Premium PFR10400X Handleiding

Premium Vriezer PFR10400X

Lees hieronder de 📖 handleiding in het Nederlandse voor Premium PFR10400X (11 pagina's) in de categorie Vriezer. Deze handleiding was nuttig voor 13 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11
Model/Modelo:PFR33400X/PFR50400X
PFR70400X/PFR10400X
CONGELADOR HORIZONTAL
CHEST FREEZER
Transportation and Placement
â–³When transporting the chest freezer from one place to another, the
inclination of the cabinet should not exceed 45 degrees to prevent against
compressor or system damage.
â–³Before use, remove all the packing material. The back side of the cabinet
should be more than 20cm away from the wall, both flank sides more than
20cm.
â–³The freezer should be put in a well-ventilated, dry place. Do not place it
under direct sunshine. The freezer should be kept away from the water sink,
heat sources and any volatile or corrosive material.
Power source and test-running
â–³Specified capacity of the wire is 7A. Section squares of the wire is 0.82mm2.
Single line or compound lines are all allowed. A fuse of 2.5A specified
electric current should be installed. (Power cord should be replaced with the
same of 7A and 0.82mm2 if it is damaged).
â–³Single-phase power supply, 60Hz, voltage range 98~132V. If the voltage is
unstable, please install a voltage stabilizer with capacity above 1000W.
â–³Avoid turning the power on and off too frequently. If the power is turned off,
wait an interval of 5 minutes before turning it on again.
â–³When the freezer is going to be out of use for a long time, disconnect the
power first, remove all its contents and then clean it. Please examine the
circuit whether it is in perfect conditions before reuse.
Operation of the Temperature Control Knob
â–³The temperature inside the cabinet can be controlled with the temperature
control knob.
â–³The knob should be kept upright normally to adjust the temperature. 7 is < =
the coldest freezing setting and is suitable for fast freezing. Do not keep the
knob at this point for long.
△ 1 : temperature inside the freezer cabinet is around -10 < = ℃
△ 2< =: temperature inside the freezer cabinet is around -12 ℃
△ 3< =: temperature inside the freezer cabinet is around -15 ℃
△ < =: temperature4 inside the freezer cabinet is around -18 Factory setting℃ÿ Ā
△ 5< =: temperature inside the freezer cabinet is around -20 ℃
△ 6< =: temperature inside the freezer cabinet is around -22 ℃
△ 7 : temperature inside the freezer cabinet is around -25< = ℃
Food storage
â–³Allow space between the foods stored in the cabinet, and between the foods
and the inner surface of the cabinet to keep good ventilation of cold air and
1
freeze evenly. Do not put in any bottled or canned beverages with freezing
points above the temperature in the cabinet when it is below zero.
â–³For foods that should be moisture-free or lose water easily, wrap them up in
airtight food bags or containers before putting in the cabinet to avoid
smell-mixing and reduce frosting.
â–³Storage of volatile and combustible gases, liquids such as strong alkalis,
strong acids, petrol, etc. is not allowed.
Maintenance
â–³The freezer should be cleaned regularly. When cleaning, turn off the power,
take out all the food from the cabinet, and clean the inside using water or a
little neutral detergent.
â–³Do not use boiling water, acid, chemical diluents, petrol, oil, or dirt- removing
powder.
â–³Dry it after cleaning.
â–³Use light soap water when cleaning the door seal and apply a little of talcum
powder on it after natural drying to extend its service life.
â–³Use a soft cloth with water or a little detergent to clean the exterior surface.
Note: Keep the power supply and connecting wires away from water to
avoid electric shock.
â–³Those who are not a service technician should not take apart and repair the
freezer on their own to avoid additional trouble. Unauthorized repairs of
electrical parts as compressor, temperature controller is forbidden.
Defrosting
â–³For better freezing efficiency, defrost when the frost film inside the cabinet is
4-5mm thick.
â–³When defrosting, turn off the power, take out the frozen foods, open the door
for warming and melting. Use a soft cloth to absorb water and clean it up.
â–³Do not use sharp metal tools as steel brushes to clean the frost film when
defrosting to avoid evaporator damage.
Trouble shooting
Failure
Cause
Removal method
The indicator is not on.
The compressor does
not start.
The plug is not really
connected to the socket.
Replug it.
No power
Connect to a socket
with power.


Product specificaties

Merk: Premium
Categorie: Vriezer
Model: PFR10400X

Heb je hulp nodig?

Als je hulp nodig hebt met Premium PFR10400X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vriezer Premium

Handleiding Vriezer

Nieuwste handleidingen voor Vriezer