Privileg RIO 3C23 A E 6.5 X Handleiding
Privileg
spĂźlmaschine
RIO 3C23 A E 6.5 X
Lees hieronder de đ handleiding in het Nederlandse voor Privileg RIO 3C23 A E 6.5 X (8 pagina's) in de categorie spĂźlmaschine. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
EN
1
PRODUCT DESCRIPTION
1 2 3 4 5 6 7 8 9 10 11 12 13
1. ON-OFF / Reset button with indicator light
2. Program selection button
3. Salt reîll indicator light
4. Rinse Aid reîll indicator light
5. Program number and delay time indicator
6. Display
7. Delay indicator light
DAILY REFERENCE
GUIDE
CONTROL PANEL
8. Multizone indicator light
9. Push & Go button
10. Delay button
11. Multizone button with indicator light
12. Tablet (Tab) button with indicator light
13. START/Pause button with indicator light
Before using the appliance carefully read Safety Instructions.
You can download the Safety Instructions and the User Manual, by visiting our website docs.whirlpool.eu
and following the Instructions on the back of this booklet.
APPLIANCE
1. Upper rack
2. Foldable îaps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
2
3
4
5
6
10
12
7
11
9
8
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machineâs functional components.
⢠It is mandatory that THE SALT RESERVOIR NEVER BE EMPTY.
⢠It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and must be îlled when the SALT REFILL
indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. Only the îrst time you do this: îll the salt
reservoir with water.
3. Position the funnel (see îgure) and îll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the pro-
cedure before the beginning of the washing cycle to avoid corrosion.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory sets the default value for the water hardness.
⢠Switch on the appliance by pressing the button.ON/OFF
⢠Switch oî the appliance by pressing the button.ON/OFF
⢠Hold down button for 5 seconds, until you hear a beep.P
⢠Switch on the appliance by pressing the button.ON/OFF
⢠The current selection level number and the salt indicator light both îash.
⢠Press button to select the desired hardness level (Psee WATER
HARDNESS TABLE).
⢠Switch oî the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been speciîcally designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches oî.
If the salt container is not îlled, the water softener and the heating
element may be damaged as a result of limescale accumulation.
Using of Salt is recommended with any type of dishwasher detergent.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
°Clark
English degrees
1 Soft 0 - 6 0 - 10 0 - 7
2 Medium 7 - 11 11 - 20 8 - 14
3 Average 12 - 16 21 - 29 15 - 20
4 Hard 17 - 34 30 - 60 21 - 42
5 Very hard 35 - 50 61 - 90 43 - 62
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should A
be îlled when the in the control RINSE AID REFILL indicator light
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lid.B
2. Pour in the rinse aid (max.110 ml), making sure it does not overîow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisîed with the drying results, you can ad-
just the quantity of rinse aid used.
⢠Switch the dishwasher on using the button.ON/OFF
⢠Switch it oî using the button.ON/OFF
⢠Press button three times - a beep will be heard.P
⢠Switch it on using the button.ON/OFF
⢠The current selection level number and rinse aid indicator light îash.
⢠Press button to select the level of rinse aid quantity to be supplied.P
⢠Switch it oî using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied.
The LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 5 levels can be set according to the dishwasher model.
The factory setting is speciîc to the model, please follow instruction
above to check this for your machine.
⢠If you see bluish streaks on the dishes, set a low number (1-2).
⢠If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device C.
Introduce the detergent into the dry dispenser D only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are indiD-
cations to help the detergent dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Usage of detergent not designed for dishwashers may cause mal-
function or damage to the appliance.
C
D
A
B
EN
3
PROGRAMS TABLE
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature
and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and
sensor calibration. The sensor calibration can increase program duration up to 20 min.
WATER RECYCLING INDICATOR - When lit, it indicates that standard program uses water recycling system.
Program
Drying
phase
Auto Door
Available
options *)
Duration of
wash program
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
1. Eco 50° 3:10 6.5 0.95
2. Auto Intensive 65° 2:00 - 3:10 14.0 - 17.0 1.50 - 1.85
3. Auto Mixed 55° 1:30 - 2:30 14.5 - 16.0 1.15 - 1.30
4. Glass
45°
1:40 11.5 1.20
5. Fast&Clean 28â 45° -- 0:28 9.0 0.50
6. Silent 50° 3:30 15.0 1.15
7. Prewash - - - 0:12 4.5 0.01
8. Self Clean 65° -- 1:35 14.0 1.15
9. Push&GO 50° 1:25 11.5 1.10
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
1 ECO
Eco programme is suitable to clean normally soiled tableware, that for
this use, it is the most eîcient programme in terms of its combined
energy and water consumption, and that it is used to assess complian-
ce with the EU Ecodesign legislation.
2 AUTO INTENSIVE
Automatic program for heavily soiled dishes and pans (not to be used
for delicate items).
3 AUTO MIXED
Automatic program for normally soiled pans and dishes.
4 GLASS
Program for delicate items, which are more sensitive to high temperatu-
res, for example glasses and cups.
5 FAST&CLEAN 28â
Program to be used for half load of lightly-soiled dishes with no dried
food residues. Does not include drying phase.
6 SILENT
Suitable for night-time operation of the appliance. Ensures optimal
cleaning and drying performance with the lowest noise emission.
7 PREWASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
8 SELF CLEAN
Program to be used to perform maintenance of the dishwasher, to be
carried out only when the dishwasher is EMPTY using speciîc deter-
gents designed for dishwasher maintenance
9 PUSH&GO
Everyday wash and dry cycle that ensures great cleaning performance
in a short time without the need to pre-treat dishes.
Notes:
Please note that cycle Fast&Clean 28â is dedicated for lightly soiled dishes.
Product specificaties
| Merk: | Privileg |
| Categorie: | spĂźlmaschine |
| Model: | RIO 3C23 A E 6.5 X |
Heb je hulp nodig?
Als je hulp nodig hebt met Privileg RIO 3C23 A E 6.5 X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding spĂźlmaschine Privileg
30 Juni 2023
Handleiding spĂźlmaschine
Nieuwste handleidingen voor spĂźlmaschine
7 Juli 2023