Oasis D270LXA Handleiding

Oasis Ontvochtiger D270LXA

Lees hieronder de 📖 handleiding in het Nederlandse voor Oasis D270LXA (2 pagina's) in de categorie Ontvochtiger. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/2
032061-012 RevOrig
DEHUMIDIFIER OWNER'S MANUAL AND WARRANTY
Export Model Series: evolution 140LX, 220LX, 270LX
How to Use Your Dehumidifier
Choosing a Location:
1. Use the dehumidier in any enclosed room or area such as a
workshop, basement, or living area where you want moisture
removed. For best results, keep all doors and windows
closed.
2. Good airow is essential for dehumidifying. Make sure there
is at least 15 cm of space between the rear of the
dehumidier and any wall or other obstruction such as
furniture or appliances.
3. The dehumidier should be in an upright position and on a
level surface.
4. The dehumidier has four casters for ease of movement.
5. These dehumidiers are built for free-standing use only and
are not designed to be built in.
Operating your dehumidier:
1. Check the available power supply against the dehumidier
data plate to assure correct electrical service. Plug power
cord into grounded wall outlet.
2. The Humidistat Knob should be securely tted to the
exposed stem on the front Grille. The Knob is packed in a
bag stapled around the power cord in the receptor bucket. All
models are equipped with an automatic humidstat control
that will switch the dehumidier on and o to maintain the
chosen humidity level. When you operate the dehumidier
for the rst time in a particular area, set the humidistat dial
on mid-point. Allow the dehumidier to operate at this setting
for two or three days.
3. Models140lX, 220LX, 270LX are equipped with an automatic
system to defrost the evaporator coils. This condition usually
happens during the fall, winter or spring months when both
the room temperature is below 18°C and the amount of
moisture is below 60%. When the frost builds up on the coils,
a control shuts o the compressor but allows the fan to
continue to run. After the coil has been defrosted, the control
turns the compressor on for normal operation.
Disposal of water:
All models are equipped with a 9-1/2 litre capacity water receptor
and an automatic shut-o system to prevent overow when the
receptor gets full. When the water in the receptor rises to a certain
level, a oat switch shuts o the system and turns on the red light
on the front panel. The receptor should then be removed and
emptied. You will notice that when the receptor is removed, the
system will again begin operating, unless the control dial has
been turned to the "OFF" position.
To empty the receptor, turn the control dial to the "OFF" position.
Take hold of the receptor with both hands and carefully slide it out.
Empty the water and replace the receptor in the dehumidier.
Turn the control dial to your desired setting.
Use of the tting on the drip tray - When you remove the water
receptor, you will notice that there is a threaded tting on the
bottom of the drip tray. This is made for the attachment of a
standard garden hose that can continuously drain the water from
the drip tray into a oor drain. When you connect the hose tting
to the drip tray, it should turn easily. Do not force the hose tting
onto the drip tray as it could damage the threads. Make sure the
drain hose is below the level of the drip tray or it will not drain
properly. If you place the dehumidier directly over a oor drain, a
short piece of hose is required to direct the water into the drain or
it will drip on the dehumidier frame and splash out onto the oor.
Do not throw away the receptor. You may need it to umidify deh
an area that does not have a oor drain.
Service and maintenance:
For your protection, always disconnect the service cord from the
electrical outlet and remove the water receptor before starting
service and/or maintenance.
1. Cleaning the cabinet - Wipe the exterior with a soft, damp
cloth. Do not use solvents or cleaning agents. Dust may be
removed with the brush attachment of a vacuum cleaner.
2. Cleaning the air lter - Remove air lter from rear of unit by
pushing "arrow indicators" gently inwards, remove lter.
Brush lightly or wash in warm sudsy water.
3. Cleaning the water receptor - Wash in warm sudsy water.
Rinse and dry.
4. Storage - Thoroughly clean and dry the dehumidier. Cover
and store in a clean, dry area.
5. Service hint - To save yourself unnecessary expense, make
the following checks before delivering your dehumidier to a
service centre.
A. Insucient moisture removal - little or no water collection.
1. Poor air circulation - See "Choosing a location"
paragraph 2.
2. Room temperature and relative humidity See –
"Operating your dehumidier" paragraph 3.
B. Runs continuously.
1. Check humidistat control setting. Is it on "Max Dry"?
2. Are windows and doors closed?
3. Is area too large for the capacity of your unit?
C. Dehumidier will not start.
1. Check control dial.
2. Check outlet. Plug a lamp or other appliance into outlet to
