Omega OCG63XB1 Handleiding

Omega Fornuis OCG63XB1

Lees hieronder de 📖 handleiding in het Nederlandse voor Omega OCG63XB1 (12 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/12
INSTRUCTIONS FOR THE INSTALLATION AND USE
OF BUILT-IN HOT PLATES
OCG63X / OCG63FX
OCG75X / OCG75FX
OCG90X / OCG90FX
omegaappliances.com.au . Always serves you well.
attaccare qui
copia targhetta segnaletica
OCG63XB / OCG63FXB
OCG75XB / OCG75FXB
OCG90XB / OCG90FXB
2
IMPORTANT SAFETY INSTRUCTION
We invite you to read this instruction booklet carefully, before installing and using the equipment.
It is very important that you keep this booklet together with the equipment for any future
consultation.
If this equipment should be sold or transferred to another person, make sure that the new
user receives the booklet, so that they can learn how to operate the appliance and read the
corresponding notice.
This is a Class 3 appliance.
WARNING
– The installation must be carried out by authorised personnel, in conformity with the regulations in force.
–CAUTION: The surface temperature of underbench components exceeds 95°C. To avoid a hazard,
underbench access must be restricted. Refer to the installation instructions.
– This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
– Children should be supervised to ensure that they do not play with the appliance.
– Before powering the equipment, check that it is properly adjusted for the type of gas at disposal (see the
“installation” paragraph).
– If the supply cord is damaged it must be replaced by a special cord or assembly available from the
manufacturer or its service agent.
– Before carrying out the maintenance or cleaning the equipment, cut off power supply and allow it cool
down.
– Make sure that air circulates around the gas equipment. Insufficient ventilation produces a lack of oxygen.
– In case of an intense or prolonged use of the equipment, it may be necessary to improve aeration, for
example by opening a window or increasing rangehood venting power, if it exists.
– The products of combustion must be discharged outside through a suction hood or an electric fan (see
the “installation” paragraph).
– For any possible operation or modification, apply to an authorized Technical Assistance Centre and
demand original spare parts.
– Where this appliance is installed in marine craft or in caravans, it shall not be used as a space heater.
– Not for use in marine craft, caravans or mobile homes unless each burner is fitted with a flame safeguard.
– Do not spray aerosols in the vicinity of the appliance while it is in operation.
– Do not store or use flammable materials or items in the vicinity of this appliance.
DO NOT MODIFY THIS APPLIANCE.
Servicing shall be carried out only by authorised personnel.
The product label, with the serial number, is fixed to the underside of hob.
An additional label should be adhered to adjacent cabinetry for easy access- refer installation
instructions.
The manufacturer refuses all responsibility for possible damages to things or people, resulting
from incorrect installation or from an improper, incorrect or unreasonable use of this equipment.
3
It is necessary that all the operations regarding the installation, adjustment and
adaptation to the type of gas available are carried out by authorised personnel, in
conformity with the regulations in force. The specific instructions are described in the
booklet section intended for the installer.
Conditions of Use.
This appliance is intended to be used in household and similar applications such as:
- Staff kitchen areas in shops, ofces and other working environments
- Farm Houses
- By clients in hotels, motels and other residential type environments
- Bed and breakfast type environment
INSTRUCTIONS FOR THE USER
USING THE BURNERS
The symbols silk-screen printed on the side of the
knob indicate the correspondence between the
knob and the burner.
Automatic start-up with valves
Turn the corresponding knob anticlockwise up
to the maximum position (large flame, fig. 1) and
press the knob.
Once the burner has been started up, keep the
knob pressed for about 6 seconds.
ATTENTION: the triple ring burner switches on
only in the maximum flame position
Using the burners
In order to obtain the maximum yield without
waste of gas, it is important that the diameter of
the pot is suitable for the burner potential (see the
following table), so as to avoid that the flame going
out (fig. 2).
Use the maximum capacity to quickly make
liquids reach boiling temperature, and the reduced
capacity to heat food or maintain boiling. All of the
operating positions must be chosen between the
maximum and the minimum ones, never between
the minimum position and the closing point.
The gas supply can be interrupted by turning
the knob clockwise up to the closing position. If
there is no power supply, it is possible to light the
burners with matches, setting the knob to the start-
up point (large flame, fig. 1).
BURNERS Power (MJ/h) Ø of
cookware (*)
NG LPG
Auxiliary 3,4 3,4 10 - 14 cm
Semi-rapid 6,3 5,6 16 - 18 cm
Rapid 11,5 9,6 20 - 22 cm
Triple crown 13,0 12,0 24 - 26 cm
Double crown 12,5 12,5 24 - 26 cm
(*) For cookware with diameter 120mm or
below use mini-trivet supplied, refer fitment
instructions on page 12.
It is important to use cookware with the sizes
specified and ensure the cookware is always
correctly centred over the burner. Using
oversize cookware can potentially cause heat
damage to your benchtop and/or control knobs
which will not be covered under warranty.
Notice
– When the equipment is not working, always
check that the knobs are in the closing position
(see fig.1).
– If the flame should blow out accidentally, the
safety valve will automatically stop the gas
supply, after a few seconds. To restore operation,
set the knob to the lighting point (large flame,
fig.1) and press.
– While cooking with fat or oil, pay the utmost
attention as these substances can catch fire
when overheated.
– Do not place unstable or deformed pots on the
burner, so as to prevent them from overturning or
overflowing.
– Handles should be turned away from the front of
the bench to avoid accidents.
– When the burner is started up, check that the
flame is regular and, before taking pots away,
always lower the flame or put it out.

Product specificaties

Merk: Omega
Categorie: Fornuis
Model: OCG63XB1

Heb je hulp nodig?

Als je hulp nodig hebt met Omega OCG63XB1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis Omega

Omega

Omega OCI302TCOM Handleiding

18 Oktober 2024
Omega

Omega OCC302TCOM Handleiding

18 Oktober 2024
Omega

Omega OCI603KZCOM Handleiding

18 Oktober 2024
Omega

Omega OCI604TCOM Handleiding

18 Oktober 2024
Omega

Omega OCG604WXCOM Handleiding

18 Oktober 2024
Omega

Omega OCC604KCOM Handleiding

18 Oktober 2024
Omega

Omega OCC302KCOM Handleiding

18 Oktober 2024
Omega

Omega OCI604TZ Handleiding

22 Augustus 2024
Omega

Omega OCI604PPTZ Handleiding

22 Augustus 2024
Omega

Omega OCC604KZ Handleiding

22 Augustus 2024

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

Café

Café CEP90362TSS Handleiding

4 Januari 2025
Amica

Amica 58EE1.20(W) Handleiding

4 Januari 2025
Hotpoint

Hotpoint HS68M8PCX Handleiding

4 Januari 2025
Bertazzoni

Bertazzoni PRO95I1EGIT Handleiding

4 Januari 2025
Bertazzoni

Bertazzoni PRO95I1EROT Handleiding

4 Januari 2025
Bertazzoni

Bertazzoni PRO95I1ENET Handleiding

4 Januari 2025
Bertazzoni

Bertazzoni PRO96L1EBIT Handleiding

4 Januari 2025
Bertazzoni

Bertazzoni PRO96L1EART Handleiding

4 Januari 2025
Bertazzoni

Bertazzoni PRO96L1EGIT Handleiding

4 Januari 2025
Berg

Berg BRGS 405 Handleiding

3 Januari 2025