Miller Air Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Miller Air (8 pagina's) in de categorie Statief. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
3001 SYSTEM AIR
3005 SYSTEM AIR C/F
Fluid Head + Tripod
rators
Manual
qto
wya
eus
rid
ENGLISH
Introducon
Thank you for purchasing the Miller System AIR. The Miller System AIR is a professional standard camera support product that
oers stability, accuracy and durability. The robust design and construcon of the full uid movement supported by precision ball
bearings and quality nishes for long lasng performance.
System AIR Operaons - Solo tripod setup
q Select rubber foot posion for either indoor or outdoor condions.
Indoor (hard surfaces): rotate anclockwise all rubber feet (check foot is fully down).
Outdoor: rotate clockwise all rubber feet fully to expose spike.
Adjust pan handle to posion required by loosen clamp and adjust to desired angle then ghten clamp.
w e Whilst holding tripod system and with leg angle in posion No. 1 loosen the 1st stage leg locks and adjust to desired
length and ghten. If more height is required loosen 2nd stage leg locks to desired length and ghten. When using leg angle
posion No. 2 only use 1st stage leg locks to adjust to desired height and for leg angle posion No. 3 keep tripod leg fully collapsed
for ultra low ground hugging heights.
AIR uid head Setup
r t To level uid head loosen ball level clamp nut and keep bubble inside bullseye of bubble level and ghten clamp nut.
y u i To mount the camera apply pan / lt locks and loosen slide lock screw and pull camera plate whilst pressing
grey release knob. Fix the camera plate to the camera using the appropriate screw, spare screws can be stored under the camera
plaorm. With camera and plate aached insert assembly into rear of camera plaorm unl release knob engages the camera
plate into the plaorm. Slide the camera posion over the lt axis of the uid head to approximate balanced locaon and ghten
slide lock screw.
o a With counterbalance selected in posion 1 release lt lock whilst holding pan handle and allow it to lt back or forward
to see if the camera is balanced. Loosen slide lock screw and slide camera and plate in the appropriate direcon for a beer
balanced posion then ghten slide lock screw and recheck camera balance again. If camera is balanced but sll falls backwards
and forwards the select posion 2 of counterbalance.
Maintenance
s Use spanner to adjust leg pivot tension.
Opons
d The oponal 2092 Accessory mounng block 1/4” can be xed to side of head by using 4 mm hex key. This 1/4” can then be
used for mounng accessory viewnders. Ball level stud (13 mm) can be removed so head can be mounted to 3/8” screw at base
applicaons.
Storage and transport
Loosen pan / lt locks also pan handle and clamp and adjust to side posion. Whilst holding tripod system loosen leg locks and
adjust 1st and 2nd stages to full collapsed posion and e legs together using transport strap and snap buckle.
Oponal Accessories
2092 Accessory mounng block 1/4”
682 Pan handle & clamp (2nd)
1520 Solo shoulder strap
394 Solo Dolly
EN


Product specificaties

Merk: Miller
Categorie: Statief
Model: Air

Heb je hulp nodig?

Als je hulp nodig hebt met Miller Air stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Statief Miller

Handleiding Statief

Nieuwste handleidingen voor Statief