Nedis SCLU110GY Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Nedis SCLU110GY (57 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 226 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/57
SCLU110GY
2018-08-02
2
ENGLISH
Electronic luggage scale
Specifications
1. Room temperature display
2. Zero and tare
3. 0.44" (11.3 mm) LCD display
4. Low battery / overload indicator
5. Capacity: 50 kg / 110 lb
6. Graduation: 50g / 0.1 lb
7. Power: 1x 3V lithium cell (CR2032)
Key illustration
: Switch on/off (press for 2 seconds to switch the device off)
UNIT: Switch between weight and temperature measurements
Weighing
1. Strap the webbing belt through the luggage handle and
secure the hook of the belt onto the triangular ring.
2. Press to switch on the scale before lifting (ensure there
is no tension)
3. When the display shows zero, press UNIT to select the
weight unit.
4. To re-weigh: press Z/T to reset the display to zero.
5. Lift the scale gently. Make sure the scale is horizontal and
balanced. The scale starts weighing the luggage. Wait for
the weight reading to stop and stabilise. The display will
flash the accurate weight 3 times and then lock. The scale
will display the accurate weight for 2 minutes and will then
automatically switch off.
6. When the scale is unable to read the weight of your luggage,
press Z/T to reset the display to zero and try again. The
scale will automatically switch off after 1 minute of inactivity.
Power
The scale is powered by 1x 3 V (CR2032) lithium battery. When
you use the scale for the first time, open the battery case cover
3
on the right end of the scale and remove the battery isolation
sheet before use.
How to Replace the Battery
LCD will display “Lo” when the battery power is low. Replace the
battery as follows:
1. Hold the scale in one hand. Use the thumb and index finger
of your other hand to pull out the battery case from the slot.
2. Push corner A outwards to release the used battery.
3. To insert a new battery, slide one side of the battery beneath
the retainer notches B & C. Press against the other side of
the battery until it clips underneath corner A. Make sure the
battery is inserted according to the polarity instructions.
4. Insert the battery case back into the slot on the scale.
Room temperature
1. Press to switch on the device. Wait until the display
shows zero. Press UNIT to view temperature (in Celsius and
Fahrenheit). Press UNIT again to revert to the normal
weighing mode.
2. When converting to temperature display mode the display
will show: “----”. This means that the scale is testing the
Removable
battery
case / slot
hook
triangular ring
webbing belt notch C
luggage handle Battery case
notch B
notch A


Product specificaties

Merk: Nedis
Categorie: Niet gecategoriseerd
Model: SCLU110GY

Heb je hulp nodig?

Als je hulp nodig hebt met Nedis SCLU110GY stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Nedis

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd