Planet IGS-504PT Handleiding

Planet Niet gecategoriseerd IGS-504PT

Lees hieronder de 📖 handleiding in het Nederlandse voor Planet IGS-504PT (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

- 1 -

- 2 -

- 3 -

- 4 -

- 5 -

- 6 -

- 7 -

- 8 -

1. Package Contents

Thank you for purchasing PLANET IGS-504PT Industrial 5-Port

Gigabit Ethernet Switch with 4 PoE+ ports. The interfaces of

these models are shown below:

In the following section, the term “Industrial PoE+ Switch”

means the IGS-504PT. Open the box of the Industrial PoE+

Switch and carefully unpack it. The box should contain the

following items:

Industrial PoE+ Switch x 1 User’s Manual x 1

Wall-mount Kit x 1 DIN-rail Kit x 1 RJ45 Dust Caps x 5

If any of these are missing or damaged, please contact your

dealer immediately.

Switch Specications

Switch

Architecture Store-and-Forward

Switch Fabric 10Gbps

Throughput

(packet per

second)

7.4Mpps@64bytes

Address Table 2K entries

Jumbo Frame 9Kbytes

Flow Control Back pressure for half duplex

IEEE 802.3x pause frame for full duplex

Power over Ethernet

PoE Standard

IEEE 802.3at Power over Ethernet Plus/PSE

Backward compatible with IEEE 802.3af

Power over Ethernet/PSE

PoE Power

Supply Type End-span

Power Pin

Assignment 1/2(+), 3/6(-)

PoE Power

Output

Per port 48-54V DC

Max. 30 watts@54V DC

Max. 15 watts@48V DC

PoE Power

Budget

Max. 120 watts@54V DC

Max. 60 watts@48V DC

Max. Number

of Class 4 PDs 4

3.3 Switch Upper Panel

The upper panel of the Industrial PoE+ Switch consists of one

terminal block connector within two DC power inputs.

Figure 3-2 shows the upper panel of the Industrial PoE+

Switch.

DC Input Range:

48-54V

, 3A max.

V1+ V2+

PWR1 PWR2

1 2 3 4

Figure 3-2: Industrial PoE+ Switch Upper Panel

3.4 Wiring the Power Inputs

The 4-contact terminal block connector on the top panel of

Industrial PoE+ Switch is used for two DC redundant power

inputs. Please follow the steps below to insert the power wire.

When performing any of the procedures like

inserting the wires or tightening the wire-clamp

screws, make sure the power is OFF to prevent

from getting an electric shock.

3. Hardware Introduction

3.1 Switch Front Panel

P1 P2

ACTLNK

PoE-in-Use

 Gigabit Ethernet TP Interface

10/100/1000BASE-T copper, RJ45

twisted-pair: Up to 100 meters.

Figure 3-1:

IGS-504PT Front View

2.ProductSpecications

Model IGS-504PT

Hardware Specications

Copper Ports 5 10/100/1000BASET RJ45 auto-MDI/MDI-X

ports

PoE Injector

Ports

4 ports with 802.3at PoE+ injector function

(Ports 1 to 4)

PoE Budget 120W maximum@75 degrees C

Connector Removable 4-pin terminal block

Pin 1/2 for Power 1; Pin 3/4 for Power 2

Power

Requirements

48~54V DC, 3A (max.)

Redundant power with reverse polarity

protection function

Power

Consumption

 DC 48V:

Max. 0.48 watts/1.63BTU (System)

Max. 62.88 watts/214.5BTU (Full Loading)

 DC 54V:

Max. 0.54 watts/1.84BTU (System)

Max. 123.12 watts/420BTU (Full Loading)

Dimensions

(W x D x H) 30 x 70 x 104 mm

Weight 260g

Enclosure IP30 metal case

Installation DIN-rail kit and wall-mount kit

ESD Protection 6KV

Standards Conformance

Regulatory

Compliance FCC Part 15 Class A, CE

Stability

Testing

IEC 60068-2-32 (free fall)

IEC 60068-2-27 (shock)

IEC 60068-2-6 (vibration)

Standards

Compliance

IEEE 802.3 Ethernet

IEEE 802.3u Fast Ethernet

IEEE 802.3ab Gigabit Ethernet

IEEE 802.3x Full-Duplex Flow Control

IEEE 802.3az Energy Ecient Ethernet (EEE)

IEEE 802.3at Power over Ethernet Plus PSE

IEEE 802.3af Power over Ethernet Plus

IEEE 802.1p Class of Service

Environment

Temperature Operating: -40~75 degrees C

Storage: -40~75 degrees C

Humidity Operating: 5~90% (non-condensing)

Storage: 5~90% (non-condensing)

3.2 LED Indicators

System

LED Color Function

P1 Green Lights to indicate power 1 has power.

P2 Green Lights to indicate power 2 has power.

 Per 802.3at PoE+ 10/100/1000BASE-T Interface (Port

1 to Port 4)

LED Color Function

LNK/

ACT Green

Lights to indicate the link through

that port is successfully established at

10/100/1000Mbps.

Blinks to indicate that the Switch is

actively sending or receiving data over that

port.

PoE-

in-Use Amber

Lights to indicate the port is providing DC

in-line power.

O to indicate the connected device is not

a PoE powered device (PD).

 Per 10/100/1000BASE-T Interface (Port 5)

LED Color Function

LNK/

ACT Green

Lights to indicate the port is successfully

established at 10/100/1000Mbps.

