Overmax Multipic 3.1 Handleiding
Overmax
Beamer projector
Multipic 3.1
Lees hieronder de 📖 handleiding in het Nederlandse voor Overmax Multipic 3.1 (88 pagina's) in de categorie Beamer projector. Deze handleiding was nuttig voor 47 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/88
English
Warning:
Before using this projector, please read the manual carefully. Any wrong
operation may cause electric shock or fire. Please comply with the following
instructions when using and/or repairing the projector.
1. Clean
When clean this projector, please unplug the power cable and use the wet cloth
not the cleanser.
2. Accessories
Please use the recommended accessories or the projector maybe damaged.
3. Using environment
Do not place the projector on any wet environments.
4. Installation
Please place this projector on a stable surface
5. Ventilation
For best performance, please clean the filter once a month.
6. Power
Before plug in the power, please make sure the voltage of your area matches
this projector (220V or 110V).
7. Ground wire
The three pin plug is the ground wire of this projector.
8. Protect the power cable
Make sure the power cable is in perfect working condition before using it.
9.
Thunder
When there is thunder or not using
the projector for a long period of time , unplug the power cable.
10.
Repair
Due to high voltage, do not open or try to repair the projector by yourself.
Refer to a professional technician if repair is needed.
11. Heat
Make sure not to put this projector near any heating devices. That may
shorten the life span of the projector.
English
About the installation
In order to improve this projector's life span, do not place it on a wet surface.
Do not put the projector under the direct sun light.
Projector working temperature: 0°C - +50 °C
Projector store temperature : -20°C - +50 °C
Do not block the ventilation-window of the projector. If the projector
interior temperature is too hot, it will be automatically shut down. This will
protect the projector. To prevent over heating the projector, please clean
the filter once a month.
About turn on/off the projector
To turn on the projector, connect the power cable, then press the "power" key
on the panel. It will take couple of minutes before the lamp works normally.
To turn off the projector, press the "power" key again. The lamp will shut
off while the fan will still working for a little longer. The projector will shut off
automatic--ally when the fan stops. DO NOT unplug the power cable before
turn off the projector.
Warning:
The fan is to keep the projector's temperature low. It will turn on when projector
is turned on. The speed of the fan is according to the heat of the projector. Do
not unplug the power cable when the projector is not turned off and the fan
is still working. If the fan stops working, the projector may be damaged due to
overheat.
Troubleshooting
Problem
The possible causes
When turn on the
power, the indicator light
does not work
•
power cable did not connect well.
•
the power switch fuse is broken
The remote control
cannot turn on the
projector.
•
the power switch is turned off
•
the remote control has no batteries or
the batteries are low
•
the remote control does not aim at the
IR
point
No Image
• the choice of the input source may not be
correct
• no input signal
• the input cable is not connected
• if under PC mode, the PC output frequency is
not 50-60Hz. Make sure that the PC output is
connected with the projector.
Auto-off after use some
times
•
the projector ventilation is blocked
•
the voltage is not stable
•
the projector is overheated, check if the fan
is broken
Product specificaties
| Merk: | Overmax |
| Categorie: | Beamer projector |
| Model: | Multipic 3.1 |
Heb je hulp nodig?
Als je hulp nodig hebt met Overmax Multipic 3.1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Beamer projector Overmax
9 Januari 2023
Handleiding Beamer projector
- Beamer projector Philips
- Beamer projector HP
- Beamer projector Sony
- Beamer projector Casio
- Beamer projector Panasonic
- Beamer projector Epson
- Beamer projector Canon
- Beamer projector JVC
- Beamer projector Medion
- Beamer projector Toshiba
- Beamer projector Yamaha
- Beamer projector Aaxa
- Beamer projector Acer
- Beamer projector Aiptek
- Beamer projector Apeman
- Beamer projector Auna
- Beamer projector Bauer
- Beamer projector BenQ
- Beamer projector Brookstone
- Beamer projector Dell
- Beamer projector DreamVision
- Beamer projector Eiki
- Beamer projector Eumig
- Beamer projector FengMi Wemax
- Beamer projector Fenton
- Beamer projector Ibm
- Beamer projector InFocus
- Beamer projector Kodak
- Beamer projector La Vague
- Beamer projector Legamaster
- Beamer projector Mitsubishi
- Beamer projector Nebula
- Beamer projector Nec
- Beamer projector Nobo
- Beamer projector Nor-tec
- Beamer projector Sagem
- Beamer projector Sanyo
- Beamer projector Skytronic
- Beamer projector Stereoboomm
- Beamer projector Viewsonic
- Beamer projector Vivitek
- Beamer projector XGIMI
- Beamer projector Optoma
Nieuwste handleidingen voor Beamer projector
28 September 2024
7 Januari 2024
22 September 2023
31 Augustus 2023
27 Augustus 2023
31 Augustus 2023
27 Augustus 2023
31 Augustus 2023
31 Augustus 2023
31 Augustus 2023