Peerless-AV XHB554 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Peerless-AV XHB554 (24 pagina's) in de categorie Televisie. Deze handleiding was nuttig voor 5 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24
12022-07-06 #:180-9147-1
ENG
Installation Guideline
For XHB554
22022-07-06 #:180-9147-1
Electrical Code
Note: To the display system installer: This reminder is provided to call attention to Article 820-44 of the National
Electric Code that provides guidelines for proper grounding and, in particular, speciîš¿es that the cable ground shall
be connected to the grounding system of the facility. Outlet shall be installed near the equipment and shall be easily
accessible.
SYSTEM INSTALLATION AND ELECTRICAL REQUIREMENTS
Antenna discharge unit
(NEC Section 810-20)
NEC National Electric Code
Ground clamp
Electric service
equipment
Ground clamps
Power service grounding
electrode system
(NEC Art 250 Part H)
Grounding conductors
(NEC Section 810-21)
Antenna lead-in wire
Power Source
The display must be connected to a mains socket outlet with a protective grounding connection.
The mains plug is used as the disconnect device and shall remain readily accessible.
Electrical installation shall be in accordance with the applicable parts of Chapter 8 of ANSI/NFPA 70.
An outdoor antenna should not be located near overhead electrical lines or any electrical circuits.
If an outside antenna is connected to the receiver, conîš¿rm that the antenna system is grounded to protect against
voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No 70-1984,
provides information with respect to proper grounding for the mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of grounding connectors, location of antenna discharge unit, connection to
grounding electrodes and requirements for the grounding electrode.
This display operates on 100-240 volts 50-60 Hz, AC current. Never connect the display to direct current or anything
other than the speciîš¿ed voltage.
To prevent electric shock from the display, do not use with an extension cord, receptacle, or other outlet unless the
blades and ground terminal can be fully inserted to prevent blade exposure.
All secondary lines must be routed through grounded conduit and kept separate from AC line.
Note: Installation shall incorporate UL Listed external surge protection rated 2500 Vpk or less, for 150 to 300 Vac
mains, installed in accordance with Article 285 of ANSI/NFPA 70 or applicable local codes.
32022-07-06 #:180-9147-1
Relevant Information
Record your display's model and serial number here for future reference. Keep this user manual in an accessible
location in the event service is required. Note: Your display's serial number can be found on the box, underneath the
rear cover plate, and in the Setup Menu under Peerless-AV Technical Support.
Model Number ____________________________________
Serial Number ____________________________________
FCC CAUTION
To assure continued compliance and possible undesirable interference, ferrite cores may be used when connecting
this display to video equipment; maintain at least 400mm (15.75 inches) spacing to other peripheral devices.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rule. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with these instructions, may cause harmful interference to radio communications; however,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o󰀨 and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit di󰀨erent from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/display technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.


Product specificaties

Merk: Peerless-AV
Categorie: Televisie
Model: XHB554

Heb je hulp nodig?

Als je hulp nodig hebt met Peerless-AV XHB554 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Televisie Peerless-AV

Handleiding Televisie

Nieuwste handleidingen voor Televisie

TCL

TCL 75S551G Handleiding

18 December 2024
TCL

TCL 55S551G Handleiding

18 December 2024
TCL

TCL 75QM851G Handleiding

18 December 2024
TCL

TCL 65S551G Handleiding

18 December 2024
TCL

TCL 65QM751G Handleiding

18 December 2024
Engel

Engel LE3285SM Handleiding

18 December 2024
TCL

TCL 85QM851G Handleiding

18 December 2024
TCL

TCL 85S551G Handleiding

18 December 2024