Pioneer AVH-P7850DVD Handleiding

Pioneer Receiver AVH-P7850DVD

Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer AVH-P7850DVD (56 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/56
English Español Português (B) Italiano Nederlands
AVH-P7850DVD
INSTALLATION MANUAL
INSTALLATION MANUAL
This product conforms to new cord colors.
Los colores de los cables de este producto se conforman
con un nuevo código de colores.
As cores dos fios deste produto seguem um novo padrão
de cores.
1
Contents
Connecting the Units ................................ 1
Connecting the system ...................................... 3
Connecting the power cord (1) .......................... 5
Connecting the power cord (2) .......................... 7
When connecting to separately sold power
amp ............................................................ 9
When connecting with a rear view camera .... 11
When connecting the external video
component and the display ...................... 13
Installation ................................................ 15
Installing the hide-away unit .......................... 15
DIN Front/Rear-mount .................................... 16
DIN Front-mount ............................................ 16
DIN Rear-mount .............................................. 17
Installing the remote control unit .................... 18
WARNING:
To avoid the risk of accident and the
potential violation of applicable laws,
the front DVD or TV (sold separately)
feature should never be used while the
vehicle is being driven. Also, Rear
Displays should not be in a location
where it is a visible distraction to the
driver.
In some countries or states the viewing
of images on a display inside a vehicle
even by persons other than the driver
may be illegal. Where such regulations
apply, they must be obeyed and this
unit’s DVD features should not be used.
If this unit is used with more than a 6-ch
speaker system, be sure to connect the
yellow lead to the battery terminal
directly.
CAUTION:
PIONEER does not recommend that
you install or service your display your-
self. Installing or servicing the product
may expose you to risk of electric shock
or other hazards. Refer all installation
and servicing of your display to autho-
rized Pioneer service personnel.
Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
Do not drill a hole into the engine com-
partment to connect the yellow lead of
the unit to the vehicle battery. Engine
vibration may eventually cause the insu-
lation to fail at the point where the wire
passes from the passenger compartment
into the engine compartment. Take
extra care in securing the wire at this
point.
It is extremely dangerous to allow the
display lead to become wound around
the steering column or gearshift. Be sure
to install the display in such a way that
it will not obstruct driving.
Make sure that wires will not interfere
with moving parts of the vehicle, such as
the gearshift, parking brake or seat slid-
ing mechanism.
Do not shorten any leads. If you do, the
protection circuit may fail to work
properly.
Connecting the Units
English Español Deutsch Français Italiano Nederlands PyÒÒÍËÈ
2
Note:
This unit is for vehicles with a 12-volt battery and
negative grounding. Before installing it in a recre-
ational vehicle, truck, or bus, check the battery
voltage.
To avoid shorts in the electrical system, be sure to
disconnect the battery cable before beginning
installation.
Refer to the owner’s manual for details on
connecting the power amp and other units, then
make connections correctly.
Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake
and seat rails. Do not route wiring in places that
get hot, such as near the heater outlet. If the insu-
lation of the wiring melts or gets torn, there is a
danger of the wiring short-circuiting to the vehicle
body.
Don’t pass the yellow lead through a hole into the
engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
Do not shorten any leads. If you do, the protection
circuit may fail to work when it should.
Never feed power to other equipment by cutting
the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of
the lead will be exceeded, causing overheating.
When replacing the fuse, be sure to only use a
fuse of the rating prescribed on the fuse holder.
Since a unique BPTL circuit is employed, never
wire so the speaker leads are directly grounded or
the left and right speaker leads are common.
Speakers connected to this unit must be high-
power with minimum rating of 50 W and imped-
ance of 4 to 8 ohms. Connecting speakers with
output and/or impedance values other than those
noted here may result in the speakers catching
fire, emitting smoke, or becoming damaged.
When this product’s source is switched ON, a
control signal is output through the blue/white
lead. Connect to an external power amp’s system
remote control or the car’s Auto-antenna relay
control terminal (max. 300 mA 12 V DC). If the
car features a glass antenna, connect to the anten-
na booster power supply terminal.
When an external power amp is being used with
this system, be sure not to connect the blue/white
lead to the amp’s power terminal. Likewise, do
not connect the blue/white lead to the power ter-
minal of the auto-antenna. Such connection could
cause excessive current drain and malfunction.
To avoid a short-circuit, cover the disconnected
lead with insulating tape. Insulate the unused
speaker leads without fail. There is a possibility of
a short-circuit if the leads are not insulated.
To prevent incorrect connection, the input side of
the IP-BUS connector is blue, and the output side
is black. Connect the connectors of the same col-
ors correctly.
This unit cannot be installed in a vehicle that
does not have an ACC (accessory) position on
the ignition switch. (Fig. 1)
Fig. 1
The black lead is ground. Please ground this lead
separately from the ground of high-current prod-
ucts such as power amps.
If you ground the products together and the
ground becomes detached, there is a risk of dam-
age to the products or fire.
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
Cords for this product and those for other prod-
ucts may be different colors even if they have
the same function. When connecting this product
to another product, refer to the supplied manuals
of both products and connect cords that have the
same function.


Product specificaties

Merk: Pioneer
Categorie: Receiver
Model: AVH-P7850DVD

Heb je hulp nodig?

Als je hulp nodig hebt met Pioneer AVH-P7850DVD stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Pioneer

Handleiding Receiver

Nieuwste handleidingen voor Receiver