Philips Series 300 S300 Handleiding

Philips Scheerapparat Series 300 S300

Lees hieronder de šŸ“– handleiding in het Nederlandse voor Philips Series 300 S300 (15 pagina's) in de categorie Scheerapparat. Deze handleiding was nuttig voor 47 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/15
- Do not use the appliance in the bath
or in the shower.
- Never use water hotter than 60Ā°C to
rinse the shaver.
- Do not use the appliance, adapter or
any other part if it is damaged, as this
may cause injury. Always replace a
damaged adapter or part with one of
the original type.
- Never use compressed air, scouring
pads, abrasive cleaning agents or
aggressive liquids such as petrol or
acetone to clean the appliance.
- Water may drip from the socket at the
bottom of the shaver when you rinse
it. This is normal and not dangerous
because all electronics are enclosed in
a sealed power unit inside the shaver.
- Use and store the appliance at a
temperature between 5Ā°C and 35Ā°C.
- The appliance complies with the
internationally approved IEC safety
regulations and can be safely cleaned
under the tap (Fig. 4).
- This Philips appliance complies with all
applicable standards and regulations
regarding exposure to electromagnetic
īƒ€elds.
- The adapter is equipped with an
automatic voltage selector and is
suitable for mains voltages ranging from
100 to 240 volts.
- The adapter transforms 100-240 volts
to a safe low voltage of less than
24 volts.
Make sure the shaver is switched off when
you start to charge it.
When you charge the shaver for the īƒ€rst
time or after a long period of non-use, let it
charge continuously for 12 hours. Charging
normally takes 10 hours.
Charge the appliance when the motor
stops or starts running slower.
For optimal performance, only charge the
shaver when the battery is low.
,
Congratulations on your purchase and
welcome to Philips! To fully beneīƒ€t from
the support that Philips offers, register your
product at .
1 Protection cap
2 Shaving heads
3 Shaving unit
4 Hair chamber
5 Handle
6 On/off slide
7 Socket for small plug
8 Wheel for retaining frame
9 Retaining frame
10 Cutter
11 Guard
12 Release button
13 Cleaning brush
14 Adapter
15 Charging light
16 Small plug
Read this important information carefully
before you use the appliance and save it for
future reference.
- Keep the adapter dry (Fig. 2).
- The adapter contains a transformer.
Do not cut off the adapter to replace
it with another plug, as this causes a
hazardous situation.
- This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
- Children should be supervised to
ensure that they do not play with the
appliance.
- Always unplug the appliance before
you clean it under the tap.
- Never immerse the appliance in
water (Fig. 3).
A fully charged shaver has a cordless shaving
time of approximately 45 (S360), 30 (S331,
S330, S321) or 20 (S311, S301, S300)
minutes.
Your īƒ€rst shaves may not bring you the
result you expect and your skin may even
become slightly irritated. This is normal.
Your skin and beard need time to adapt to
any new shaving system. We advise you to
shave regularly (at least 3 times a week)
with this shaver for a period of 3 weeks to
allow your skin to adapt to the new shaver.
S360, S330, S331, S321,
S311, S301, S300
Clean the shaver after every shave to
guarantee better shaving performance.
For the best cleaning result, we advise you
to use Philips Cleaning Spray (HQ110).
Ask your Philips dealer for information.
Keep the appliance dry.
Store the appliance in a safe, dry place.
Replace the shaving heads every two years
for optimal shaving results.
Replace damaged or worn shaving heads
with Philips shaving heads only.
For instructions on how to remove the
shaving heads, see chapter ā€˜Cleaning and
maintenanceā€™, section ā€˜Every two months:
shaving headsā€™.
To buy accessories or spare parts, visit
or go
to your Philips dealer. You can also contact
the Philips Consumer Care Centre in your
country (see the worldwide guarantee
leaīƒet for contact details).
To retain the top performance of your
shaver, make sure you clean it regularly
and replace its shaving heads at the
recommended time.
- We advise you to replace your shaving
heads every two years. Always replace
them with Philips shaving heads
only (Fig. 21).
- Use Philips Cleaning Spray (HQ110) to
clean the shaving heads thoroughly.
Do not throw away the appliance with the
normal household waste at the end of its
life, but hand it in at an ofīƒ€cial collection
point for recycling. By doing this, you help to
preserve the environment.
If you need information or support, please
visit or read
the separate worldwide guarantee leaīƒet.
The shaving heads (cutters and guards)
are not covered by the terms of the
international guarantee because they are
subject to wear.
This chapter summarises the most common
problems you could encounter with the
appliance. If you are unable to solve the
problem with the information below, visit
for a list of
frequently asked questions or contact the
Consumer Care Centre in your country.
The
shaver
does not
shave as
well as it
used to.
The shaving
heads are
dirty. You
have not
cleaned the
shaver well
enough or
you have
not cleaned
it for a long
time.
Clean the
shaving heads
thoroughly
before you
continue
shaving.
See chapter
ā€˜Cleaning and
maintenanceā€™.
Long
hairs ob-
struct the
shaving
heads.
Clean the
cutters and
guards with
the clean-
ing brush
supplied.
See chapter
ā€˜Cleaning and
maintenanceā€™,
section ā€˜Every
two months:
shaving headsā€™.
You mixed
up the
cutters
and guards
when you
placed them
back into
the retaining
frame after
cleaning.
Put each
cutter in the
other guard.
If you do not
switch the
cutters, it
may take 2
to 3 weeks
until optimal
shaving
performance
is restored.
The shaving
heads are
damaged or
worn.
Replace the
shaving heads.
See chapter
ā€˜Replacementā€™.
The
shaver
does not
work
when
I push
the on/
off slide
upwards.
The re-
chargeable
battery is
empty.
Recharge
the battery.
See chapter
ā€˜Chargingā€™.
My
skin is
irritated
after
shaving.
Your skin
needs time
to get used
to the
Philips shav-
ing system.
Skin irritation
during the
īƒ€rst 2-3
weeks of use
is possible.
After this
period, the
skin irritation
usually disap-
pears.
The
rotation
speed of
the shav-
ing heads
is slower
than
usual.
Too much
dirt has
collected in
the shaving
heads.
Clean the
shaving heads.
See chapter
ā€˜Cleaning and
maintenanceā€™.
The re-
chargeable
battery is
low.
Recharge
the battery.
See chapter
ā€˜Chargingā€™.
The
appliance
makes a
strange
noise.
Too much
dirt has
collected in
the shaving
heads.
Clean the
shaving heads.
After cleaning,
lubricate
the central
point on the
inside of the
guards with
Philips Clean-
ing Spray
(HQ110).
See chapter
ā€˜Cleaning and
maintenanceā€™.
The shaving
heads are
damaged or
worn.
Replace the
shaving heads.
See chapter
ā€˜Replacementā€™.


Product specificaties

Merk: Philips
Categorie: Scheerapparat
Model: Series 300 S300

Heb je hulp nodig?

Als je hulp nodig hebt met Philips Series 300 S300 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Scheerapparat Philips

Handleiding Scheerapparat

Nieuwste handleidingen voor Scheerapparat