appliance carefully and retain the packaging for
possible further use, in the event of moving or returning the
appliance to the supplier.
Contents of Carton
Opti-V Fire Model PGF10
Remote control and batteries (AAA type)
Product Features
Volume Control
Remote or Manual operation
Red light indication of standby mode
Installation
Warning.
Do not connect the appliance until properly xed to a secure
base and the instruction leaet is read fully.
Opti-V Fire : PGF 10
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
At installation of the appliance, care must be taken not to
damage any cables that may be concealed in the wall.
Positioning the Fire
The Opti-V uses an illusory reection technique and is designed
to work best when ambient light levels are low. If the Opti-V is
installed in brightly lit areas, the strong reections may diminish
the ame picture.
Fixing dimensions
The Opti-V is supplied in an assembled state.
This mo d el is de signe d to be permane n tly fixed .
Please see Fig.2a and 2b for recommended xing dimensions.
Height of Fire
There is a choice of height when tting the re.
Recommended heights (from oor to bottom opening of re - *
Fig 2a) :
- Minimum 65cm when the re is viewed while sitting
(e.g. lounge).
- Maximum 110cm when the re is viewed while standing
(e.g. reception area).
Electrical connection
The outline of the chassis and the position of the electrical socket
are shown as dotted outlines in Please consult with a Fig.4.
qualied electrician for appropriate wiring requirements.
Operation: -
The power ‘ON’ switch (‘O/I’see Fig.3) must rst be switched ‘I’
to operate the appliance.
An ‘Opti-V’ screen will appear for about 3 seconds before the
ame picture starts .
Note: The user may notice a blank screen for approximately 5
seconds, every 30 minutes. This is normal and should not be a
cause for concern.
Manual Control Operation: -
The manual controls for the screen are located at the inner top
left hand side of the appliance above the glass.(see ). Fig.3
The appliance Power switch (‘O/I’ Fig.3see ) may be used to
switch the appliance off ( ) when it is not required, for example, ‘O’
overnight or for long periods, to avoid energy wastage.
The standby button ( ) is located just below the mains switch.
Remote Control Operation: -
The remote control may be operated once the appliance is
switched (‘I’ see ‘I’ Fig.3).
Aim the remote control at the re (the sensor is indicated in Fig.
4). The volume may be adjusted up or down by pressing the
volume control buttons ( + and -).
The button funtions are identied as described below;
Standby
Volume down -
Volume up+
A red light will indicate when the appliance is in standby mode.
(see )Fig 4
Remote Control - Battery Information
Note : The remote control is packed separately in the carton.
1. Slide Open the battery cover on the back of the remote
transmitter.
2. Install the AAA batteries into the remote control (see .Fig. 5)
NOTE - Use Alkaline batteries only.
Batteries should not be exposed to heat such as sunshine, re
and the like.
Attention should be drawn to the environmental aspects of
battery disposal.
Maintenance
WARNING ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
To disconnect from mains - set the mains switch to O’. The
mains (power) switch is located at the top left hand side of the
appliance above the manual controls - see ‘O/I’ Fig.3.
Mains switch shall remain readily operable.
Techical Information:
100-240V ~ 50/60Hz
Power consumption 32W
Stand-by Power 1W
Cleaning
For general cleaning use a soft clean duster never use abrasive
cleaners. The glass screen should be cleaned carefully with a
soft, lint-free cloth.
RECYCLING
Waste electrical products should not be disposed
of with household waste.
Please recycle where facilities exist.
Check with your local authority or retailer for
recycling advice.
PATENT
Opti-V products are protected by the following
International patents : GB2502814 & EP2802746.
AFTER SALES SERVICE
Your product is guaranteed for 2 years from the date of
purchase if installed in a domestic/residential setting.
If the product is installed in a commercial setting, it is
guaranteed for 1 year. Within this period, we undertake to
repair or exchange this product free of charge provided
it has been installed and operated in accordance with
these instructions. Your rights under this guarantee are
additional to your statutory rights, which in turn are not
affected by this guarantee.
Should you require after sales information or assistance
with this product please go to www.realame.com.au in
Australia and www.realame.co.nz in New Zealand and
select “Contact”. Please retain your receipt as proof of
purchase.
Glen Dimplex Australia Pty Ltd
1340 Ferntree Gully Road,
Scoresby,
Victoria 3179,
Australia
PH: 1300 554 155
Fax: 1800 058 900
Email: ame@glendimplex.com.au
Web: www.realame.com.au
Glen Dimplex New Zealand Ltd
38 Harris Road,
East Tamaki, Auckland 2013,
New Zealand
PH: 0800 666 2824
Fax: 09 274 8472
Email: sales@glendimplex.co.nz
Web: www.realame.co.nz


Product specificaties

Merk: Real Flame
Categorie: Heater
Model: Opti-V Single PGF10

Heb je hulp nodig?

Als je hulp nodig hebt met Real Flame Opti-V Single PGF10 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Real Flame

Handleiding Heater

Nieuwste handleidingen voor Heater