make certain power is available.
3. Check fuse or circuit breaker.
4. If using an extension cord, make sure it is good by
checking it with other appliances.
Replacement of the power cord should only be carried
out by properly trained and equipped personal, or return
the Dehumidier to the dealer.
Electrical Information:
1. Available power supply must agree with that listed on the
dehumidier data plate. If an extension cord is used at any
time, it should be suitably rated, taking account of the rating
as specied on the rear of the unit.
2. Never operate a dehumidier in an environment where it is
likely that standing water will accumulate around the unit. If
this condition should occur, FOR YOUR SAFETY, UNPLUG
THE SERVICE CORD before stepping into the water
accumulated around the dehumidier.
3. DO NOT operate the dehumidier if it is in a damaged
condition.
4. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a suitably qualied
person in order to avoid a hazard.
032061-012 RevOrig
Dehumidier Export Warranty.
For the year after purchase: Manufacturer, through its authorized
distributor organization will replace any part of said Dehumidier
which is found to be defective. This warranty includes freight, or
postage only for parts from the factory to port of embarkation.
The customer will pay for: pickup and delivery of the Dehumidier
to a Service Agency for diagnosis and service; All costs for labour
and transportation.
For the second through fth year following expiration of the -one
year warranty period; Manufacturer, through its authorized
distributor organization will replace any part of said Dehumidier
sealed refrigeration system, which is found to be defective. This
warranty includes freight or postage only for parts from the factory
to port of embarkation. The customer will pay for: pickup and
delivery of the Dehumidifier to Service Agency for diagnosis and
service; Analysis charge for determining defects; All costs for
labour and transportation.
Only service and parts obtained from manufacturer`s authorized
distributor are covered by this warranty. It does not cover normal
responsibilities of the user.
Warning:
This warranty for this machine is automatically voided if this
machine is altered, modied, or combined with any other machine
or device. Alteration or modication of this machine may cause
serious ooding and/or hazardous electrical shock or re.
Except as set forth herein, the Manufacturer makes no other
warranty, guarantee or agreement expressed, implied or statutory,
including any implied warranty of merchantability or tness for a
particular purpose.
Normal responsibilities of the user:
1. Use of the machine in accordance with instructions in the
customer`s manual.
2. Proper installation in accordance with printed instructions.
3. Any damage to finish after installation.
4. Cleaning of condenser or evaporator coils.
5. Service required due to Acts of God. oods, fire, alteration,
abuse or misuse.
6. Connection to power supply of proper voltage as shown on
date plate, replacement of blown fuses (the fuse to be of
similar type and rating), repair of any loose connections or
defects in wiring that is part of the building power supply.
The user should keep a copy of the bill of sale, cancelled check,
or payment record, verifying purchase date to validate this
guarantee.
There are no other warranties expressed or implied, covering this
appliance, except this warranty which is in lieu of all other
warranties including any implied warranty of merchantability or
tness for a particular purpose. In no event shall the manufacturer
be liable for special indirect or consequential damages, nor for
any delay in the performance of this warranty due to cause
beyond its control.
The manufacturer authorizes no other person to change or add to
any of the obligations hereunder.
For Customer Service and Technical
Helpline assistance call:
+353 96 71222
Web-site - www.oasis.ie
E Mail info@oasis.ie
Oasis East Sp. z o.o.
ul. Gutenberga 20
44-146 Gliwice
Poland
OASIS Ballina
Bunree Industrial Estate
Ballina
County Mayo
Ireland

Product specificaties

Merk: Oasis
Categorie: Ontvochtiger
Model: D270LXA

Heb je hulp nodig?

Als je hulp nodig hebt met Oasis D270LXA stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Ontvochtiger Oasis

Oasis

Oasis D270LXA Handleiding

2 Juni 2024

Handleiding Ontvochtiger

Nieuwste handleidingen voor Ontvochtiger

Heinner

Heinner HFD-K380SSBK Handleiding

13 December 2024
Heinner

Heinner HFD-K400SS Handleiding

13 December 2024
Heinner

Heinner HFD-KD600SS Handleiding

13 December 2024
Midea

Midea MAD35S1AWWT Handleiding

4 December 2024
Midea

Midea MAD50PS1AWBL Handleiding

4 December 2024
Midea

Midea MAD50PS1AWT-C Handleiding

4 December 2024
Midea

Midea MAD22S1AWWT Handleiding

4 December 2024
Gree

Gree GGL25AW Handleiding

4 December 2024
Einhell

Einhell LEF 30 Handleiding

4 December 2024
Gemini

Gemini GDW24W Handleiding

30 November 2024