Philips S300 Handleiding

Philips Scheerapparat S300

Lees hieronder de 📖 handleiding in het Nederlandse voor Philips S300 (15 pagina's) in de categorie Scheerapparat. Deze handleiding was nuttig voor 78 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/15

- Do not use the appliance in the bath

or in the shower.

- Never use water hotter than 60°C to

rinse the shaver.

- Do not use the appliance, adapter or

any other part if it is damaged, as this

may cause injury. Always replace a

damaged adapter or part with one of

the original type.

- Never use compressed air, scouring

pads, abrasive cleaning agents or

aggressive liquids such as petrol or

acetone to clean the appliance.

- Water may drip from the socket at the

bottom of the shaver when you rinse

it. This is normal and not dangerous

because all electronics are enclosed in

a sealed power unit inside the shaver.

- Use and store the appliance at a

temperature between 5°C and 35°C.

- The appliance complies with the

internationally approved IEC safety

regulations and can be safely cleaned

under the tap (Fig. 4).

- This Philips appliance complies with all

applicable standards and regulations

regarding exposure to electromagnetic

elds.

- The adapter is equipped with an

automatic voltage selector and is

suitable for mains voltages ranging from

100 to 240 volts.

- The adapter transforms 100-240 volts

to a safe low voltage of less than

24 volts.

Make sure the shaver is switched off when

you start to charge it.

When you charge the shaver for the rst

time or after a long period of non-use, let it

charge continuously for 12 hours. Charging

normally takes 10 hours.

Charge the appliance when the motor

stops or starts running slower.

For optimal performance, only charge the

shaver when the battery is low.

Congratulations on your purchase and

welcome to Philips! To fully benet from

the support that Philips offers, register your

product at .

1 Protection cap

2 Shaving heads

3 Shaving unit

4 Hair chamber

5 Handle

6 On/off slide

7 Socket for small plug

8 Wheel for retaining frame

9 Retaining frame

10 Cutter

11 Guard

12 Release button

13 Cleaning brush

14 Adapter

15 Charging light

16 Small plug

Read this important information carefully

before you use the appliance and save it for

future reference.

- Keep the adapter dry (Fig. 2).

- The adapter contains a transformer.

Do not cut off the adapter to replace

it with another plug, as this causes a

hazardous situation.

- This appliance is not intended for use

by persons (including children) with

reduced physical, sensory or mental

capabilities, or lack of experience and

knowledge, unless they have been given

supervision or instruction concerning

use of the appliance by a person

responsible for their safety.

- Children should be supervised to

ensure that they do not play with the

appliance.

- Always unplug the appliance before

you clean it under the tap.

- Never immerse the appliance in

water (Fig. 3).

A fully charged shaver has a cordless shaving

time of approximately 45 (S360), 30 (S331,

S330, S321) or 20 (S311, S301, S300)

minutes.

Your rst shaves may not bring you the

result you expect and your skin may even

become slightly irritated. This is normal.

Your skin and beard need time to adapt to

any new shaving system. We advise you to

shave regularly (at least 3 times a week)

with this shaver for a period of 3 weeks to

allow your skin to adapt to the new shaver.

S360, S330, S331, S321,

S311, S301, S300

Clean the shaver after every shave to

guarantee better shaving performance.

For the best cleaning result, we advise you

to use Philips Cleaning Spray (HQ110).

Ask your Philips dealer for information.

Keep the appliance dry.

Store the appliance in a safe, dry place.

Replace the shaving heads every two years

for optimal shaving results.

Replace damaged or worn shaving heads

with Philips shaving heads only.

For instructions on how to remove the

shaving heads, see chapter ‘Cleaning and

maintenance’, section ‘Every two months:

shaving heads’.

To buy accessories or spare parts, visit

or go

to your Philips dealer. You can also contact

the Philips Consumer Care Centre in your

country (see the worldwide guarantee

leaet for contact details).

To retain the top performance of your

shaver, make sure you clean it regularly

and replace its shaving heads at the

recommended time.

