Pioneer S-ES21-LR-K Handleiding

Pioneer Speakers S-ES21-LR-K

Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer S-ES21-LR-K (16 pagina's) in de categorie Speakers. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/16

S-ES21-LR-K

S-ES21-LR-T

Operating Instructions

Speaker System

WHAT’S IN THE BOX

BEFORE USE

Thank you for buying this Pioneer product.

Please read through these operating instructions before

using your speaker system to optimize performance.

• This speaker system has an impedance of 8 Ω, and

should be connected only to an amplifier designed

with a load impedance of 8 Ω (the amplifier’s speaker

output connector should clearly be labeled “8 Ω“).

• In order to prevent damage to the speaker system

resulting from input overload, please observe the

following precautions:

-Be sure to turn the connected devices off and

remove the power cord from the wall outlet

beforehand when changing the connection or

installation method.

-Do not use excessive amplifier volume if using a

tone control to emphasize high or low frequencies.

• Do not use the speaker to output distorted sound for

long periods of time. This can result in a fire hazard.

INSTALLATION PRECAUTIONS

• Do not install these units near a stove or other

heating appliance, or put them in a place exposed to

the sun. Such locations may cause the cabinet to

change color and the speaker system to break down.

• Do not attach the front speakers to the wall or ceiling.

It may fall off and cause injury.

• Placing the stand on an unstable surface can be

dangerous. Be sure to place it on a flat, firm surface.

• This speaker system is magnetically shielded.

However, depending on the installation location,

color distortion may occur if the speaker system is

installed extremely close to the screen of a television

set.

If this happens, turn off the television, then turn it on

again after 15 min to 30 min. If the problem persists,

place the speaker system away from the television

set.

• Do not install your speakers overhead on the ceiling

or wall. The grille is designed to be detachable, and

as such it may fall and cause damage or personal

injury if installed overhead.

• Do not place heavy or large objects on top of the

speaker. Doing so could provoke the speaker to fall,

causing damages or bodily injury.

PLACEMENT AND FINE TUNING

For best results the speakers should be separated a

distance approximately equal to the listening distance.

Angling the speakers inward towards the listener will

improve the image stability for non-central listeners.

Close proximity to a side or rear wall will enhance the

midbass performance, although too close (particularly a

corner location) and the bass may be unnaturally high

and image performance may be degraded.

Front speaker x 2

Speaker cords x 2

Front Grilles x 2

Operating instructions

S-ES21-LR.fm 1 ページ２０１３年７月１８日　木曜日　午前９時２５分

STANDARD SURROUND SETUP

This is a standard multichannel surround sound speaker

setup for optimal 5.1 channel home theater sound.

MAKING AMPLIFIER SETTINGS

Before connecting the speakers, please read the

operating instructions supplied with your amplifier to

select the speaker setting of amplifier :

• FRONT SPEAKERS : LARGE

CONNECTING YOUR SYSTEM

Make sure all equipment is turned off before making any

connections.

• Correct wiring of your speakers is essential for

achieving the best sound quality. Be careful to

ensure proper polarity of connection.

Connect to the speaker terminals on the rear of

the amplifier.

Connect the red marked speaker cord to the red (+)

terminal and the other cord to the black (–) terminal as

shown below (for more details, refer to your amplifier

instruction manual).

After connecting the plugs, pull lightly on the cords to

make sure that the ends of the cords are securely con-

nected to the terminals. Poor connections can create

noise and interruptions in the sound.

Connect to the speaker terminals on the rear of

the speakers.

Unscrew the terminals on the speaker and insert the red

marked speaker cord into the red (+) terminal and the

other cord into the black (–) terminal as shown below.

SECURING THE FRONT SPEAKERS

• Pass a commercially-available reinforced string

through the plastic catch to securely support the

speaker to the wall. Be sure that the wall to which you

fasten the speaker is strong enough to support the

weight of the speaker. After fastening the speaker,

make sure that it does not fall over.

• The speaker can incur damage in the event of a fall.

• Do not attach the plastic catch directly to the wall. It

should only be used in conjunction with reinforced

string to prevent the speaker from falling.

Pass and tie two reinforced strings through the plastic

catch, and fasten the speaker to the wall as shown above.

• If you are unsure of the quality and strength of the

walls, consult a professional for advice.

• Pioneer is not responsible for any accidents or

damage that result from improper installation.

Surround left Surround right

Center

Front

left

Listening position

Front

right

Subwoofer

(not supplied)

CAUTION

These speaker terminals carry HAZARDOUS LIVE

voltage. To prevent the risk of electric shock when

connecting or disconnecting the speaker cables,

disconnect the power cord before touching any

uninsulated parts.

D3-4-2-2-3_A1_En

SpeakersAmplifier

Red marked half of speaker cord

Other half of speaker cord

Black Red

Plastic catch

Reinforced strings

Backside of speaker

S-ES21-LR.fm 2 ページ２０１３年７月１８日　木曜日　午前９時２５分

CABINET MAINTENANCE

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the cabinet is very dirty, clean with a soft cloth

dipped in some neutral cleanser diluted five or six times

with water, and then wipe again with a dry cloth. Do not

use furniture wax or cleaners.

Never use thinners, benzine, insecticide sprays and other

chemicals on or near the cabinets, since these will

corrode the surfaces.

ATTACHING / DETATCHING THE GRILLE

The front grille of this speaker system is removable.

Proceed as follows:

1. To detatch the grille, grab it by its bottom with both

hands and toward you to separate the bottom part of

the grille from the speaker.

2. Next, grab the top part of the grille and gently pull it

toward you to remove the top portion.

3. To replace the grille, align the holes in the front of the

speaker’s corners with the projections on the grille,

and push each of the corners into place.

TROUBLESHOOTING

Symptom Possible cause Remedy

No sound • Bad speaker cord or

connection.

• Amplifier is off.

• Volume control is at zero.

• Connect correctly or

replace cord.

• Turn on amplifier.

• Slowly turn up volume.

Sound is

distorted.

• Extreme signal condition. • Turn down the

amplifier’s output level

(volume, bass control,

bass boost) to lower the

level.

S-ES21-LR.fm 3 ページ２０１３年７月１８日　木曜日　午前９時２５分

Product specificaties

Merk:	Pioneer
Categorie:	Speakers
Model:	S-ES21-LR-K
Kleur van het product:	Zwart
Gewicht:	9000 g
Breedte:	220 mm
Diepte:	247 mm
Hoogte:	247 mm
Materiaal behuizing:	Hout
Connectiviteitstechnologie:	Bedraad
Type stroombron:	AC
Gemiddeld vermogen:	150 W
Aanbevolen gebruik:	Luidsprekerset
Impedantie:	8 Ohm
Geschikt voor buitengebruik:	Nee
Audio-uitgangskanalen:	2.0 kanalen
Speaker plaatsing:	Vloer
Aantal drivers:	3
Woofer:	Ja
Frequentiebereik:	40 - 20000 Hz
Gevoeligheid:	84 dB
Bass reflex:	Ja
Luidspreker soort:	2-weg
Speaker omsluiting:	Reflex
Diameter woofer:	160 mm
Diameter hogetonenluidspreker:	52 mm
Magnetisch afgeschermd:	Ja
Tweeter:	Ja
Speaker positie:	Voorkant