QSC CX108V Handleiding

QSC Receiver CX108V

Lees hieronder de 📖 handleiding in het Nederlandse voor QSC CX108V (3 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Current draw—120 VAC Page 1 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω 8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
Model Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes
CX302 0.9 3.5 5.4 8.6 na 5.1 8.7 12.9 na 8.4 13.9 22.2 na
CX502 0.9 5.1 8.0 11.9 na 7.6 12.1 18.2 na 12.6 21.2 32.2 na
CX702 0.8 5.0 7.7 11.5 na 8.3 13.2 19.8 na 15.9 26.7 41.1 na
CX902 0.9 5.9 9.2 13.2 na 10.5 16.8 24.6 na 20.4 34.3 52.3 na
CX1102 0.9 7.6 11.6 16.6 na 13.1 20.3 30.4 na 25.1 40.6 58.6 na
CX302V 1.0 nr nr nr 5.6 nr nr nr 8.0 nr nr nr 12.0
CX602V 0.9 8.7 nr nr 8.7 13.0 nr nr 13.0 20.5 nr nr 20.5
CX1202V 1.0 7.7 11.9 nr 11.9 12.5 19.2 nr 19.2 25.2 38.7 nr 38.7
CX254 0.7 5.8 9.2 14.3 na 8.8 14.2 21.7 na 14.8 24.0 38.2 na
CX404 0.7 8.1 12.4 nr na 12.2 19.3 nr na 21.7 33.4 nr na
CX204V 0.8 nr nr nr 8.3 nr nr nr 12.7 nr nr nr 20.1
CX168 0.6 6.4 10.0 nr na 9.9 15.1 nr na 16.5 26.0 nr na
CX108V 0.6 nr nr nr 6.4 nr nr nr 10.2 nr nr nr 15.6
CX Series Amplifier Current Draw—120 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 120 VAC usage; for 230- and 100-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
1/8 Power
1/3 Power
Full Power
Load per channel ->
Current draw—230 VAC Page 2 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω 8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
Model Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes
CX302 0.5 1.8 2.7 4.3 na 2.6 4.4 6.5 na 4.2 7.0 11.1 na
CX502 0.5 2.6 4.0 6.0 na 3.8 6.1 9.1 na 6.3 10.6 16.1 na
CX702 0.4 2.5 3.9 5.8 na 4.2 6.6 9.9 na 8.0 13.4 20.6 na
CX902 0.5 3.0 4.6 6.6 na 5.3 8.4 12.3 na 10.2 17.2 26.2 na
CX1102 0.5 3.8 5.8 8.3 na 6.6 10.2 15.2 na 12.6 20.3 29.3 na
CX302V 0.5 nr nr nr 2.8 nr nr nr 4.0 nr nr nr 6.0
CX602V 0.5 4.4 nr nr 4.4 6.5 nr nr 6.5 10.3 nr nr 10.3
CX1202V 0.5 3.9 6.0 nr 6.0 6.3 9.6 nr 9.6 12.6 19.4 nr 19.4
CX254 0.4 2.9 4.6 7.2 na 4.4 7.1 10.9 na 7.4 12.0 19.1 na
CX404 0.4 4.1 6.2 nr na 6.1 9.7 nr na 10.9 16.7 nr na
CX204V 0.4 nr nr nr 4.2 nr nr nr 6.4 nr nr nr 10.1
CX168 0.3 3.2 5.0 nr na 5.0 7.6 nr na 8.3 13.0 nr na
CX108V 0.3 nr nr nr 3.2 nr nr nr 5.1 nr nr nr 7.8
Load per channel ->
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 230 VAC usage; for 120- and 100-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
CX Series Amplifier Current Draw—230 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
1/8 Power
1/3 Power
Full Power
Current draw—100 VAC Page 3 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω 8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
Model Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes
CX302 1.1 4.2 6.5 10.3 na 6.1 10.4 15.5 na 10.1 16.7 26.6 na
CX502 1.1 6.1 9.6 14.3 na 9.1 14.5 21.8 na 15.1 25.4 38.6 na
CX702 1.0 6.0 9.2 13.8 na 10.0 15.8 23.8 na 19.1 32.0 49.3 na
CX902 1.1 7.1 11.0 15.8 na 12.6 20.2 29.5 na 24.5 41.2 62.8 na
CX1102 1.1 9.1 13.9 19.9 na 15.7 24.4 36.5 na 30.1 48.7 70.3 na
CX302V 1.2 nr nr nr 6.7 nr nr nr 9.6 nr nr nr 14.4
CX602V 1.1 10.4 nr nr 10.4 15.6 nr nr 15.6 24.6 nr nr 24.6
CX1202V 1.2 9.2 14.3 nr 14.3 15.0 23.0 nr 23.0 30.2 46.4 nr 46.4
CX254 0.8 7.0 11.0 17.2 na 10.6 17.0 26.0 na 17.8 28.8 45.8 na
CX404 0.8 9.7 14.9 nr na 14.6 23.2 nr na 26.0 40.1 nr na
CX204V 1.0 nr nr nr 10.0 nr nr nr 15.2 nr nr nr 24.1
CX168 0.7 7.7 12.0 nr na 11.9 18.1 nr na 19.8 31.2 nr na
CX108V 0.7 nr nr nr 7.7 nr nr nr 12.2 nr nr nr 18.7
Load per channel ->
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 100 VAC usage; for 230- and 120-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
CX Series Amplifier Current Draw—100 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
1/8 Power
1/3 Power
Full Power


Product specificaties

Merk: QSC
Categorie: Receiver
Model: CX108V

Heb je hulp nodig?

Als je hulp nodig hebt met QSC CX108V stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver QSC

QSC

QSC SRA2422 Handleiding

6 November 2024
QSC

QSC CMX2000V Handleiding

6 November 2024
QSC

QSC SRA3622 Handleiding

5 November 2024
QSC

QSC CMX800V Handleiding

5 November 2024
QSC

QSC 1700 Handleiding

23 Oktober 2024
QSC

QSC DPA4.5Q Handleiding

23 Oktober 2024
QSC

QSC CX6T Handleiding

23 Oktober 2024
QSC

QSC CX12T Handleiding

23 Oktober 2024
QSC

QSC CX4T Handleiding

23 Oktober 2024
QSC

QSC 1100 Handleiding

23 Oktober 2024

Handleiding Receiver

Nieuwste handleidingen voor Receiver