Blinks to indicate that the Switch is actively

sending or receiving data over that port.

1. The DC power input range is 48V

~ 54V DC. Please insert

positive and negative DC power wires into contacts 1 and 2

for POWER 1, or 3 and 4 for POWER 2.

DC Input Range:

48-54V

, 3A max.

V1+ V2+

PWR1 PWR2

1 2 3 4

Figure 3-3: Industrial PoE+ Switch DC Input

DC Input Max. PoE Budget

48V~51V 60 watts

52V~54V 120 watts

Note

1. To avoid damage, please use the Industrial PoE+

Switch according to its specifications.

2. Please follow the table above for DC input in

relation with maximum PoE budget.

- 9 -

- 10 -

- 11 -

- 12 - - 13 - - 14 -

3.5 Grounding the Device

Uses MUST complete grounding wired with the device;

otherwise, a sudden lightning could cause fatal damage to the

device.

Note

EMD (Lightning) DAMAGE IS NOT CONVERED

UNDER WARRANTY.

DC Input Range:

48-54V

, 3A max.

V1+ V2+

PWR1 PWR2

1 2 3 4

Earth Ground

4.2 Wall-mount Plate Mounting

4.3 Side Wall-mount Plate Mounting

You must use the screws supplied with the wall-

mounting brackets. Damage caused to the parts

by using incorrect screws would invalidate your

warranty.

4. Installation

This section describes the functionalities of the Industrial PoE+

Switch’s components and guides you to installing it on the

DIN-rail and wall. Basic knowledge of networking is assumed.

Please read this chapter completely before continuing.

Note

This following pictures show how to install the

device. However, the device in the picture is not

IGS-504PT.

4.1 DIN-rail Mounting Installation

5. Customer Support

Thank you for purchasing PLANET products. You can browse

our online FAQ resource at the PLANET Web site rst to

check if it could solve your issue. If you need more support

information, please contact PLANET support team.

PLANET online FAQs:

https://www.planet.com.tw/en/support/faq?method=category&c1=3

Support team mail address:

support@planet.com.tw

Contents are subject to revision without prior notice.

PLANET is a registered trademark of PLANET Technology Corp.

All other trademarks belong to their respective owners.

FCC Warning

This device has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the

Instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own

expense

WEEE Warning

To avoid the potential eects on the environment and

human health as a result of the presence of

hazardous substances in electrical and electronic

equipment, end users of electrical and electronic

equipment should understand the meaning of the crossed-out

wheeled bin symbol. Do not dispose of WEEE as unsorted

municipal waste and have to collect such WEEE separately.

PLANET TECHNOLOGY CORPORATION

e-mail: sales@planet.com.tw http://www.planet.com.tw

10F., No.96, Minquan Rd., Xindian Dist., New Taipei City, Taiwan Tel:886 2219 9518 Fax:886 2219 9528-2- - -2- -

EC Declaration of Conformity

For the following equipment:

*Type of Product : -Port 10/100/1000T 802.3at PoE + 1-Port 10/100/1000T Industrial Compact 4

Ethernet Switch

*Model Number : -504PTIGS

* Produced by:

Manufacturer‘s Name : Planet Technology Corp.

Manufacturer‘s Address : 10F., No.96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan

is herewith confirmed to comply with the requirements set out in the Council Directive on the

Approximation of the Laws of the Member States relating to Electromagnetic Compatibility Directive on

2014/30/EU.

For the evaluation regarding the EMC, the following standards were applied:

EN 55032 2015+AC:2016

EN 55024 2010+A1:2015

EN 55035 2017

Responsible for marking this declaration if the:

Manufacturer Authorized representative established within the EU

Authorized representative established within the EU (if applicable):

Company Name: Planet Technology Corp.

Company Address: 10F., No.96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan

Person responsible for making this declaration

Name, Surname Kent Kang

Position / Title : Director

Taiwan

Apr., 2021

Place

Date

Legal Signature

Product specificaties

Merk:	Planet
Categorie:	Niet gecategoriseerd
Model:	IGS-504PT
Kleur van het product:	Blauw
Gewicht:	260 g
Breedte:	30 mm
Diepte:	70 mm
Hoogte:	104 mm
Materiaal behuizing:	Metaal
Internationale veiligheidscode (IP):	IP30
Stroom:	3 A
Certificering:	FCC Part 15 Class A, CE
Netwerkstandaard:	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x
Temperatuur bij opslag:	-40 - 75 °C
Luchtvochtigheid bij opslag:	5 - 90 procent
Rack-montage:	Nee
Ophangsysteem voor aan de muur:	Ja
Auto MDI/MDI-X:	Ja
Power over Ethernet (PoE):	Ja
Switchingcapaciteit:	10 Gbit/s
MAC-adrestabel:	2000 entries
10G support:	Nee
Switch type:	Unmanaged
Aantal basis-switching RJ-45 Ethernet-poorten:	5
Type basis-switching RJ-45 Ethernet-poorten:	Gigabit Ethernet (10/100/1000)
Throughput:	7.4 Mpps
Jumbo Frames ondersteuning:	Ja
Bedrijfstemperatuur (T-T):	-40 - 75 °C
Relatieve vochtigheid in bedrijf (V-V):	5 - 90 procent
Totaal Power over Ethernet (PoE)-budget:	120 W
Jumbo frames:	9000
DIN rail bevestiging:	Ja
Store-and-forward:	Ja