- We advise you to replace your shaving

heads every two years. Always replace

them with Philips shaving heads

only (Fig. 21).

- Use Philips Cleaning Spray (HQ110) to

clean the shaving heads thoroughly.

Do not throw away the appliance with the

normal household waste at the end of its

life, but hand it in at an ofcial collection

point for recycling. By doing this, you help to

preserve the environment.

If you need information or support, please

visit or read

the separate worldwide guarantee leaet.

The shaving heads (cutters and guards)

are not covered by the terms of the

international guarantee because they are

subject to wear.

This chapter summarises the most common

problems you could encounter with the

appliance. If you are unable to solve the

problem with the information below, visit

for a list of

frequently asked questions or contact the

Consumer Care Centre in your country.

The

shaver

does not

shave as

well as it

used to.

The shaving

heads are

dirty. You

have not

cleaned the

shaver well

enough or

you have

not cleaned

it for a long

time.

Clean the

shaving heads

thoroughly

before you

continue

shaving.

See chapter

‘Cleaning and

maintenance’.

Long

hairs ob-

struct the

shaving

heads.

Clean the

cutters and

guards with

the clean-

ing brush

supplied.

See chapter

‘Cleaning and

maintenance’,

section ‘Every

two months:

shaving heads’.

You mixed

up the

cutters

and guards

when you

placed them

back into

the retaining

frame after

cleaning.

Put each

cutter in the

other guard.

If you do not

switch the

cutters, it

may take 2

to 3 weeks

until optimal

shaving

performance

is restored.

The shaving

heads are

damaged or

worn.

Replace the

shaving heads.

See chapter

‘Replacement’.

The

shaver

does not

work

when

I push

the on/

off slide

upwards.

The re-

chargeable

battery is

empty.

Recharge

the battery.

See chapter

‘Charging’.

skin is

irritated

after

shaving.

Your skin

needs time

to get used

to the

Philips shav-

ing system.

Skin irritation

during the

rst 2-3

weeks of use

is possible.

After this

period, the

skin irritation

usually disap-

pears.

The

rotation

speed of

the shav-

ing heads

is slower

than

usual.

Too much

dirt has

collected in

the shaving

heads.

Clean the

shaving heads.

See chapter

‘Cleaning and

maintenance’.

The re-

chargeable

battery is

low.

Recharge

the battery.

See chapter

‘Charging’.

The

appliance

makes a

strange

noise.

Too much

dirt has

collected in

the shaving

heads.

Clean the

shaving heads.

After cleaning,

lubricate

the central

point on the

inside of the

guards with

Philips Clean-

ing Spray

(HQ110).

See chapter

‘Cleaning and

maintenance’.

The shaving

heads are

damaged or

worn.

Replace the

shaving heads.

See chapter

‘Replacement’.

Product specificaties

Merk:	Philips
Categorie:	Scheerapparat
Model:	S300
Kleur van het product:	Black,White
Stroombron:	Batterij/Accu
LED-indicatoren:	Bezig met opladen
Oplaadtijd:	10 uur
Waterdicht:	Ja
Stroomverbruik (in standby):	0.1 W
Vermogensverbruik (max):	1 W
Levensduur accu/batterij:	20 uur
Groene oplaadindicator (LED):	Ja
Accu gestuurd:	Ja
Gebruikstijd:	20 min
Scheersysteem:	Roterend scheerapparaat
Trimmer:	Nee
Aantal scheerkoppen/bladen:	2
Wasbaar:	Ja
Reinigingsborsteltje:	Ja
Oplaadbaar:	Ja
Vervangingsperiode scheerkop:	2 jaar
Afzonderlijk zwevende scheerkop:	Ja
Reserve scheerkop:	SH30
Beschermende caps:	Ja
Zelfslijpend mes:	Ja
Reflex Action-systeem:	Ja
AC-ingangsspanning:	100-240 V
Batterijtechnologie:	Nikkel-Metaalhydride (NiMH)