Pioneer DVH-340UB Handleiding

Pioneer Multimedia DVH-340UB

Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer DVH-340UB (40 pagina's) in de categorie Multimedia. Deze handleiding was nuttig voor 112 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/40

Installation Manual

Manuel d installation’

Manuale d installazione’

Manual de instalación

Installationsanleitung

Installatiehandleiding

DVD RDS RECEIVER

AUTORADIO DVD RDS

SINTO LETTORE DVD CON RDS

RADIO RDS CON DVD

DVD-RDS-EMPFÄNGER

DVD RDS-ONTVANGER

DVH-340UB

English NederlandsDeutschEspañolItalianoFrançais

WARNING

!To avoid the risk of accident and the potential

violation of applicable laws, no viewing of

front seat video should ever occur while the

vehicle is being driven. Also, rear displays

should not be in a location where they are

visibly distracting to the driver.

!In some countries or states the viewing of im-

ages on a display inside a vehicle even by

persons other than the driver may be illegal.

Where such regulations apply, they must be

obeyed and this unit s DVD features should’

not be used.

CAUTION

!PIONEER does not recommend that you in-

stall or service your display unit yourself. In-

stalling or servicing the product may expose

you to risk of electric shock or other hazards.

Refer all installation and servicing of your

display unit to authorized Pioneer service

personnel.

!Secure all wiring with cable clamps or elec-

trical tape. Do not allow any bare wiring to re-

main exposed.

!Do not drill a hole into the engine compart-

ment to connect the yellow cable of the dis-

play unit to the vehicle battery. Engine

vibration may eventually cause the insulation

to fail at the point where the wire passes

from the passenger compartment into the

engine compartment. Take extra care in se-

curing the wire at this point.

!It is extremely dangerous to allow the display

lead to become wound around the steering

column or shift lever. Be sure to install the

display in such a way that it will not obstruct

driving.

!Make sure that wires will not interfere with

moving parts of the vehicle, such as the shift

lever, parking brake or seat sliding mecha-

nism.

!Do not shorten any cables. If you do, the pro-

tection circuit may fail to work properly.

Important

!When installing this unit in a vehicle without

an ACC (accessory) position on the ignition

switch, failure to connect the red cable to the

terminal that detects operation of the ignition

key may result in battery drain.

ACC position No ACC position

!Use of this unit in conditions other than the

following could result in fire or malfunction.

—Vehicles with a 12-volt battery and negative

grounding.

—Speakers with 50 W (output value) and 4 Wto

8W(impedance value).

!To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

—Disconnect the negative terminal of the bat-

tery before installation.

—Secure the wiring with cable clamps or adhe-

sive tape. Wrap adhesive tape around wiring

that comes into contact with metal parts to

protect the wiring.

—Place all cables away from moving parts,

such as the shift lever and seat rails.

—Place all cables away from hot places, such

as near the heater outlet.

—Do not connect the yellow cable to the battery

by passing it through the hole to the engine

compartment.

—Cover any disconnected cable connectors

with insulating tape.

—Do not shorten any cables.

—Never cut the insulation of the power cable of

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

—Use a fuse of the rating prescribed.

—Never wire the negative speaker cable directly

to ground.

—Never band together negative cables of multi-

ple speakers.

!When this unit is on, control signals are sent

through the blue/white cable. Connect this

cable to the system remote control of an ex-

ternal power amp or the vehicle s auto-anten-’

na relay control terminal (max. 300 mA

12 V DC). If the vehicle is equipped with a

glass antenna, connect it to the antenna

booster power supply terminal.

!Never connect the blue/white cable to the

power terminal of an external power amp.

Also, never connect it to the power terminal

of the auto antenna. Doing so may result in

battery drain or a malfunction.

!The black cable is ground. Ground cables for

this unit and other equipment (especially,

high-current products such as power amps)

must be wired separately. If they are not, an

accidental detachment may result in a fire or

malfunction.

Connections

Section

Connections

Power cable connection

Note:

Depending on the kind of vehicle, the

function of 2* and 4* may be different. In

this case, be sure to connect 1* to 4*

and 3* to 2*.

Connect leads of the same

color to each other.

Yellow (2*)

Back-up (or

accessory)

Red (4*)

Accessory

(or back-up)

Yellow (1*)

Connect to the constant

12 V supply terminal.

Red (3*)

Connect to terminal controlled

by ignition switch (12 V DC).

ISO connector

Note:

In some vehicles, the ISO connector

may be divided into two. In this case,

be sure to connect to both connectors.

Speaker leads

White: Front left 

White/black: Front left 

Gray: Front right 

Gray/black: Front right 

Green: Rear left  or subwoofer

Green/black: Rear lef t  or subwoofer

Violet: Rear right   or subwoofer

Violet/black: Rear right  or subwoofer

Blue/white

Connect to system control terminal of the

power amp (max. 300 mA 12 V DC).

Blue/white (6*)

Connect to auto-antenna

relay control terminal

(max. 300 mA 12 V DC).

The pin position of the ISO connector will differ

depends on the type of vehicle. Connect 5* and

6* when Pin 5 is an antenna control type. In

another type of vehicle, never connect 5* and 6*.

Yellow/black

If you use an equipment with Mute function, wire

this lead to the Audio Mute lead on that equipment.

If not, keep the Audio Mute lead free of any

connections.

Black (chassis ground)

Connect to a clean, paint-free metal location.

This product

Fuse (10 A)

Wired remote input

Hard-wired remote control

adapter can be connected

(sold separately).

Antenna jack

Blue/white (5*)

Notes:

࡮Change the initial setting of this unit (refer to the

Operation Manual). The subwoofer output of this

unit is monaural.

࡮When using a subwoofer of 70 W (2 ), be sure Ω

to connect the subwoofer to the violet and

violet/black leads of this unit. Do not connect

anything to the green and green/black leads.

English

Connections

Section

Connections

Product specificaties

Merk:	Pioneer
Categorie:	Multimedia
Model:	DVH-340UB
Kleur van het product:	Zwart
Ingebouwd display:	Ja
Bluetooth:	Nee
Ondersteund audioformaat:	AAC, MP3, WAV, WMA
Ondersteunde videoformaten:	DIVX, MP4, MPEG1, MPEG2
USB-poort:	Ja
Audiosysteem:	MOSFET
Aantal USB-aansluitingen:	1
FM-radio:	Ja
USB-versie:	2.0
Ondersteund beeldformaat:	JPG
Kleur van de verlichting:	Wit
Audio-uitgangskanalen:	4.0 kanalen
MP3 afspelen:	Ja
Playback disc formaten:	CD audio, CD video, VCD
AUX ingang:	Ja
Optische drive type:	CD, CD-R, CD-RW, DVD, DVD-R, DVD-RW
DVD player:	Ja
Ondersteunde frequentiebanden:	AM, FM
Aantal voorkeurszenders:	18
USB direct afspelen:	Ja
CD-R afspelen:	Ja
CD-RW afspelen:	Ja
Cd-speler:	Ja
Type beeldscherm:	LCD
Kleur toetsenverlichting:	Rood
DVD Audio playback:	Ja
Maximaal vermogen per kanaal:	50 W
CD Text:	Ja
Line outputs (RCA):	2
Pre out poort:	Ja
DVD Video playback:	Ja