Neumann LH 25 Handleiding

Neumann Monitor LH 25

Lees hieronder de 📖 handleiding in het Nederlandse voor Neumann LH 25 (5 pagina's) in de categorie Monitor. Deze handleiding was nuttig voor 56 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/5
georg neumann gmbh · ollenhauerstr. 98 · 13403 berlin · germany
tel +49 (0)30 / 41 77 24-0 · fax -50 · headoffice@neumann.com · www.neumann.com
LH 25
Mounting manual
Mounting Bracket | Haltebügel
Crochet de montage | Soporte de montaje
Important safety and mounting instructions
• Have the product mounted by a specialist.
• Due to his/her technical training, know-how and experience as well
as knowledge of relevant provisions, regulations and standards, the
specialist must be able to assess assigned tasks, recognize poten-
tial hazards and ensure appropriate safety measures. The following
safety and mounting instructions are addressed to this specialist.
•
Read and follow the safety and mounting instructions, keep these
instructions and always include them when passing the LH25 on
to third parties.
•
Also read and follow the installation instructions contained in the
operating manual of the mounted loudspeaker.
• When mounting, observe and follow the local, national and interna-
tional regulations and standards.
•
Do not install the LH25 in locations where it is exposed to externally
generated vibrations.
• Always use the original Neumann mounting hardware.
•
Only fasten the LH25 to loudspeakers and other accessories as
defined in the “Hardware Mounting Matrix”. The maximum permis-
sible load is 20 kg (44 lbs).
Download the PDF file “Hardware Mounting Matrix” from
www.neumann.com. Only combine the Neumann mounting
hardware as specified in the “Hardware Mounting Matrix”.
CAUTION
Danger of injury and material damage due to
dropping of the loudspeaker/mounting hardware!
The loudspeaker together with the mounting hardware can drop
down until mounting is complete.
XHave the loudspeaker held by a second specialist who is phy-
sically able to do so. The requirements mentioned earlier also
apply to this specialist.
XWhen mounting the loudspeaker, provide a sucient additional
protection against dropping.
CAUTION
Danger of injury and material damage due to
dropping of the loudspeaker/mounting hardware!
If you use other M8 bolts than the supplied ones ( or ) to fasten B C
the LH 25 to the loudspeaker, the loudspeaker together with the
mounting hardware can drop down.
XAlways use the two supplied M8 bolts or to fasten the LH 25 B C
to the loudspeaker.
• Remove the pre-mounted screws at the sides of the loudspeaker.
• Fasten the LH 25 to the loudspeaker ...
– from above if you want to mount the loudspeaker hanging (see
fig. 1).
– -from below if you want to mount the loudspeaker to a loud
speaker stand or on top of a subwoofer (see fig. 2).
• If necessary, attach other Neumann mounting hardware to the
LH25 (see the “Hardware Mounting Matrix”). Also read and follow
the safety and mounting instructions contained in the operating
manual of the selected mounting hardware.
• If dierent mounting positions are possible, choose mounting
points that minimize leverage when the loudspeaker is tilted. As
a rule, this means that the LH25 is centrally mounted to the other
Neumann mounting hardware.
• Only tilt the loudspeaker when it is properly fastened to the LH25
and to additional Neumann mounting hardware and when it is
secured (see below). The maximum inclination angle depends on
the chosen mounting point and on the direction of inclination (see
fig. 3).
• Tighten the M8 bolts B or C that hold the LH 25 onto the loud-
speaker until the loudspeaker holds its vertical angling position.
• If you mount the LH25 hanging o a horizontal surface or a light-
ing truss:
– The horizontal surface or lighting truss must be able to carry
the weight of all parts used plus the weight of the loudspeaker.
If necessary, you additionally have to consider leverages. Also
read and follow the safety and mounting instructions contained
in the operating manual of the lighting truss.
•
Use safety wires to additionally protect the loudspeaker and the
mounting hardware against tipping/dropping – both when mounted
to a loudspeaker stand and when hanging. The safety wires, rope
terminations and coupling links must comply in their dimensioning
and condition with the regulations and standards of the country in
which they are used and must reliably prevent tipping/dropping of
the attached loudspeaker and mounting hardware.
• Make sure that ...
– you use both M8 bolts B C or to fasten the LH 25 to the loud-
speaker;
–
the LH 25, the associated mounting hardware, the loudspeaker,
the lighting truss and/or the loudspeaker stand cannot tip over or
drop down, even if the power or audio cables are pulled;
–
you replace the safety wires and coupling links by new ones when
they have prevented tipping/dropping;
–
you check every 3 months if all screws are properly tightened
and if the LH25 and associated mounting hardware, additional
fastening elements, safety wires and coupling links, as well as the
loudspeaker are in proper condition.
In case of any damage or any deviation from the safety and mounting
instructions, immediately dismount the loudspeaker, the LH25 and
the additional mounting hardware used.
Delivery includes
A: 1 x LH25 mounting bracket
B: 2 x M8 x 25 bolts with hand tightening knob
C: 2 x M8 x 25 bolts with Allen key head
D: 2 x rubber washers
E: 2 x metal washers
Specifications
Weight 1.1 kg (2.4 lbs)
Dimensions 205 x 400 x 40 mm (H x W x D)
7 1/8" x 15 7/8" x 1 5/8" (H x W x D)
Max. load 20 kg (44 lbs)
Guarantee
For the current terms and conditions of the product guarantee
please visit www.neumann.com.
EN
* Sourced from 3rd parties
B
B
D
C
C
C
C
D
D
A
A
E
E
B
B
D
D
A
E
E
C
*
*
B
E
Example/Beispiel/
Exemple/Ejemplo:
LH 29
Example/Beispiel/
Exemple/Ejemplo:
LH 28
1
2

Product specificaties

Merk: Neumann
Categorie: Monitor
Model: LH 25

Heb je hulp nodig?

Als je hulp nodig hebt met Neumann LH 25 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Monitor Neumann

Neumann

Neumann KH 80 DSP Handleiding

26 April 2023
Neumann

Neumann KH 310 Handleiding

8 April 2023
Neumann

Neumann LH 65 Handleiding

8 April 2023
Neumann

Neumann KH 750 Handleiding

26 November 2022
Neumann

Neumann KH 150 AES67 Handleiding

19 November 2022
Neumann

Neumann LH 28 Handleiding

3 November 2022
Neumann

Neumann LH 25 Handleiding

13 Oktober 2022
Neumann

Neumann LH 45 Handleiding

8 Oktober 2022

Handleiding Monitor

Nieuwste handleidingen voor Monitor

HoverCam

HoverCam eGlass Station Handleiding

21 November 2024
Kramer

Kramer KT-208 Handleiding

21 November 2024
AOpen

AOpen 27XC1R P Handleiding

21 November 2024
Wohler

Wohler vMON-170-8K Handleiding

20 November 2024
Wohler

Wohler vMON-320-4K Handleiding

20 November 2024
Wohler

Wohler vMON-170-4K Handleiding

20 November 2024
Wohler

Wohler vMON-320-8K Handleiding

20 November 2024
AOpen

AOpen d-TILE DT22M-O Handleiding

20 November 2024
Hannspree

Hannspree HP240WJB Handleiding

20 November 2024
BlueBuilt

BlueBuilt BBFHM24100 Handleiding

20 November 2024