Princeton Tec Switch MPLS Handleiding

Princeton Tec Niet gecategoriseerd Switch MPLS

Lees hieronder de 📖 handleiding in het Nederlandse voor Princeton Tec Switch MPLS (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 4 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/2
Battery installation
1. ARC Rail Installation 2. MOLLE Mount
Slide ARC Rail Adapter into ARC rail to desired position and secure in place with center
anti-slip lock screw. DO NOT OVERTIGHTEN this screw.
Slide clip inside any strap position, pinch MOLLE strap to hook the lower end of the
metal clip onto the strap.
2
3. MICH Mount Installation 4. Picatinny Rail Mount
Back the screw out so the end of screw is ush with metal U-clip. Slide the exposed
U-clip over the bottom edge of your helmet with the metal clip on the inside and the
plastic base exposed on the outside of your Helmet. Holding Mount rmly upward,
tighten center slotted screw until it stops.
Remove the center through screw from the side of the Picatinny base mount. Slide Pica-
tinny to desired position and insert side locking screw aligning with any slot in Picatinny
rail and tighten to clamp in place. DO NOT OVERTIGHTEN this screw.
2
5. (ABR) Above Rail Mount
A. If using MPLS ABR on a ballistic helmet, skip to step two. For
use with nonballistic helmets, begin by snapping off unneeded
portion of ABR mount by hand or with a pair of pliers, and
discarding the smaller ‘hook’ portion
Loosen or remove front rail screw, and slide ABR into desired position
beneath rail. Retighten front rail screw.
1a 2a 1b 2b 3b 4b
Select Charge MPLS mount and secure with included machine screws, gently tightening with a Phillips screwdriver. Install Switch/Point onto mount.
1c 2c 3c
POINT / SWITCH
M P L S
MODULAR PERSONAL
LIGHTING SYSTEM
OPERATING AND MAINTENANCE
INSTRUCTIONS
English
Battery Installation
White, Blue or Green LED
• (2) CR2016 Coin Cells - 6V
• Infrared and Red LED
• (1) CR2032 Coin Cell - 3V
Princeton Tec cares about the environment and recom-
mends recycling batteries. For more information about
battery recycling, please go to: batteryrecycling.com To
install the batteries, rotate light unit out of base. Lift tab
of battery door on the underside of light unit to expose
coin cell(s)
Install coin cell(s) batteries with the (+) positive side fac-
ing up. Improper installation of the batteries will damage
the light and void the warranty.
Replace the battery door with the lift tab properly
aligned with lift tab slot of the housing. Press door rmly
in place making sure it is all the way seated in place.
WARNING !
Never mix fresh and used batteries.Never mix different
battery brands or chemistry types.
Always remove drained batteries immediately.
Remove batteries during long periods of storage.
Switch Operation
Modes-Low, High (Color), High (White or Red)
Low, High (Color): Select by pressing and releasing the
button within 1.6 seconds of the previous button press.
High (White or Red): Hold down the push button in any
mode for 1.6 seconds to activate the high output light
mode. Once off, the Switch will always return to the low
(color) LED mode once turned on again.
There are two ways to turn the Switch-MPLS off.
1. You can cycle through the modes within 1.6 seconds of
the initial button press until you reach the off mode.
2. Or if more than 1.6 seconds has passed since the
previous button press, the next press of the button will
turn the light off.
Troubleshooting
If the MPLS fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is conrmed.
• This light has been designed to be water resistant.
Check the light for water contamination on the circuit
board. The light will resume normal operation once any
water is shaken or blown out and the light is left open
until completely dry. If the light has been contaminated
with salt water, ush the unit with fresh water and dry
as described above.
USA– International 1-Year Warranty
WARRANTY – Princeton Tec warrants this product to be
free from defects in workmanship and materials under
normal use for one year. This warranty covers all of the
component parts of the product except batteries. This
warranty does not cover deterioration due to normal
wear or damage due to misuse, alteration, negligence,
accidents, or unauthorized repair. Princeton Tec will
repair or replace parts which are
defective in workmanship or materials. Your authorized
Princeton Tec Dealer and Princeton Tec are the only
facilities authorized to repair the product. After (3) un-
successful attempts (within the warranty
period) to repair the product, you have the right to elect
replacement of the product or a refund of the purchase
price less allowance for use of the product. NO IN-
CIDENTAL OR CONSEQUENTIAL DAMAGES ARE
INCLUDED IN THIS WARRANTY. (Some states do not
allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitations or exclu-
sions may not apply to you.) This warranty gives you
specic legal rights, and you may also have other rights
which vary from state to state.
Princeton Tec reserves the right to change product
specications without notice.
FOR CALIFORNIA RESIDENTS
WARNING: This product contains Bisphenol A (BpA) a
chemical known to the State of California to cause birth
defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, rst
contact Princeton Tec customer service on
1-800-257-9080 to request an RMA number. Please
have your light model, date of purchase and a brief
description of the fault your are experiencing. No
warranty repairs will be accepted without an RMA
number.
3. Return the light to: Princeton Tec, PO Box 8057
Trenton NJ 08650. Postage due and freight collect
items will not be accepted.
4. Upon receipt your light will be processed in about
two weeks. Please allow additional time for return
transportation from NJ.
Princeton Tec
PO Box 8057, Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com

Product specificaties

Merk: Princeton Tec
Categorie: Niet gecategoriseerd
Model: Switch MPLS

Heb je hulp nodig?

Als je hulp nodig hebt met Princeton Tec Switch MPLS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Princeton Tec

Princeton Tec

Princeton Tec Switch MPLS Handleiding

25 Februari 2025
Princeton Tec

Princeton Tec MPLS-ABR Handleiding

25 Februari 2025
Princeton Tec

Princeton Tec Charge X Handleiding

7 December 2024
Princeton Tec

Princeton Tec Charge Pro Handleiding

30 Januari 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Andover

Andover Songbird HRA Handleiding

25 Februari 2025
XD-Design

XD-Design P265.872 Handleiding

25 Februari 2025
XD-Design

XD-Design P265.871 Handleiding

25 Februari 2025
XD-Design

XD-Design P265.875 Handleiding

25 Februari 2025
Step2

Step2 Masterpiece Easel 4831 Handleiding

25 Februari 2025
Step2

Step2 Play Up Teeter Totter 7168 Handleiding

25 Februari 2025
Step2

Step2 3 Piece Farmhouse Table & Bench Set 4939 Handleiding

25 Februari 2025
Step2

Step2 Play & Fold Jr Slide 8439 Handleiding

25 Februari 2025
Step2

Step2 Fiesta Cruise Sand & Water Table 8947 Handleiding

25 Februari 2025
Step2

Step2 Skyward Summit 739700 Handleiding

25 Februari 2025