Netgear ANT2407 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Netgear ANT2407 (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
)NSTALLATION'UIDE
Extended wireless network coverage: 400~450 M. The actual indoor range will be
affected by the local environment.
Note: For optimal results in extending wireless range with antenna installations, consult a
qualified professional installer service for a site survey and proper installation. For a list of
devices approved by the FCC for use with the antenna, see the NETGEAR website at
http://tools.netgear.com/legal/fcc_antennas.html.
Warning: Keep the antenna 15 cm (6 in) away from
notebook computers and monitors.
400~450 M
To maximize coverage and performance, place the antenna within the line of sight of your
wireless devices. Minimize partitions and objects that block the line of sight if possible.
The antenna can be placed on a flat surface, wall mounted, or magnet mounted.
• If wall-mounting, place the antenna on an interior wall above cubicles (cubicles
generally include a metal foil). Ideal placement is 2 meters (6.5 feet) high.
• If the wireless access point, router, or gateway, is in an IT room, place the antenna
outside the room against a a wall and close to the ceiling.
The area close to, behind, or beside the antenna will be covered, because the dynamic
range of the WLAN transmitter/receiver and antenna is approximately 100 dB. Even
with 20 dB to 40 dB or attenuation, the signal strength is still strong and
communication is maintained.
• The antenna has magnets in the base, which can be used to mount it on metal cabinets,
white boards, or even the ceiling cross bars (the framework that holds the ceiling
panels up).
Omni-directional
antenna ANT2407
Approximate
coverage area
Magnet mounting
on a whiteboard
Turn off your wireless access point, and connect your ANT2407 antenna. Note that the
antenna has a RP SMA female reverse connector. If your wireless access point is new,
follow the access point installation instructions. If you are upgrading an existing access
point, turn it on again.
Wireless Device with 1 Antenna
Wireless Device with 2 Antennas: Replacing the Primary Antenna
Wireless Device with 2 Antennas: Replacing Both
Wireless access point
Wireless access point
Wireless access point
February, 2009
Regional Customer Support phone numbers:
This symbol was placed in accordance with the European Union Directive 2002/96 on the
Waste Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the
European Union, this product should be treated and recycled in accordance with the laws of
your jurisdiction implementing the WEEE Directive.
© 2009 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered
trademarks of NETGEAR, Inc. in the United States and/or other countries. Other brand and product names
are trademarks or registered trademarks of their respective holders. Information is subject to change
without notice.
All countries 1-888-638-4327 Germany 0180 590 59 59 Mexico 1800 123 1786
Argentina 0800 666 9838 Finland 020 7928590 Netherlands 020 568 2987
Australia 1300 361 254 France 0820 887 177 New Zealand 0800 174600
Austria 0820 555 644 Hong Kong 800 964 605 Norway 800 12 500
Belgium 078 15 06 73 Hungary 1 23 55 353 Poland 22 583 4381
Brazil 0800 761 0021 India 1800-425-4327 Russia 810-800-20931032
Bulgaria + 359 2 97 444 70 Italy 0238 591 018 Singapore 800 6011 369
Canada 1-888-NETGEAR Ireland 1800 453019 Slovakia 02 5010 2648
Chile 800 472001 Japan 0120-921-080 Spain 90 099 5462
China 800-830-3815 Korea 080-638-4327 Sweden 0770-93 00 33
Columbia 01800-700-2102 Lux (Deu) 0049 180 590 59 59 Switzerland 0848 000 195
Czech Republic 296 335 656 Lux (Fra) 0033 820 88 71 77 Thailand 1800 060 013
Denmark 80 702 666 Malaysia 1800 880 023 UK 0844 875 4000
US 1-888-NETGEAR
NETGEAR 7 dBi Omni-directional Antenna ANT2407 Specifications
Frequency range 2.4~2.5GHz
Impedance 50 Ohmns
Gain (excluding cable loss) 7 dBi@ 2.45GHz
Operating temperature –10 to 60° C (14 to 140° F)
Storage temperature –10 to 70° C (14 to 158° F)
Humidity 95% RH
Radome material ABS
HPBW/H-plane 360°
HPBW/E-plane 21.6°
Dimensions (l x w x h) 114 x 169 x 302 mm (4.5 x 6.7 x 12 in)
Weight 240 gf
Connector RP SMA Female Reverse
Warranty 2 year
Impedance 50 +/- 5 Ohms
Thank you for selecting NETGEAR products.
After installing your device, locate the serial number of your product and use it to register
your product at http://www.NETGEAR.com/register. Registration is required before you
can use our telephone support service. Registration via our website is strongly
recommended.
Go to http://kbserver.netgear.com for product updates and Web support.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves
the right to make changes to the products described in this document without notice. NETGEAR does not
assume any liability that may occur due to the use or application of the product(s) or circuit layout(s)
described herein.
Federal Communications commission (FCC) Compliance Notice:
Radio Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
To comply with FCC regulations, the ANT2407 should only be used with devices that have been FCC
approved for use with the NETGEAR ANT2407. Check the NETGEAR website at
http://tools.netgear.com/legal/fcc_antennas.html for an updated list of FCC approved devices.
Note: This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna; (2)
Increase the separation between the equipment and receiver; (3) Connect the equipment to an outlet or
circuit different from that to which the receiver is connected; (4) Consult the dealer or an experienced
radio/TV technician for help.
FCC and EU Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
To avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the
antenna must be less than 20 cm (8 inches) during normal operation.
This device should not be co-located with other transmitters.
For EU, use of any antenna requires careful planning and extra considerations to comply with EU
emissions and health standards and regulations. Antenna installation must comply with the maximum
level authorized by each country.


Product specificaties

Merk: Netgear
Categorie: Niet gecategoriseerd
Model: ANT2407

Heb je hulp nodig?

Als je hulp nodig hebt met Netgear ANT2407 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Netgear

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd