Pyle PDC21 Handleiding

Pyle Receiver PDC21

Lees hieronder de 📖 handleiding in het Nederlandse voor Pyle PDC21 (6 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/6

1/4'' Instrument To Balanced

& Unbalanced (1/4''/XLR) Direct Box

PDC21

www PyleUSA com

Front and Rear Panel Layout

1. INPUT: 1/4" input connector.

2. PARA OUT: It’s parallel output 1/4" jack for passing the input signal through to a

stage ampliﬁer or monitor system.

3. ATT Switch: input attenuation, switchable(0dB,-20dB,-40dB)

4. BALANCED OUTPUT: Male XLR connector.

5. When engaged, the ground from the PDC21 chassis detaches from the GROUND:

XLR jack.

PDC21 Operation

A direct box, or DI box, provides the facility for the direct insertion of an audio signal

into a mixer or recorder. The oers a variety of DI solutions for live sound and PDC21

recording applications. You can connect all kinds of audio signals like guitars,

keyboards, outboard signal processors and even the high-powered speaker output

from an ampliﬁer. The enables you to tap o the signal from a guitar or bass PDC21

guitar and pass the signal from the PARA OUTPUT to the on stage ampliﬁer without

aecting the original sound. This can eliminate the need for mixing the guitar

ampliﬁer, which in many cases is preferable, especially with bass guitar. The is PDC21

also very useful for connecting unbalanced signals from sources like signals DJ and

sub-mixers, eects processors and keyboards to a main PA or recording mixer.

1 2 3

5 4

Balanced Output

(opposite panel)

Input

Amp Speaker

Output

Amplier Amp Speaker

Input

PA Mixer

Link Output

SIGNAL FLOW

www PyleUSA com

The balanced output provides a clean signal at a low level so long runs of PDC21

cable are possible. Another beneﬁt from a balanced connection is common mode

rejection, which provides cancellation of the bad sounds (hums and buzzes) while

leaving the original signal pure.

Direct insertion of an Instrument into a PAsystem

One of the most common applications for using a DI box is getting the signal of

a bass guitar into the PA system. Simply put, the low frequencies produced by bass

are dicult to mic, so use of a DI box is almost always preferable. In addition, the

signal going to PA system can be tweaked by the FOH (front of house) engineer,

without aecting the sound the musician dials up on stage. You can use PDC21 to

plug a guitar directly into the PA system as well. Especially acoustic guitars with

pickups and when using electronic guitar processors and modelers. Follow the

diagram and steps below to connect a guitar to a PA mixer.

• Connect the output of the guitar or bass to the INPUTPDC21

• Connect 's PDC21 PARA OUT to the input of the guitar or bass ampliﬁer.

• Connect 's to the input of main PA mixer.PDC21 BALANCED OUTPUT

NOTE:

To avoid annoying pops and clicks be sure to mute (or turn down the volume control)

of your mixer’s output while connecting the PDC21.

Product specificaties

Merk:	Pyle
Categorie:	Receiver
Model:	PDC21
Kleur van het product:	Zwart
Breedte:	120 mm
Diepte:	76.5 mm
Hoogte:	45 mm
Materiaal behuizing:	Staal
Diepte (imperiaal):	3.01 "
Aantal producten inbegrepen:	1 stuk(s)
Aansluiting 1:	1/4'' TS
Aansluiting 2:	1/4'' TS, XLR